The effect of negative capacitance (NC), which can internally boost the voltage applied to a transistor, has been considered to overcome the fundamental Boltzmann limit of a transistor. To stabilize the NC effect, the dielectric (DE) must be integrated into a heterostructure with a ferroelectric (FE) film. However, in a multidomain hafnia, the charge boosting effect is reduced owing to a lowering of the depolarization field originating from the stray field at each domain, and simultaneously, the operating voltage increases owing to the voltage division at the DE. Here, we demonstrate core approaches to the gate stack of energy-efficient device technology using a transient NC. Electrical measurements of the transistor with imprinted antiferroelectric and high / structures exhibit low subthreshold slopes below 20 mV/dec, a low voltage operation of 0.5 V, a fast operation of 20 ns, hysteresis-free -, and high endurance characteristics of 10 cycles. We expect that this will lead to the rapid implementation of the NC effect in high-speed switching device applications with significantly improved energy efficiency.

Download full-text PDF

Source
http://dx.doi.org/10.1021/acsami.2c10610DOI Listing

Publication Analysis

Top Keywords

transistor imprinted
8
imprinted antiferroelectric
8
steep-slope transistor
4
antiferroelectric film
4
film negative
4
negative capacitance
4
capacitance internally
4
internally boost
4
voltage
4
boost voltage
4

Similar Publications

Sensing with Molecularly Imprinted Membranes on Two-Dimensional Solid-Supported Substrates.

Sensors (Basel)

August 2024

School of Materials Science and Engineering, Tsinghua University, No. 1 Tsinghua Yuan, Haidian District, Beijing 100084, China.

Molecularly imprinted membranes (MIMs) have been a focal research interest since 1990, representing a breakthrough in the integration of target molecules into membrane structures for cutting-edge sensing applications. This paper traces the developmental history of MIMs, elucidating the diverse methodologies employed in their preparation and characterization on two-dimensional solid-supported substrates. We then explore the principles and diverse applications of MIMs, particularly in the context of emerging technologies encompassing electrochemistry, surface-enhanced Raman scattering (SERS), surface plasmon resonance (SPR), and the quartz crystal microbalance (QCM).

View Article and Find Full Text PDF

Integrated mental stress smartwatch based on sweat cortisol and HRV sensors.

Biosens Bioelectron

December 2024

Key Laboratory of Micro-systems and Micro-structures Manufacturing of Ministry of Education, Harbin Institute of Technology, Harbin, 150001, China; School of Chemistry and Chemical Engineering, Harbin Institute of Technology, Harbin, 150001, China; School of Materials Science and Engineering, Harbin Institute of Technology, Harbin, 150001, China. Electronic address:

Mental stress, a human's common emotion that is difficult to recognize and describe, can give rise to serious psychological disorders. Skin and sweat are easily accessible sources of biomarkers and bio-signals that contain information about mental stress. It is challenging for current wearable devices to monitor psychological stress in real-time with a non-invasive manner.

View Article and Find Full Text PDF

Human-serum-albumin (HSA)-templated molecularly imprinted polymer nanoparticles (nano-MIPs) were integrated with a solution-gated field-effect transistor-based biosensor. The real-time electrical analysis of nano-MIP-HSA binding showed a high affinity and specificity of nano-MIPs for HSA. Moreover, the binding behaviour was continuously visualised using a solution-gated complementary metal-oxide semiconductor array image biosensor.

View Article and Find Full Text PDF

Ultrathin molecularly imprinted polymer (MIP) films were deposited on the surfaces of ZnO nanorods (ZNRs) and nanosheets (ZNSs) by electropolymerization to afford extended-gate field-effect transistor sensors for detecting phenytoin (PHT) in plasma. Molecular imprinting efficiency was optimized by controlling the contents of functional monomers and the template in the precursor solution. PHT sensing was performed in plasma solutions with various concentrations by monitoring the drain current as a function of drain voltage under an applied gate voltage of 1.

View Article and Find Full Text PDF

Simple Isopropanol-Assisted Direct Soft Imprint Lithography for Residue-Free Microstructure Patterning.

ACS Appl Mater Interfaces

May 2024

Guangdong Basic Research Center of Excellence for Energy & Information Polymer Materials, State Key Laboratory of Luminescent Materials and Devices, South China University of Technology, Wushan Road 381, Guangzhou 510640, P. R. China.

A direct soft imprint lithography was proposed to realize the direct fabrication of residue-free, well-shaped functional patterns through a single step. This imprint method requires only a simply prepared isopropanol-treated polydimethylsiloxane (PDMS) stamp without any additional resists. Residue-free Ag patterns were successfully fabricated on different substrates by directly imprinting the Ag ink with the isopropanol-treated PDMS stamp.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!