Oily water caused in the process of industry leads to not only the waste of resources, but also environmental pollution. Membrane separation, as a facile and efficient separation technology, has attracted widespread attention in the field of oil/water separation. The development of membrane materials with high separation performance is one of the key elements to improve separation efficiency. In this work, a superhydrophobic membrane composited with a trifluoromethyl-containing covalent organic framework (COF) is prepared, which exhibits excellent performance on separations of oil/water mixtures and water-in-oil emulsions. For different composition of oil/water mixtures, the highest flux of oil is up to 32 000 L m h and oil/water separation efficiency is above 99%. Moreover, the high oil/water separation efficiency remains unchanged after successive cycles. This work provides a feasible scheme for the design of high-efficiency oil/water separation membranes.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1002/marc.202200641 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
High-Density Polyethylene Janus Fibrous Membrane with Enhanced Breathability and Moisture Permeability via PDA Assisted Hydrophilic Modification.
Macromol Rapid Commun
January 2025
State Key Laboratory for Modification of Chemical Fibers and Polymer Materials, College of Materials Science and Engineering, Donghua University, Shanghai, 201620, China.
Functional fibrous membranes with high mechanical properties are intensively developed for different application fields. In this study, to enhance moisture and air permeability without compromising mechanical strength, a facile float-surface modification strategy is employed to fabricate Janus fibrous membranes with distinct hydrophobicity/hydrophilicity using the high-density polyethylene (HDPE) fibrous membranes. By coating one side of the HDPE fibrous membranes with polydopamine (PDA) and a superhydrophilic polyelectrolyte, the obtained Janus HDPE fibrous membranes demonstrate an excellent water transmission rate (577.
View Article and Find Full Text PDFDetection and continuous monitoring of moisture content in transformer oil using fractal-based capacitive sensor.
Heliyon
December 2024
Africa New Energies, UK.
The contaminated transformer oil is one of the major causes of failure in the power system. Detection and continuous monitoring of moisture content in transformer oil is required for the smooth operation of a system. In this paper, a Fractal-based Sinusoidal-shaped Capacitive Sensor (FSCS) is proposed to increase the contact area between capacitor plates and dielectric medium by 17.
View Article and Find Full Text PDFSustainable superhydrophobic lignin-based polyurethane foam: an innovative solution for oil pollutant adsorption.
RSC Adv
January 2025
College of Agricultural Engineering and Food Science, Shandong University of Technology Zibo 255000 China
Green, efficient treatment of crude oil spills and oil pollutants is a global challenge, with adsorption technology favored for its efficiency and low environmental impact. The development of an environmentally friendly adsorbent with high hydrophobicity, excellent adsorption performance, and degradability is crucial to overcoming the limitations of petroleum-based adsorbents. Here, a lignin-based polyurethane foam (LPUF) with superhydrophobic and photothermal oil-absorbing properties was fabricated by incorporating octadecyltrimethoxysilane into the foam system.
View Article and Find Full Text PDFSuper hydrophilic and super oleophobic carbon nanotube/TiO composite membranes for efficient separation of algal-derived oil/water emulsions.
Colloids Surf B Biointerfaces
December 2024
Department of Chemical Technologies, Iranian Research Organization for Science and Technology (IROST), Tehran, Iran.
The separation of oil from microalgae aqueous emulsions is a critical step in producing algal-derived biofuels and nutraceuticals. This study presents the development of super hydrophilic and super oleophobic composite membranes to efficiently separate algal oil from oil/water emulsions. Carbon nanotubes (CNTs) were functionalized with polydopamine (PDA), polyethylene glycol (PEG), and titanium dioxide (TiO) nanoparticles and coated onto a mixed cellulose ester (MCE) substrate to fabricate the composite membranes.
View Article and Find Full Text PDFSustainable nanomaterials: the role of Cyrene in optimising carbon nanotubes dispersion and filtration efficiency.
Front Chem
December 2024
Circa Renewable Chemistry Institute, Department of Chemistry, University of York, York, United Kingdom.
This study focuses on the fabrication and characterisation of single-walled carbon nanotube (SWCNT) buckypapers and polyethersulfone (PES) flat-sheet membranes using Cyrene, aiming toevaluate its efficacy as a green solvent for these applications. Pristine SWCNTs were dispersed inCyrene without surfactants and compared to N-Methyl-2-pyrrolidone (NMP) dispersions. Buckypapers were fabricated from these dispersions and characterised using Scanning ElectronMicroscopy (SEM), Atomic Force Microscopy (AFM), and infrared spectroscopy.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!