Biological-based treatment as the conventional treatment for palm oil mill effluent (POME) in open-ponding system face a well known rate-limiting step which is hydrolysis. In this study, electrochemical oxidation (EO) by a ruthenium oxide-coated titanium (Ti/RuO) electrode was introduced as a pre-treatment for POME waste activated sludge (WAS). Surface morphology and elemental analysis were investigated using field emission scanning electron microscopy and energy dispersive X-ray spectroscopy, respectively. Response surface methodology type central composite design was used in this study to understand the relationship between the independent and dependent variables. Analysis of variance (ANOVA) was used to validate the model of the studied variables. The correlation coefficients (R) indicated a close agreement between the experimental results and the predicted values, with high R values of 0.9044-0.9773. Multiple response optimization suggested that the range of current density (17-27 mA/cm) and electrolysis time (55-75 min) at a fixed concentration of sodium chloride (10 g/L), resulted in mixed liquor volatile suspended solids (MLVSS) removal >20%, capillary suction timer (CST) reduction >43%, extracellular polymeric substances (EPS) increment <19% and soluble chemical oxygen demand (sCOD) increment >25%. EO appears to be an efficient pre-treatment as well as practical way to improve the POME WAS disintegration and dewaterability.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.2166/wst.2022.255 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Electrosynthesis of Silane-Modified Magnetic Nanoparticles for Efficient Lead Ion Removal.
ChemSusChem
January 2025
Swinburne University of Technology - Hawthorn Campus: Swinburne University of Technology, Chemistry and Biotechnology, AUSTRALIA.
The removal of heavy metal ions, such as lead (Pb2+), from aqueous systems is critical due to their high toxicity and bioaccumulation in living organisms. This study presents a straightforward approach for the synthesis and surface modification of iron oxide nanoparticles (IONPs) for the magnetic removal of Pb2+ ions. IONPs were produced via electrosynthesis at varying voltages (10-40 V), with optimal magnetic properties achieved at 40 V resulting in highly crystalline and magnetic IONPs in the gamma-maghemite (γ-Fe2O3) phase.
View Article and Find Full Text PDFAntifouling ONOO electrochemical sensor based on copper-platinum bimetallic nanoparticle-modified N-doped biomass porous carbon fibres composites.
Talanta
January 2025
College of Chemistry and Bioengineering, Guilin University of Technology, Guilin, 541004, China.
Monitoring reactive nitrogen species (RNS) in complex biological media is essential for evaluating the health status of living organisms; however, biofouling on the sensor surface restricts its applications. To overcome this issue, we developed an antifouling electrochemical sensing platform using copper-platinum bimetallic nanoparticles/N-doped biomass porous carbon fibres (Cu-PtNPs/N-BCF) for directly detecting peroxynitrite anion (ONOO), a major type of RNS. Cyclic voltammetry measurements demonstrated that the Cu-PtNPs/N-BCF-2 nanocomposite, synthesised at a molar ratio of 1:1 between Co and Zn, exhibited exceptional electrocatalytic activity for ONOO oxidation.
View Article and Find Full Text PDFNano-interface enhanced electrochemical sensing of hazardous organochlorine pesticides and prospects with ZnO based nanomaterials.
Talanta
January 2025
Department of Electronics and Communication Engineering, Tezpur University, Tezpur, 784028, India. Electronic address:
Detection and analysis of organochlorine pesticides (OCP) residue is getting significant research importance because of their extensive use despite their hazardous effects on the health of people and the ecosystem. Despite the implementation of regulations and bans to safeguard human health and the environment, reports frequently reveal the continued use of these harmful chemicals in quantities exceeding the recommended limits set by regulatory boards. Data on the use of OCP from India, the most populous country, and African countries is not very encouraging.
View Article and Find Full Text PDFAdjusting the ratio of oxidation states in a CuO@Cu2O for the optimization of electrocatalytic CO2 conversion to ethylene.
ChemSusChem
January 2025
Dalian University of Technology, State Key Laboratory of Fine Chemicals, 2 Ligong Rd., 116024, Dalian, CHINA.
Understanding the impact of surface copper valence states on the distribution of electrochemical carbon dioxide products is critical. Herein, CuO@Cu2O with a Cu2+/Cu+ interface was fabricated using wet chemical etching approach. The hollow shape offered a large region for gas adsorption, while the interfacial mixed chemical state of Cu2+/Cu+ with tunable control ratio raised the local density of CHO* and accelerated the carbon-carbon coupling reaction.
View Article and Find Full Text PDFDefects Calculation and Accelerated Interfacial Charge Transfer in a Photoactive MOF-Based Heterojunction.
Small
January 2025
Institutes of Physical Science and Information Technology, Anhui Graphene Carbon Fiber Materials Research Center, Anhui University, Hefei, Anhui, 230601, P. R. China.
Photocatalytic hydrogen production is currently considered a clean and sustainable route to meet the energy and environmental issues. Among, heterojunction photocatalysts have been developed to improve their photocatalytic efficiency. Defect engineering of heterojunction photocatalysts is attractive due to it can perform as electron trap and change the band structure to optimize the interfacial separation rate of photogenerated electron-hole pairs.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!