The discovery of more efficient and stable catalysts for oxygen evolution reaction (OER) is vital in improving the efficiency of renewable energy generation devices. Given the large numbers of possible binary and ternary metal oxide OER catalysts, high-throughput methods are necessary to accelerate the rate of discovery. Herein, Mn-based spinel oxide, Fe Co Mn O, is identified for the first time using high-throughput methods demonstrating remarkable catalytic activity (overpotential of 310 mV on fluorine-doped tin oxide (FTO) substrate and 237 mV on Ni foam at 10 mA cm ). Using a combination of soft X-ray absorption spectroscopy and electrochemical measurements, the high catalytic activity is attributed to 1) the formation of multiple active sites in different geometric sites, tetrahedral and octahedral sites; and 2) the formation of active oxyhydroxide phase due to the strong interaction of Co and Fe . Structural and surface characterizations after OER show preservation of Fe Co Mn O surface structure highlighting its durability against irreversible redox damage on the catalytic surface. This work demonstrates the use of a high-throughput approach for the rapid identification of a new catalyst, provides a deeper understanding of catalyst design, and addresses the urgent need for a better and stable catalyst to target greener fuel.

Download full-text PDF

Source
http://dx.doi.org/10.1002/smll.202204520DOI Listing

Publication Analysis

Top Keywords

mn-based spinel
8
spinel oxide
8
multiple active
8
active sites
8
oxygen evolution
8
evolution reaction
8
high-throughput methods
8
catalytic activity
8
efficient ternary
4
ternary mn-based
4

Similar Publications

Conductive MOF-Derived Coating for Suppressing the Mn Dissolution in LiMnO toward Long-Life Lithium-Ion Batteries.

Nano Lett

January 2025

Department of Chemical Engineering and Materials Science, and Graduate Program in System Health Science and Engineering, Ewha Womans University, Seoul 03760, Republic of Korea.

Spinel lithium manganese oxide (LiMnO, LMO) is a promising cathode material with nontoxicity, high operating voltage, and low cost. However, structural collapse during battery cycling ─ caused by Mn dissolution and the Jahn-Teller effect ─ is a critical disadvantage, reducing cycle retention, particularly at high temperatures. In this study, to solve these critical issues, we introduce Cu(HITP) (CuHITP; HITP = 2,3,6,7,10,11-hexaiminotriphenylene), a conductive two-dimensional (2D) metal-organic framework (MOF) as a surface coating material.

View Article and Find Full Text PDF

The Doping of Al at the Tetrahedral Site of Spinel MnO for Electrocatalytic Water Oxidation.

Chemistry

December 2024

Key Laboratory of Applied Surface and Colloid Chemistry, Ministry of Education, School of Chemistry and Chemical Engineering, Shaanxi Normal University, Xi'an, 710119, China.

Spinel oxides have attracted much attention for electrocatalytic water oxidation. Specially, the Mn-based spinel structures merits fundamental investigation, as Mn is involved in water oxidation in natural photosynthesis. Herein, Al-doped MnO spinel electrocatalyst was prepared for water oxidation.

View Article and Find Full Text PDF

MnCoO spinel activates peroxymonosulfate for highly effective bisphenol A degradation with ultralow catalyst and persulfate usage.

J Hazard Mater

December 2024

Shanghai Organic Solid Wastes Biotransformation Engineering Technical Research Center, Shanghai Key Lab for Urban Ecological Processes and Eco-Restoration, School of Ecological and Environmental Sciences, East China Normal University, Shanghai 200241, China. Electronic address:

Persulfates-based advanced oxidation processes are highly efficient in degrading refractory organic contaminants in wastewater. However, their practical application is often limited by the extensive consumption of catalysts and oxidants. Therefore, constructing catalysts with abundant and efficient reaction interfaces is essential for improving the efficiency of persulfate activation.

View Article and Find Full Text PDF

Simultaneous Regulating the Surface, Interface, and Bulk via Phosphating Modification for High-Performance Li-Rich Layered Oxides Cathodes.

Adv Mater

December 2024

Hefei National Research Center for Physical Sciences at the Microscale, National Synchrotron Radiation Laboratory, Department of Materials Science and Engineering, CAS Key Laboratory of Materials for Energy Conversion, University of Science and Technology of China. Hefei, Anhui, 230026, China.

Li-rich Mn-based layered oxides (LRMOs) are regarded as the leading cathode materials to overcome the bottleneck of higher energy density. Nevertheless, they encounter significant challenges, including voltage decay, poor cycle stability, and inferior rate performance, primarily due to irreversible oxygen release, transition metal dissolution, and sluggish transport kinetics. Moreover, traditionally single modification strategies do not adequately address these issues.

View Article and Find Full Text PDF

Li-excess Mn-based disordered rock salt oxides (DRX) are promising Li-ion cathode materials owing to their cost-effectiveness and high theoretical capacities. It has recently been shown that Mn-rich DRX LiMnMO ( ≥ 0.5, M are hypervalent ions such as Ti and Nb) exhibit a gradual capacity increase during the first few charge-discharge cycles, which coincides with the emergence of spinel-like domains within the long-range DRX structure coined as "δ phase".

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!