Purpose: This study aimed to assess the efficacy of three techniques for preventing dental erosion and thereby identify effective methods. The three techniques were: 1) adding calcium to fermented milk (2% Ca and 0.5% Ca); 2) topical application of fluoride to the teeth before exposure to fermented milk (acidulated phosphate fluoride [APF] gel and 0.05% NaF); and 3) a combination of the two techniques (APF gel + 0.5% Ca, 0.05% NaF + 0.5% Ca).

Materials And Methods: pH cycling was performed on bovine-tooth specimens alternately immersed in experimental solutions and artificial saliva. After treatment, the microhardness and roughness of the enamel surfaces were measured, and changes in the surface morphology were observed using atomic force microscope images.

Results: Microhardness did not differ statistically significantly between the 2% Ca and mineral water (negative control) groups (2% Ca: 295.34 ± 11.50; mineral water group: 294.76 ± 10.67; p > 0.05). Surface roughness did not differ statistically significantly between the 2% Ca, 0.05% NaF + 0.5% Ca, and mineral water groups (2% Ca: 16.81 ± 7.23; 0.05% NaF + 0.5% Ca: 15.77 ± 2.86; mineral water group: 13.35 ± 5.53; p > 0.05). The surface morphology did not change in the mineral water and 2% Ca groups.

Conclusion: Considering that 2% calcium is a high concentration, adding a low concentration of calcium to fermented milk and applying a low concentration of fluoride daily decreased the reduction of surface microhardness and reduced the increase in surface roughness without causing marked changes in surface morphology. This confirms that combining the two techniques is an effective strategy to prevent dental erosion in-vitro.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC11640634PMC
http://dx.doi.org/10.3290/j.ohpd.b3556031DOI Listing

Publication Analysis

Top Keywords

mineral water
20
fermented milk
16
005% naf
16
dental erosion
12
naf 05%
12
surface morphology
12
three techniques
8
calcium fermented
8
changes surface
8
differ statistically
8

Similar Publications

The aim of this work was to determine the nutritional value and antioxidant potential of the pulp and seeds of the fruit of grown and consumed in the Eastern Region of Cameroon. The physicochemical and nutritional analyses of the pulp and seeds showed that the water content ranged from 89.33 to 95.

View Article and Find Full Text PDF

In this study, kaolinite-poly(urea-formaldehyde) was successfully prepared through the polymerization of urea intercalated within the kaolinite structure. Polymerization was carried out under ambient conditions by immersing kaolinite-urea in formaldehyde. Evidence of urea intercalation and polymerization was obtained from FTIR, XRD, and thermal analysis (TG-DSC).

View Article and Find Full Text PDF

Sport participation affects body composition and bone health, but the association between sport, body composition, and bone health in female athletes is complex. We compared areal bone mineral density (aBMD, DXA) and tibial volumetric bone mineral density (vBMD), geometry, microarchitecture, and estimated strength (HR-pQCT) in cross-country runners (n = 22), gymnasts (n = 23) and lacrosse players (n = 35), and investigated associations of total body lean mass (TBLM), team, and their interaction with tibial bone outcomes. Total body (TB), total hip (TH), femoral neck (FN), and lumbar spine (LS) aBMD were higher in gymnasts than runners (p < 0.

View Article and Find Full Text PDF

Evaporation or freezing of water-rich fluids with dilute concentrations of dissolved salts can produce brines, as observed in closed basins on Earth and detected by remote sensing on icy bodies in the outer Solar System. The mineralogical evolution of these brines is well understood in regard to terrestrial environments, but poorly constrained for extraterrestrial systems owing to a lack of direct sampling. Here we report the occurrence of salt minerals in samples of the asteroid (101955) Bennu returned by the OSIRIS-REx mission.

View Article and Find Full Text PDF

Exploring wood-derived biochar potential for electrochemical sensing of fungicides mancozeb and maneb in environmental water samples.

Talanta

January 2025

Department of Chemistry, Biochemistry and Environmental Protection, Faculty of Sciences, University of Novi Sad, Trg D. Obradovića 3, 21000, Novi Sad, Serbia.

The sustainable material, biochar (BC) from a hardwood source, was synthesized via pyrolysis process at 400 °C (BC400) and 700 °C (BC700) and used as a modifier during the electrochemical sensor design. The prepared BCs were characterized by scanning electron microscopy (SEM), Brunauer-Emmett-Teller (BET) analysis, and elemental analysis (CHNS). The development of rapid analytical techniques for detecting pesticides employing a low-cost carbon paste electrode (CPE) modified with BC is a novel strategy to provide a sensitive response to water pollution.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!