Brillouin dynamic gratings (BDG) can measure the distributed birefringence of polarization-maintaining fibers (PMF), however, its sensing range is limited by both stimulated Brillouin scattering depletion and fiber losses in PMF, which are significantly higher than those in standard single-mode fibers. In this work, we theoretically and experimentally verify that BDG can be sustained over ultra-long distances when assisted by distributed Brillouin amplification, significantly extending the distributed birefringence measurement distance. Using an optical frequency comb pumped by a narrow linewidth laser to both generate and interrogate the amplified BDG, a birefringence measurement accuracy of 7.5 × 10 was achieved over 7 km sensing length, more than double the longest range reported. This opens a new opportunity to investigate small birefringence changes due to nonlinear optics effects and monitoring fiber network security from eavesdropping.

Download full-text PDF

Source
http://dx.doi.org/10.1364/OE.466212DOI Listing

Publication Analysis

Top Keywords

distributed birefringence
12
optical frequency
8
frequency comb
8
distributed brillouin
8
birefringence measurement
8
distributed
5
birefringence sensing
4
sensing accuracy
4
accuracy ultra-long
4
ultra-long pmf
4

Similar Publications

Liquid crystals (LC) are widely used in various optical devices due to their birefringence, dielectric anisotropy, and responsive behavior to external fields. Enhancing the properties of existing LCs through doping with nanoparticles, including semiconductor quantum dots, offers a promising route for improving their performance. Among various nanoparticles, QDs stand out for their high charge mobility, sensitivity in the near-infrared spectral region, and cost-effectiveness.

View Article and Find Full Text PDF

Can Low Structural Anisotropy Produce High Optical Anisotropy? Anomalous Giant Optical Birefringent Effect in PIAlI in Focus.

J Am Chem Soc

January 2025

Functional Crystals Lab, Key Laboratory of Functional Crystals and Laser Technology, Technical Institute of Physics and Chemistry, Chinese Academy of Sciences, Beijing 100190, China.

Tetrahedral halides with broad transparency and large second harmonic effects have the potential to serve as mid-infrared wide-bandgap materials with balanced nonlinear-optical (NLO) properties. However, their regular tetrahedral motifs tend to exhibit low optical birefringence (Δ < 0.03) due to limited structural anisotropy, which constrains their practical phase-matched capability.

View Article and Find Full Text PDF

The New Paradigm of Ligand Substitution-Driven Enhancement of Anisotropy from SO Units in Short-Wavelength Region.

ACS Cent Sci

December 2024

Research Center for Crystal Materials, State Key Laboratory of Functional Materials and Devices for Special Environmental Conditions, Xinjiang Key Laboratory of Functional Crystal Materials, Xinjiang Technical Institute of Physics and Chemistry, CAS, 40-1 South Beijing Road, Urumqi 830011, China.

For non-π-conjugated [SO] units, it is challenging to generate sufficient birefringence, owing to the high symmetry of the regular tetrahedron. Unlike the traditional trial-and-error approach, we propose a new paradigm for birefringence engineering to tune the optical properties based on [SO] units. Through the strategy of ligand substitution, we can predict its effect on the band gap and anisotropy.

View Article and Find Full Text PDF

Achilles tendon injuries, as a widely existing disease, have attracted a lot of research interest. Mueller matrix polarimetry, as a novel label-free quantitative imaging method, has been widely used in various applications of lesion identification and pathological diagnosis. However, focusing on the recovery process of Achilles tendon injuries, current optical imaging methods have not yet achieved the label-free precise identification and quantitative evaluation.

View Article and Find Full Text PDF

This paper reports a compact fiber optical electric field (E-field) sensor aiming for the precise detection of transient E-field distributions. Here, a reflective polarization-reciprocal optical path is proposed, which inherently mitigates the temperature-induced birefringence interference of the electro-optical crystal without the need for additional optical elements, thereby facilitating a reduced-size sensing probe. Furthermore, an adaptive particle swarm optimization (A-PSO) algorithm has been utilized for the first time to optimize the insulation structure of the optical E-field sensor, which significantly suppresses field distortion within the sensing region by 50%.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!