The focus of this work was on developing a green, low-cost, and efficient biosorbent based on the biological structure and properties of MT and applying it to the remediation of cationic dyes in dye wastewater. The adsorption performance and mechanism of MT on methylene blue (MB) and crystal violet (CV) were investigated by batch adsorption experiments. The results demonstrated that the highest adsorption values of MT for MB (411 mg/g) and CV (553 mg/g) were greatly higher than the reported values of other biosorbents. In addition, the adsorption behaviors of methylene blue (MB) and crystal violet (CV) by MT were spontaneous exothermic reactions and closely followed the pseudo-second-order (PSO) kinetics and Langmuir isotherm. Further, the depleted MT was regenerated using pyrolysis mode to convert depleted MT into MT-biochar (MBC). The maximum adsorption of Cu and Pb by MBC was up to 320 mg/g and 840 mg/g, respectively. In conclusion, this work presented a new option for the adsorption of cationic dyes in wastewater and a new perspective for the treatment of depleted biosorbents.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC9571076PMC
http://dx.doi.org/10.3390/molecules27196228DOI Listing

Publication Analysis

Top Keywords

cationic dyes
12
adsorption cationic
8
methylene blue
8
blue crystal
8
crystal violet
8
adsorption
7
porous structure-inspired
4
structure-inspired lignocellulosic
4
lignocellulosic biosorbent
4
biosorbent efficient
4

Similar Publications

Photocatalytic degradation of the azo dye orange II using NdVO/VO/BiVO under visible light is reported here, and this oxygen-rich defect three-phase heterojunction structure is constructed using a two-step cation exchange method. This heterojunction significantly enhances the separation and migration efficiency of photo-induced charges, while the accompanying oxygen defects effectively capture photogenerated electrons, thereby suppressing the recombination of electrons and holes. Experimental characterization and theoretical calculations demonstrate the efficient separation and transfer capabilities of photogenerated carriers and their excellent photocatalytic degradation performance.

View Article and Find Full Text PDF

A low chemical consumption cationization and salt-free dyeing process for cotton fabrics by reusing polyallylamine modification bath.

Int J Biol Macromol

January 2025

National Engineering Research Center for Dyeing and Finishing of Textile, Donghua University, Shanghai 201620, PR China; College of Chemistry and Chemical Engineering, Donghua University, Shanghai, PR China; National Manufacturing Innovation Center of Advanced Dyeing and Finishing Technology, Tai'an, Shandong 271000, PR China. Electronic address:

Cationic polymers have been used in the cationization of cotton fabrics for salt-free dyeing, but commonly used polymers are limited by their high molecular weight and low adsorption efficiency, leading to high dosage or complex modification conditions. In this study, polyallylamine with low molecular weight was found to be an efficient cationic agent for cotton modification and the modified fabrics can be salt-free dyed with different kinds of reactive dyes after the optimization of the modification process. Furthermore, the modification bath was reused by replenishing a small amount of cationic agent and adjusting the pH to the original level.

View Article and Find Full Text PDF

Preparation of a CNF porous membrane and synthesis of silver nanoparticles (AgNPs).

RSC Adv

January 2025

The Center for Chemical Biology, School of Fundamental Science and Technology, Graduate School of Science and Technology, Keio University 3-14-1 Hiyoshi, Kohoku-ku Yokohama 223-8522 Japan +81-45-566-1580 +81-45-566-1839.

We prepared a cellulose nanofiber (CNF)-based porous membrane with three dimensional cellular structures. CNF was concentrated a surfactant-induced assembly by mixing CNF with a cationic surfactant, domiphen bromide (DB). Furthermore, they were accumulated by centrifugation to obtain a CNF-DB sol.

View Article and Find Full Text PDF

Designing molecular receptors that bind anions in water is a significant challenge, and an even greater difficulty lies in using these receptors to remove anions from water without resorting to the hazardous liquid-liquid extraction approach. We here demonstrate an effective and synthetically simple strategy toward these goals by exploiting ion-pair assembly of macrocycles. Our anion binding ensemble consists of an octa-chloro tetra-urea macrocyclic anion receptor (ClTU), which forms water-dispersible aggregates, and a tetra-cationic fluorescent dye 5,10,15,20-tetrakis(1-methyl-4-pyridinio)porphyrin (TMPyP4), which provides Coulombic stabilization and fluorescence reporting of anion binding in an ion-pair assembly.

View Article and Find Full Text PDF

Luminescence Lifetime-Based Water Conductivity Sensing Using a Cationic Dextran-Supported Ru(II) Polypyridyl Complex.

Sensors (Basel)

December 2024

Chemical Optosensors & Applied Photochemistry Group (GSOLFA), Department of Organic Chemistry, Faculty of Chemistry, Complutense University of Madrid, 28040 Madrid, Spain.

Water conductivity sensing relies universally on electrical measurements, which are subject to corrosion of the electrodes and subsequent signal drift in prolonged in situ uses. Furthermore, they cannot provide contactless sensing or remote readout. To this end, a novel device for water conductivity monitoring has been developed by employing a microenvironment-sensitive ruthenium complex, [Ru(2,2'-bipyridine-4,4'-disulfonato)], embedded into a quaternary ammonium functionalized cross-linked polymer support.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!