MoFeB-based cermets have wide applications in fields of wear resistance, corrosion resistance and heat resistance due to their simple preparation process, low-cost raw materials, and prominent mechanical properties. Herein, MoFeB-based cermets with Mo ( = 43.5, 45.5, 47.5, 49.5, wt.%) were prepared by means of the vacuum liquid phase sintering technique. Investigations on the microstructure and mechanical properties of MoFeB-based cermets with Mo addition were performed. Experimental results show that, with Mo content increasing, the average particle size decreases gradually, revealing that the grain coarsening of MoFeB-based cermets is controlled by interface reaction. In addition, MoFeB grains gradually transform from an elongated shape to a nearly equiaxed shape. The improvement of MoFeB hard phase on the morphology is mainly due to the inhibition of solution-precipitation reaction by increasing Mo. Furthermore, the relative density of cermets decreases due to the reduced Fe content. When Mo content is 47.5 wt.%, a relatively small grain size of MoFeB is obtained (about 2.03 μm). Moreover, with the increase in Mo content, hardness and transverse rupture strength (TRS) of MoFeB-based cermets increase firstly and then decrease. Whereas, with increasing Mo content, the fracture toughness deteriorates gradually. When Mo content is 47.5 wt.%, the comprehensive mechanical properties of cermets are the best. The optimal raw material ratio for the preparation of MoFeB-based cermets in this study is determined to be 47.5 wt.% Mo-6.0 wt.% B-Fe.
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC9573301 | PMC |
http://dx.doi.org/10.3390/ma15196729 | DOI Listing |
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!