Pumpkin fruits are large in size and need to be cut into pieces for use. The quality and storage life of cuts rapidly deteriorated. Big size fruits can be converted to shelf stable product to minimize postharvest loss using solar driers. However, drying temperature and RH in long solar tunnel drier not uniform and may affects quality of dried products. Therefore this research work aimed to investigate the effects of pre-drying treatments and solar tunnel dryer zones on the functional properties, proximate composition, and bioactive components of pumpkin pulp powder. Three groups of pumpkin slices were pre-treated in 1% citric acid (20 min), 2% salt (20 min) solutions, and the other group blanched at 65 °C in 1% salt solution (2 min), untreated sample used as a control. Pre-treated samples then dried in three zones of tunnel solar drier (zone I, zone II and zone III). Treatment combinations were laid down in factorial RCBD replicated 3 times. Results showed that pulp powder from salt pre-treated slice and dried at zone III results in the highest values of shrinkage, rehydration ratio, water holding capacity, and bulk density. Moisture content decreased from zone I to III, and with salt blanching in range of 8.2 to 6.4%, no effect in crude fat content, slices pre-treated in 2% salt solution results is better crude protein and fiber contents in zones. Better retention of total polyphones, beta-carotene, ascorbic acid, with high DPPH scavenging activity and lowest IC values were observed for salt pre-treated sample but dried in zone II of the drier. In general relatively better functional properties, proximate composition and bioactive compounds of the powder can be preserved when slices pre-treated in 2% salt solution and dried in zone II of solar tunnel drier characterized by 54.9 ± 3.7 °C, RH value of 31.4 ± 3.4% and air velocity of 0.45 m/s.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC9529547PMC
http://dx.doi.org/10.1016/j.heliyon.2022.e10747DOI Listing

Publication Analysis

Top Keywords

solar tunnel
16
functional properties
12
properties proximate
12
proximate composition
12
composition bioactive
12
pulp powder
12
slices pre-treated
12
salt solution
12
zone iii
12
dried zone
12

Similar Publications

Based on the DCV-C system of fullerene acceptor organic solar cell active materials, the charge transfer process of D-A type molecular materials under the action of an external electric field () was explored. Within the range of electric field application, the excited state characteristics exhibit certain regular changes. Based on reducing the excitation energy, the excitation mode shows a trend of developing toward low excited states.

View Article and Find Full Text PDF

Interface Engineering and Modulation of Nickel Oxide for High Air-Stable p-Type Crystalline Silicon Solar Cells.

Small

January 2025

Anhui Soltrend New Energy Technology Co., Ltd, Lujiang County, Hefei, 230000, China.

Dopant-free passivating contact crystalline silicon solar cells hold the potential of higher efficiency and cost down. In the hole-transport terminal, one still faces the challenge of trade-off between efficiency and stability. In this work, a H-AlO/NiO/Ni stacked hole-transport layer is proposed, where the H-AlO standing for H-rich AlO film can effectively reduce the interfacial defects and the high work function Ni metal results in a low contact resistance of 47.

View Article and Find Full Text PDF

High Gain, Low Voltage Solar-Blind Deep UV Photodetector Based on GaO/(AlGa)O/GaN nBp Heterojunction.

Small

January 2025

Key Laboratory of UV Light Emitting Materials and Technology, Ministry of Education, Northeast Normal University, Changchun, 130024, China.

In this study an (AlGa)O barrier layer is inserted between β-GaO and GaN in a p-GaN/n-GaO diode photodetector, causing the dark current to decrease considerably, and device performance to improve significantly. The β-GaO/β-(AlGa)O/GaN n-type/Barrier/p-type photodetector achieves a photocurrent gain of 1246, responsivity of 237 A W, and specific detectivity of 5.23 × 10 cm Hz W under a bias of -20 V.

View Article and Find Full Text PDF

Optimizing the installation parameters of photovoltaic panels in a photovoltaic array to reduce dust accumulation, thereby enhancing their power generation, is a crucial research topic in the construction of solar power stations in desert regions. Utilizing a series of wind tunnel experiments on a photovoltaic array comprising four equally sized panels, this study assessed how variations in tilt angle, mounting height, spacing, and incoming flow direction influence both the accumulation mass of dust and the particle size distribution in a photovoltaic array. The results indicate that the dust accumulation on the first panel exponential growth with increasing tilt angle, incoming flow angles, and height, while subsequent panels displayed a trend of initial increase followed by a decrease, with a maximum increasing ratio achieved at specific installation configurations, the difference of dust mass on each panel can even be several times.

View Article and Find Full Text PDF

A variety of ZnCdS-based semiconductor nanoparticle heterostructures with extended exciton lifetimes were synthesized to enhance the efficacy of photocatalytic hydrogen production in water. Specifically, doped nanoparticles (NPs), as well as core/shell NPs with and without palladium and platinum co-catalysts, were solubilized into water using various methods to assess their efficacy for solar H fuel synthesis. The best results were obtained with low bandgap ZnCdS cores and ZnCdS/ZnS core/shell NPs with palladium co-catalysts.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!