Changes in solution turbidity and color during paracetamol removal in laboratory and pilot-scale semicontinuous ozonation reactors.

Injecting ozone by means of a venturi device causes an increase in the mass transfer coefficient with respect to gas dissolution through a microdiffuser. Moreover, it was observed that significant turbidity levels are not formed (<1 NTU) when using a microdiffuser, probably due to the relatively high stirring which avoids formation of intermolecular hydrogen bonds. On the contrary, employing a venturi injector led to the production of high turbidity levels in water (up to 20 NTU). This indicates that formation of supramolecular structures causing this turbidity requires the presence of certain facilitating species which are formed through ozone decomposition mechanisms. The maximum ozone transfer takes place when operating at pH 9.0, that is, when this value is close to the pK and employing a dose of R = 115 mol O/mol Pa. Under these conditions, the degradation of paracetamol generates color, which is attributed to the presence of condensation products from pyrogallol, catechol, resorcinol, acetamide, oxalic acid and 4-aminophenol. Once paracetamol is fully degraded and solution turns colorless, turbidity grows (>20 NTU). This is attributed to formation of high molecular weight structures from 4-aminophenol and oxamide. Operating with large ozone excess (R = 500 mol O/mol Pa), the maximum ozone transfer rate is achieved at pH = 12.0. Under these conditions, the pollutant is fully removed together with water aromaticity and oxalic acid (able to form linear structures through hydrogen bonding) is detected during color development. Then, turbidity is formed due to cyclic dimer formation from acetic acid.