Mobility disabilities are prominent in society with wide-ranging deficits, motivating modular, partial-assist, lower-limb exoskeletons for this heterogeneous population. This paper introduces the Modular Backdrivable Lower-limb Unloading Exoskeleton (M-BLUE), which implements high torque, low mechanical impedance actuators on commercial orthoses with sheet metal modifications to produce a variety of hip- and/or knee-assisting configurations. Benchtop system identification verifies the desirable backdrive properties of the actuator, and allows for torque prediction within ±0.4 Nm. An able-bodied human subject experiment demonstrates that three unilateral configurations of M-BLUE (hip only, knee only, and hip-knee) with a simple gravity compensation controller can reduce muscle EMG readings in a lifting and lowering task relative to the bare condition. Reductions in mean muscular effort and peak muscle activation were seen across the primary squat musculature (excluding biceps femoris), demonstrating the potential to reduce fatigue leading to poor lifting posture. These promising results motivate applications of M-BLUE to additional populations, and the expansion of M-BLUE to bilateral and ankle configurations.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC9427014PMC
http://dx.doi.org/10.1109/LRA.2022.3145580DOI Listing

Publication Analysis

Top Keywords

modular backdrivable
8
hip knee
8
enhancing voluntary
4
voluntary motion
4
motion modular
4
backdrivable powered
4
powered hip
4
knee orthoses
4
orthoses mobility
4
mobility disabilities
4

Similar Publications

Design and Validation of a Modular, Backdrivable Ankle Exoskeleton.

Proc IEEE RAS EMBS Int Conf Biomed Robot Biomechatron

September 2024

Department of Robotics, University of Michigan, Ann Arbor, MI 48109, USA.

Partial-assist ankle exoskeletons have been limited by inherent trade-offs between favorable characteristics including high torque capacity, high control bandwidth, back-drivability, compliance, and low mass. Emerging quasi-direct drive actuators have a rigid transmission with a low gear ratio, enabling inherent backdrivability and compliance with accurate torque and position control. Our existing modular, backdrivable exoskeleton system () uses quasi-direct drive actuators at the hip and/or knee to deliver high assistive torques alongside low dynamic backdrive torques, enabling natural interaction with users with remnant voluntary motion.

View Article and Find Full Text PDF
Article Synopsis
  • Various lower-limb exoskeletons can assist movement for both able-bodied individuals and those with mild to moderate gait disorders, but a universal control system for all activities doesn’t exist.
  • The paper introduces a new modular control framework that optimizes joint torques for any exoskeleton configuration in real-time during daily activities like walking, ascending stairs, or transitioning from sitting to standing.
  • The study tested this framework on eight able-bodied users with different joint setups, finding that unilateral configurations significantly reduced muscle activation during tasks, while bilateral setups showed minimal effects likely due to weight and design limitations.
View Article and Find Full Text PDF

Mobility disabilities are prominent in society with wide-ranging deficits, motivating modular, partial-assist, lower-limb exoskeletons for this heterogeneous population. This paper introduces the Modular Backdrivable Lower-limb Unloading Exoskeleton (M-BLUE), which implements high torque, low mechanical impedance actuators on commercial orthoses with sheet metal modifications to produce a variety of hip- and/or knee-assisting configurations. Benchtop system identification verifies the desirable backdrive properties of the actuator, and allows for torque prediction within ±0.

View Article and Find Full Text PDF

This paper presents the mechatronic design and experimental validation of a novel powered knee-ankle orthosis for testing torque-driven rehabilitation control strategies. The modular actuator of the orthosis is designed with a torque dense motor and a custom low-ratio transmission (24:1) to provide mechanical transparency to the user, allowing them to actively contribute to their joint kinematics during gait training. The 4.

View Article and Find Full Text PDF

Assistive acting movement therapy devices with pneumatic rotary-type soft actuators.

Biomed Tech (Berl)

December 2012

FWBI Research Company and Institute of Automation, University of Bremen, Otto-Hahn-Allee, 1, D-28359 Bremen, Germany.

Inherent compliance and assistive behavior are assumed to be essential properties for safe human-robot interaction. Rehabilitation robots demand the highest standards in this respect because the machine interacts directly with weak persons who are often sensitive to pain. Using novel soft fluidic actuators with rotary elastic chambers (REC actuators), compact, lightweight, and cost-effective therapeutic devices can be developed.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!