Influence of the palatal plane cant and skeletal patterns in the hard palate thickness?

Introduction: The aim of the present study was to evaluate the thickness of the hard palate at the different angles formed by the palatal plane and the Frankfort horizontal line using computed tomography in patients with different facial patterns for planning the installation of MARPE.

Materials And Methods: The measurements were analysed in the hard palate of 106 patients. Four regions were selected passing through the mesial face, tangent at the level of the cemento-enamel junction of the premolars and molars. The bone thickness was measured from the floor of the nasal cavity to the cortical bone of the hard palate, 02 measurements with a distance of 05 mm between them (2.5 mm on each side starting from the midsagittal line) and 2 more with a distance of 7 mm between measurements (3.5 mm on each side starting from the midsagittal line). The palatal plane cant was determined based on the palatal plane and the Frankfort horizontal plane. The sagittal skeletal pattern was determined based on the ANB angle and the vertical skeletal pattern based on the SN.Go.Gn angle.

Results: Palatal bone thickness was greater in males than in females. Regarding the sagittal skeletal pattern, patients with Class II were found to have a thinner hard palate than Class I and Class III patients. No difference in the vertical skeletal pattern was observed between groups. Regarding the palatal plane cant, bone thickness was greater in patients with clockwise rotation.

Conclusions: Careful planning should be considered in the case of female patients; patients with greater angles of the palatal plane cant and Class II patients have a smaller bone thickness.