Limited effect of thermal pruning on wild blueberry crop and its root-associated microbiota.

Front Plant Sci

Institut de Recherche en Biologie Vègétale, Département de sciences biologiques, Université de Montréal, Montréal, QC, Canada.

Published: August 2022

Thermal pruning was a common pruning method in the past but has progressively been replaced by mechanical pruning for economic reasons. Both practices are known to enhance and maintain high yields; however, thermal pruning was documented to have an additional sanitation effect by reducing weeds and fungal diseases outbreaks. Nevertheless, there is no clear consensus on the optimal fire intensity required to observe these outcomes. Furthermore, fire is known to alter the soil microbiome as it impacts the soil organic layer and chemistry. Thus far, no study has investigated into the effect of thermal pruning intensity on the wild blueberry microbiome in agricultural settings. This project aimed to document the effects of four gradual thermal pruning intensities on the wild blueberry performance, weeds, diseases, as well as the rhizosphere fungal and bacterial communities. A field trial was conducted using a block design where agronomic variables were documented throughout the 2-year growing period. MiSeq amplicon sequencing was used to determine the diversity as well as the structure of the bacterial and fungal communities. Overall, yield, fruit ripeness, and several other agronomical variables were not significantly impacted by the burning treatments. Soil phosphorus was the only parameter with a significant albeit temporary change (1 month after thermal pruning) for soil chemistry. Our results also showed that bacterial and fungal communities did not significantly change between burning treatments. The fungal community was dominated by ericoid mycorrhizal fungi, while the bacterial community was mainly composed of Acidobacteriales, Isosphaerales, Frankiales, and Rhizobiales. However, burning at high intensities temporarily reduced leaf spot disease in the season following thermal pruning. According to our study, thermal pruning has a limited short-term influence on the wild blueberry ecosystem but may have a potential impact on pests (notably infection), which should be explored in future studies to determine the burning frequency necessary to control this disease.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC9408806PMC
http://dx.doi.org/10.3389/fpls.2022.954935DOI Listing

Publication Analysis

Top Keywords

thermal pruning
32
wild blueberry
16
pruning
10
bacterial fungal
8
fungal communities
8
burning treatments
8
thermal
7
fungal
5
limited thermal
4
wild
4

Similar Publications

Visually Asymptomatic Leaf Loss in -Infected Blueberry Plants.

Pathogens

October 2024

Department of Plant Pathology, University of Georgia, Tifton, GA 31793, USA.

(Xf), a gram-negative bacterium, is a notorious, world-wide plant pathogen with an extended latent period that presents a challenge for early disease detection and control interventions. We used thermal imaging of tissue-cultured, experimentally Xf-infected blueberry plants to identify visually pre-symptomatic leaves and compared the minimum force required to dislodge symptomatic leaves from infected plants to leaves on uninfected (control) blueberry plants. For two different blueberry cultivars and one pathogenic isolate of , we found no statistical difference between the mean downward force for leaf dislodgement, regardless of symptom category, on Xf-infected blueberry plants.

View Article and Find Full Text PDF

A lightweight detection algorithm for tooth cracks in optical images.

Comput Biol Med

November 2024

School of Mechanical and Electrical Engineering, Guangzhou University, Guangzhou, 510006, China. Electronic address:

Objectives: Cracked tooth syndrome (CTS) is one of the major causes of tooth loss, presents the problem of early microcrack symptoms that are difficult to distinguish. This paper aims to investigate the practicality and feasibility of an improved object detection algorithm for automatically detecting cracks in dental optical images.

Methods: A total of 286 teeth were obtained from Sun Yat-sen University and Guangdong University of Technology, and simulated cracks were generated using thermal expansion and contraction.

View Article and Find Full Text PDF

As a central molecule in complement system (CS), complement (C) 3 is upregulated in the patients and animal models of Alzheimer's disease (AD). C3 will metabolize to iC3b and C3a. iC3b is responsible for clearing β-amyloid protein (Aβ).

View Article and Find Full Text PDF

In this work, forcefield flexibility parameters were constructed and validated for more than 100 metal-organic frameworks (MOFs). We used atom typing to identify bond types, angle types, and dihedral types associated with bond stretches, angle bends, dihedral torsions, and other flexibility interactions. Our work used Manz's angle-bending and dihedral-torsion model potentials.

View Article and Find Full Text PDF

Programmable self-assembly has seen an explosion in the diversity of synthetic crystalline materials, but developing strategies that target "self-limiting" assemblies has remained a challenge. Among these, self-closing structures, in which the local curvature defines the finite global size, are prone to polymorphism due to thermal bending fluctuations, a problem that worsens with increasing target size. Here, we show that assembly complexity can be used to eliminate this source of polymorphism in the assembly of tubules.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!