In-situ growth of robust superlubricated nano-skin on electrospun nanofibers for post-operative adhesion prevention.

Nat Commun

State Key Laboratory of Tribology, Department of Mechanical Engineering, Tsinghua University, 100084, Beijing, China.

Published: August 2022

It is a great challenge to achieve robustly bonded, fully covered, and nanoscaled coating on the surface of electrospun nanofibers. Herein, we develop a controllable, facile, and versatile strategy to in-situ grow superlubricated nano-skin (SLNS) on the single electrospun nanofiber. Specifically, zwitterionic polymer chains are generated from the nanofiber subsurface in an inside-out way, which consequently form a robust network interpenetrating with the polymeric chains of the nanofiber matrix. The nanofibers with SLNS are superlubricated with the coefficient of friction (COF) lower than 0.025, which is about 16-fold of reduction than the original nanofibers. The time-COF plot is very stable after 12, 000 cycles of friction test, and no abrasion is observed. Additionally, the developed nanofibrous membranes possess favorable tensile property and biocompatibility. Furthermore, the nanofibrous membranes with SLNS achieve prevention of post-operative adhesion, which is confirmed in both rat tendon adhesion model and abdominal adhesion model. Compared with clinically-used antiadhesive membranes such as Interceed and DK-film, our nanofibrous membranes are not only more effective but also have the advantage of lower production cost. Therefore, this study demonstrates a potential of the superlubricated nanofibrous membranes in-situ grown based on a SLNS strategy for achieving prevention of post-operative adhesion in clinics.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC9420117PMC
http://dx.doi.org/10.1038/s41467-022-32804-0DOI Listing

Publication Analysis

Top Keywords

nanofibrous membranes
16
post-operative adhesion
12
superlubricated nano-skin
8
electrospun nanofibers
8
prevention post-operative
8
adhesion model
8
adhesion
5
membranes
5
in-situ growth
4
growth robust
4

Similar Publications

Sterilization and Filter Performance of Nano- and Microfibrous Facemask Filters - Electrospinning and Restoration of Charges for Competitive Sustainable Alternatives.

Macromol Rapid Commun

December 2024

Empa, Swiss Federal Laboratories for Materials Science and Technology, Laboratory for Biomimetic Membranes and Textiles, St. Gallen, 9014, Switzerland.

Facemask materials have been under constant development to optimize filtration performance, wear comfort, and general resilience to chemical and mechanical stress. While single-use polypropylene meltblown membranes are the established go-to material for high-performing mask filters, they are neither sustainable nor particularly resistant to sterilization methods. Herein an in-depth analysis is provided of the sterilization efficiency, filtration efficiency, and breathing resistance of selected aerosol filters commonly implemented in facemasks, with a particular focus on the benefits of nanofibrous filters.

View Article and Find Full Text PDF

Versatile LaCoNiO Nanofiber Membrane for High Performance Oxygen Electrocatalysis over a Wide Temperature Range.

Small

December 2024

School of Materials Science and Engineering, State Key Laboratory of Material Processing and Die and Mold Technology, Huazhong University of Science and Technology, Wuhan, Hubei, 430074, P. R. China.

The oxygen reduction reaction (ORR) and oxygen evolution reaction (OER) are key processes in numerous oxygen-involved applications over a wide temperature range. Despite advances in nanofiber engineering to increase active site density and catalytic efficiency for ORR/OER, conventional electrode fabrication methods often compromise the integrity of nanofibrous structures. Herein, a robust strategy is presented for the fabrication of LaCoNiO (LCN) nanofibrous membranes using optimized electrospinning techniques.

View Article and Find Full Text PDF

Self-crystal electret poly(lactic acid) nanofibers for high-flow air purification and AI-assisted respiratory diagnosis.

J Hazard Mater

December 2024

School of Materials Science and Physics, China University of Mining and Technology, Xuzhou 221116, China; Jiangsu Engineering Research Center of Dust Control and Occupational Protection, Xuzhou 221008,  China; College of Polymer Science and Engineering, State Key Laboratory of Polymer Materials Engineering, Chengdu 610065, China. Electronic address:

Particulate matters (PMs), one of the major airborne pollutants, continue to seriously threaten human health and the environment. Here, a self-crystal-induced electret enhancement (SCIEE) strategy was developed to promote the in-situ electret effect and polarization properties of electrospun poly(L-lactic acid) (PLLA) nanofibers. The strategy specifically involved the elaborate pre-structuring of stereocomplex crystals (SCs) with uniform dimensions (∼300 nm), which were introduced into PLLA electrospinning solution as the electrets and physical cross-linking points of high density.

View Article and Find Full Text PDF

Self-cleaning micro/nano graded porous groove structure fiber membranes by coaxial spinning for purification of dye wastewater.

Environ Res

December 2024

State Key Lab of Oil and Gas Reservoir Geology and Exploitation, Southwest Petroleum University, Chengdu, 610500, PR China; College of Petroleum and Gas Engineering Southwest Petroleum University, Chengdu, 610500, PR China; Oil & Gas Field Applied Chemistry Key Laboratory of Sichuan Province, Chengdu, 610500, PR China. Electronic address:

Adjusting the structure of the membrane and improving its performance proved to be an effective technique for accomplishing efficient dye wastewater purification. Water erosion of polyvinylpyrrolidone (PVP) core in polyacrylonitrile (PAN) nanofiber membrane modified with UiO-66-NH was successfully achieved, in this study, using coaxial electrospinning, and ZIF-8 with excellent performance was further epitaxy-grown in situ. Two differently shaped and positively charged MOFs confer strong adsorption capacity (adsorption capacity >2042 mg/g) on cationic dyes.

View Article and Find Full Text PDF

Glucose-Activated Janus Wound Dressing for Enhanced Management of Infected and Exudative Diabetic Wounds.

ACS Appl Mater Interfaces

December 2024

Key Laboratory of Textile Science & Technology, Ministry of Education, Donghua University, Shanghai 201620, China.

Article Synopsis
  • Diabetic wounds present complex challenges due to factors like high glucose levels and infections, leading to increased demand for innovative wound dressings in biomedical engineering.
  • A new Janus wound dressing has been developed, combining a hydrophobic antimicrobial layer with a hydrophilic sponge, which helps manage wound exudate and enhances healing.
  • In lab tests, this dressing improved healing rates by 54% within three days and effectively reduced methicillin-resistant (MRSA) infections, highlighting its potential for treating chronic diabetic wounds.
View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!