This data article contains the location, energy consumption, renewable energy potential, techno-economics, and profitability of hybrid renewable energy systems (HRES) in 634 Philippine off-grid islands. The HRES under consideration consists of solar photovoltaics, wind turbines, lithium-ion batteries, and diesel generators. The islands were identified from Google Maps™, Bing Maps™, and the study of Meschede and Ocon et al. (2019) [1]. The peak loads of these islands were acquired from National Power Corporation - Small Power Utilities Group (NPC-SPUG), if available, or estimated from the island population otherwise. Hourly-resolution load profiles were synthesized using the normalized profiles reported by Bertheau and Blechinger (2018) [2]. Existing diesel generators in the islands were compiled from reports by NPC-SPUG, while monthly average global horizontal irradiance and wind speeds were taken from the Phil-LIDAR 2 database. Islands that are electrically interconnected were lumped into one microgrid, so the 634 islands were grouped into 616 microgrids. The HRES were optimized using Island System LCOE Algorithm (ISLA), our in-house energy systems modeling tool, which sized the energy components to minimize the net present cost. The component sizes and corresponding techno-economic metrics of the optimized HRES in each microgrid are included in the dataset. In addition, the net present value, internal rate of return, payback period, and subsidy requirements of the microgrid are reported at five different electricity rates. This data is valuable for researchers, policymakers, and stakeholders who are working to provide sustainable energy access to off-grid communities. A comprehensive analysis of the data can be found in our article "Techno-economic and Financial Analyses of Hybrid Renewable Energy System Microgrids in 634 Philippine Off-grid Islands: Policy Implications on Public Subsidies and Private Investments" [3].
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC9364085 | PMC |
http://dx.doi.org/10.1016/j.dib.2022.108485 | DOI Listing |
ACS Appl Mater Interfaces
January 2025
Center of Nanomaterials for Renewable Energy, State Key Laboratory of Electrical Insulation and Power Equipment, School of Electrical Engineering, Xi'an Jiaotong University, Xìan, Shaanxi 710049, China.
Prussian blue analogues (PBAs) show great promise as cathode candidates for aqueous zinc-ion batteries thanks to their high operating voltage, open-framework structure, and low cost. However, suffering from numerous vacancies and crystal water, the electrochemical performance of PBAs remains unsatisfactory, with limited capacity and poor cycle life. Here, a simple coprecipitation method is shown to synthesize well-crystallized cobalt hexacyanoferrate (CoHCF) with a small amount of water and high specific surface area.
View Article and Find Full Text PDFJ Acoust Soc Am
January 2025
Health Canada, Consumer and Clinical Radiation Protection Bureau, Non-Ionizing Radiation Health Sciences Division, Ottawa, Ontario K1A 1C1, Canada.
The World Health Organization Environmental Noise Guidelines provide source-based nighttime sound level (Lnight) recommendations. For non-aircraft sources, the recommended Lnight is where the absolute prevalence of high sleep disturbance (HSD) equals 3%. The Guideline Development Group did not provide an Lnight for wind turbines due to inadequate data.
View Article and Find Full Text PDFSmall
January 2025
Institute of Advanced Wear & Corrosion Resistant and Functional Materials, Jinan University, Guangzhou, 510632, P. R. China.
Electricity-powered C─C coupling of CO represents an attractive strategy for producing valuable commodity chemicals with renewable energy, but it is still challenging to gain high C selectivity at high current density. Here, a SnCu single-atom alloy (SAA) is reported with isolated Sn atom embedded into the Cu lattice, as efficient ectrocatalyst for CO reduction. The as prepared SnCu-SAA catalyst shows a maximal C Faradaic efficiency of 79.
View Article and Find Full Text PDFHeliyon
January 2025
School of Photovoltaic and Renewable Energy Engineering, University of New South Wales, Sydney, NSW, 2052, Australia.
India is anticipated to grow its total energy consumption and CO emissions by more than any other country over the next two decades. India will have to attract around $400 billion in financing to realize its 500 GW target of renewable energy by 2030. Given complex renewable energy sector risks, rapidly scaling-up risk-friendly private equity financing will be critical to achieve India's target.
View Article and Find Full Text PDFHeliyon
January 2025
Centre for Advanced Composite Materials (CACM) Universiti Teknologi Malaysia, 81310, Skudai, Johor Bahru, Johor, Malaysia.
Cellulose nanocrystals (CNCs) are a class of materials that have received significant attention in recent years due to their unique properties and potential applications. CNCs are extracted from plant fibers and possess high strength, stiffness, and biocompatibility, making them attractive materials for use in various fields such as biomedical engineering, renewable energy, and nanotechnology. This provides an in-depth discussion of the extraction, characterization, and promising applications of CNCs.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!