Titanium-based metal-organic framework MIL-125(Ti) was synthesized by the hydrothermal method of terephthalic acid and tetra butyl titanate in N-N,dimethylformamide, and methanol. MIL-125(Ti) was characterized by Fourier-transform infrared spectroscopy, X-ray diffraction, thermogravimetric analysis, nitrogen adsorption-desorption, energy-dispersive X-ray spectroscopy, zeta potential, scanning electron microscope, and transmission electron microscopy. The results showed MIL-125(Ti) could be used as a potential adsorbent for protein separation and purification due to the high specific surface area, high stability, and strong hydrophobicity. As a result, MIL-125(Ti) had adsorption selectivity for immunoglobulin G, which was due to the hydrogen bond between MIL-125(Ti) and protein. At pH 8.0, the maximum adsorption efficiency of 0.25 mg MIL-125(Ti) for 300 μL 100 μg/mL immunoglobulin G was 98.3%, and its maximum adsorption capacity was 232.56 mg/g. The elution efficiency of immunoglobulin G was 92.4% by 0.1% sodium dodecyl sulfate. sodium dodecyl sulfate-polyacrylamide gel electrophoresis result demonstrated the successful isolation of highly purified immunoglobulin G from the human serum. Therefore, a new method of separation and purification of immunoglobulin G in human serum using titanium-based metal-organic framework MIL-125(Ti) as a solid-phase adsorbent was established, which broadened the application scope of metal-organic frameworks.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1002/jssc.202200357 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Modulation of interface structure on titanium-based metal-organic frameworks heterojunctions for boosting photocatalytic carbon dioxide reduction.
J Colloid Interface Sci
January 2025
College of Materials Science and Engineering, Beijing University of Technology, Beijing 100124, China. Electronic address:
Rational regulation of interface structure in photocatalysts is a promising strategy to improve the photocatalytic performance of carbon dioxide (CO) reduction. However, it remains a challenge to modulate the interface structure of multi-component heterojunctions. Herein, a strategy integrating heterojunction with facet engineering is developed to modulate the interface structure of metal-organic frameworks (MOF)-based heterojunctions.
View Article and Find Full Text PDFAdvanced Solid Lubrication with COK-47: Mechanistic Insights on the Role of Water and Performance Evaluation.
Adv Sci (Weinh)
January 2025
Institute for Engineering Design and Product Development, Research Unit Tribology E307-05, TU Wien, Vienna, 1060, Austria.
Metal-organic framework (MOF) nanoparticles have attracted widespread attention as lubrication additives due to their tunable structures and surface effects. However, their solid lubrication properties have been rarely explored. This work introduces the positive role of moisture in solid lubrication in the case of a newly described Ti-based MOF (COK-47) powder.
View Article and Find Full Text PDFPhotocatalytic membranes based on Cu-NH-MIL-125(Ti) protected by poly(vinylidene fluoride) for high and stable hydrogen production.
Mater Horiz
December 2024
Department of Process Engineering and Chemical Technology, Faculty of Chemistry, Gdansk University of Technology, 80-233 Gdansk, Poland.
A porous, photocatalytically active, and water-stable composite membrane has been developed based on Cu-NH-MIL-125(Ti), a titanium-based metal-organic framework (MOF) and PVDF polymeric matrix. To tune the structural and functional properties of the PVDF/MOF composites, the loading degree of the MOF within the polymer was systematically varied. The most effective performance of the composite material was achieved with a 10% wt/wt loading of MOF into the PVDF matrix.
View Article and Find Full Text PDFPhotocatalytic degradation of methylene blue using a Cu-modified bimetallic titanium-based metal organic framework (MIL-125) photocatalyst with enhanced visible light activity.
Turk J Chem
April 2024
Department of Chemical Engineering, Faculty of Engineering and Architecture, İstanbul Beykent University, İstanbul, Turkiye.
Cu-modified TiO nanoparticles derived from MIL-125 were prepared by solvothermal method for the photocatalytic degradation of methylene blue under visible light illumination. For boosting the photocatalytic performance as well as the physicochemical properties of bare sample, 2 wt % Cu ions were integrated into the nodes of the MIL-125 framework. The results showed that incorporation of 2 wt % Cu ions into the MOF framework had significant effects on the crystallographic structure and morphological and optical properties of photocatalytic samples, as well as catalytic activity for the methylene blue degradation reaction.
View Article and Find Full Text PDFCatalytically Active Ti-Based Nanomaterials for Hydroxyl Radical Mediated Clinical X-Ray Enhancement.
Adv Sci (Weinh)
December 2024
Nanoparticle Systems Engineering Laboratory, Institute of Energy and Process Engineering (IEPE), Department of Mechanical and Process Engineering (D-MAVT), ETH Zurich, Sonneggstrasse 3, Zurich, 8092, Switzerland.
Nanoparticle radioenhancement offers a promising strategy for augmenting radiotherapy by locally increasing radiation damage to tumor tissue. While past research has predominantly focused on nanomaterials with high atomic numbers, such as Au and HfO, recent work has revealed that their radioenhancement efficacy decreases considerably when using clinically relevant megavoltage X-rays as opposed to the orthovoltage X-rays typically employed in research settings. Here, radiocatalytically active Ti-based nanomaterials for clinical X-ray therapy settings are designed.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!