Endothelial and smooth muscle cell dysfunction is an early event at the onset of atherosclerosis, a heterogeneous and multifactorial pathology of the vascular wall. Bone morphogenetic protein (BMP)-4, a mechanosensitive autocrine cytokine, and BMPR-1a, BMPR-1b, BMPR-2 specific receptors play a key role in atherosclerotic plaque formation and vascular calcification and BMP4 is regarded as a biomarker of endothelial cell activation. The study aimed to examine the BMP4 system expression by Real-Time PCR in Human Coronary Artery Endothelial (HCAECs) and Smooth Muscle Cells (HCASMCs) under different flow rates determining low or physiological shear stress in the presence/absence of medicated Bioresorbable Vascular Scaffold (BVS). The HCAEC and HCASMC were subjected to 1-10-20 dyne/cm shear stress in a laminar flow bioreactor system, with/without BVS+ Everolimus (600 nM). In HCAECs without BVS the BMP4 expression was similar at 1, 20 dyne/cm decreasing at 10 dyne/cm, while adding BVS+ Everolimus, it decreased both at 1, 10 compared to 20 dyne/cm. In HCASMCs without BVS + Everolimus, the BMP4 system mRNA expression was significantly reduced at 1, 10 dyne/cm compared to 20 dyne/cm, while in the presence of BVS+ Everolimus, higher BMP4 mRNA levels were observed at 10 compared to 1, 20 dyne/cm. In HCAECs and HCASMCs BMPRs were expressed in all experimental conditions except for BMPR-1a at 1 dyne/cm in HCAEC. Significant correlations were found between BMP4 and BMPRs. The more negligible on BMP4 expression due to low shear stress in HCAEC compared to HCASMC and its reduction in the presence of BVS+ Everolimus at low shear stress highlighted the protection of BMP4-mediated against endothelial dysfunction and neoatherogenesis.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1007/s00380-022-02140-w | DOI Listing |
J Contemp Dent Pract
September 2024
Department of Academic, Faculty of Dentistry, Universidad Nacional Federico Villarreal, Lima, Peru, ORCID: https://orcid.org/0000-0002-0594-5834.
Objective: To evaluate the shear strength of adhesives based on the type of solvent (ethanol and acetone), aged and light-cured using light-emitting diode (LED) units with different wavelengths. Polywave and monowave LED units were employed for this study.
Materials And Methods: Ninety bovine tooth samples were analyzed using OptiBond Universal adhesive (acetone) and single bond universal adhesive (ethanol).
J Contemp Dent Pract
September 2024
Department of Orthodontic, Faculty of Dentistry, Mansoura University, Mansoura, Egypt.
Aim: This study evaluates long-term shear bond strength (SBS) and enamel micro cracks (MCs) healing after using adhesive pre-coated brackets (APC).
Materials And Methods: A total of eighty extracted human premolar teeth were randomly divided into four experimental groups ( = 20 per group): Control group: Teeth underwent indentation but no bracket bonding; group II : Teeth were subjected to indentation without exposure to thermocycling; group III: Teeth experienced both indentation and thermocycling; group IV: No indentation was applied to the teeth; groups III and IV were further divided into two subgroups to simulate different clinical timelines: Subgroup A (n = 10): Teeth underwent 5,000 thermocycles, equivalent to six months of clinical use. Subgroup B (n = 10): Teeth were subjected to 10,000 thermocycles, representing 12 months of use.
Soft Matter
January 2025
Department of Chemical and Biomolecular Engineering, University of Illinois at Urbana-Champaign, Champaign, IL 61801, USA.
Linking the macroscopic flow properties and nanoscopic structure is a fundamental challenge to understanding, predicting, and designing disordered soft materials. Under small stresses, these materials are soft solids, while larger loads can lead to yielding and the acquisition of plastic strain, which adds complexity to the task. In this work, we connect the transient structure and rheological memory of a colloidal gel under cyclic shearing across a range of amplitudes a generalized memory function using rheo-X-ray photon correlation spectroscopy (rheo-XPCS).
View Article and Find Full Text PDFJ Biomech Eng
January 2025
Department of Mechanical Engineering Marshall University, Huntington, WV 25755, USA; Department of Biomedical Engineering Marshall University, Huntington, WV 25755, USA.
Cell-laden, scaffold-based tissue engineering methods have been successfully utilized for the treatment of bone fractures. In such methods, the rate of scaffold biodegradation, transport of nutrients, and removal of cell metabolic wastes are critical fluid-dynamics factors, affecting tissue regeneration. Therefore, there is a critical need to identify the underlying material transport mechanisms associated with stem cell-driven, scaffold-based bone tissue regeneration.
View Article and Find Full Text PDFJ Mater Chem B
January 2025
School of Materials Science and Engineering, University of New South Wales (UNSW Sydney), Sydney, NSW 2052, Australia.
Most synthetic hydrogels are formed through radical polymerization to yield a homogenous covalent meshwork. In contrast, natural hydrogels form through mechanisms involving both covalent assembly and supramolecular interactions. In this communication, we expand the capabilities of covalent poly(ethylene glycol) (PEG) networks through co-assembly of supramolecular peptide nanofibers.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!