Polymer materials containing C rings and CO become promising electrode materials for high-performance lithium ion batteries (LIBs). However, the poor electronic conductivity severely restricts its further application. Herein, we design and construct a pyromellitic dianhydride anhydride anthraquinone/reduced graphene oxides (PMAQ/rGO-40) composite as an anode material for LIBs. The PMAQ is uniformly wrapped by conductive rGO nanosheets. The PMAQ/rGO-40 electrode without additional conductive agents displays a discharge capacity of 253 mAh g over 3000 cycles under 2A g, which is higher than that of the PMAQ electrode with conductive agents. Meanwhile, a capacity of 196 mAh g is achieved under 5A g. The enhanced cycling performance and rate ability are attributed to the rGO conductive network, which promotes electronic transport capability. In addition, the lithium ion storage mechanism and kinetics in the PMAQ/rGO-40 are investigated. The excellent electrochemical performance shows the potential application of the PMAQ/rGO composite anode material for high performance LIBs.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1016/j.jcis.2022.06.090 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Continuous Polarizability-Based Separation of Lithium Iron Phosphate and Graphite Using a Dielectrophoretic Particle Separator.
Langmuir
January 2025
College of Chemistry and Chemical Engineering, Qingdao University, Qingdao 266071, China.
The recovery of valuable materials from spent lithium-ion batteries (LIBs) has experienced increasing demand in recent years. Current recycling technologies are typically energy-intensive and are often plagued by high operation costs, low processing efficiency, and environmental pollution concerns. In this study, an efficient and environmentally friendly dielectrophoresis (DEP)-based approach is proposed to separate the main components of "black mass" mixtures from LIBs, specifically lithium iron phosphate (LFP) and graphite, based on their polarizability differences.
View Article and Find Full Text PDFUsing High-Entropy Configuration Strategy to Design Spinel Lithium Manganate Cathodes with Remarkable Electrochemical Performance.
Small
January 2025
National and Local Joint Engineering Laboratory for Lithium-ion Batteries and Materials Preparation Technology, Key Laboratory of Advanced Battery Materials of Yunnan Province, Faculty of Metallurgical and Energy Engineering, Faculty of Materials Science and Engineering, Kunming University of Science and Technology, Kunming, 650093, China.
Owing to its abundant manganese source, high operating voltage, and good ionic diffusivity attributed to its 3D Li-ion diffusion channels. Spinel LiMnO is considered a promising low-cost positive electrode material in the context of reducing scarce elements such as cobalt and nickel from advanced lithium-ion batteries. However, the rapid capacity degradation and inadequate rate capabilities induced by the Jahn-Teller distortion and the manganese dissolution have limited the large-scale adoption of spinel LiMnO for decades.
View Article and Find Full Text PDFHighly Crystalline Contorted Coronene Homologous Molecule as Superior Organic Anode Material for Full-Cell Li-Ion Batteries.
ACS Nano
January 2025
Department of Energy Engineering, School of Energy and Chemical Engineering, Ulsan National Institute of Science and Technology (UNIST), Ulsan 44919, Republic of Korea.
Organic anode materials have garnered attention for use in rechargeable Li-ion batteries (LIBs) owing to their lightweight, cost-effectiveness, and tunable properties. However, challenges such as high electrolyte solubility and limited conductivity, restrict their use in full-cell LIBs. Here, we report the use of highly crystalline Cl-substituted contorted hexabenzocoronene (Cl-cHBC) as an efficient organic anode for full-cell LIBs.
View Article and Find Full Text PDFDelaying the volume-change of CaCoO/rGO as an anode for high-performance lithium-ion and sodium-ion batteries.
Dalton Trans
January 2025
School of Physics and Optoelectronics, South China University of Technology, Guangzhou 510640, P. R. China.
CaCoO/rGO was prepared by combining a sol-gel strategy and mechanical ball milling method. The Rietveld refinement results demonstrated a single-phase structure with a monoclinic symmetry. When utilized as an anode for lithium-ion batteries, it exhibited excellent rate performance and electrochemical stability due to the significantly decreasing particle size as well as the formation of a conductive rGO network in the composite after ball milling.
View Article and Find Full Text PDFIon-Induced Phase Changes in 2D MoTe Films for Neuromorphic Synaptic Device Applications.
ACS Nano
January 2025
Department of Materials Science and Engineering, University of North Texas, Denton, Texas 76207, United States.
Two-dimensional molybdenum ditelluride (2D MoTe) is an interesting material for artificial synapses due to its unique electronic properties and phase tunability in different polymorphs 2H/1T'. However, the growth of stable and large-scale 2D MoTe on a CMOS-compatible Si/SiO substrate remains challenging because of the high growth temperature and impurity-involved transfer process. We developed a large-scale MoTe film on a Si/SiO wafer by simple sputtering followed by lithium-ion intercalation and applied it to artificial synaptic devices.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!