Stabilizing Li-O Batteries with Multifunctional Fluorinated Graphene.

Nano Lett

State Key Laboratory of Physical Chemistry of Solid Surfaces, College of Chemistry and Chemical Engineering, Xiamen University, Xiamen 361005, P.R. China.

Published: June 2022

As a full cell system with attractive theoretical energy density, challenges faced by Li-O batteries (LOBs) are not only the deficient actual capacity and superoxide-derived parasitic reactions on the cathode side but also the stability of Li-metal anode. To solve simultaneously intrinsic issues, multifunctional fluorinated graphene (CF, = 1, F-Gr) was introduced into the ether-based electrolyte of LOBs. F-Gr can accelerate O transformation and O-participated oxygen reduction reaction (ORR) process, resulting in enhanced discharge capacity and restrained O-derived side reactions of LOBs, respectively. Moreover, F-Gr induced the F-rich and O-depleted solid electrolyte interphase (SEI) film formation, which have improved Li-metal stability. Therefore, energy storage capacity, efficiency, and cyclability of LOBs have been markedly enhanced. More importantly, the method developed in this work to disperse F-Gr into an ether-based electrolyte for improving LOBs' performances is convenient and significant from both scientific and engineering aspects.

Download full-text PDF

Source
http://dx.doi.org/10.1021/acs.nanolett.2c01713DOI Listing

Publication Analysis

Top Keywords

li-o batteries
8
multifunctional fluorinated
8
fluorinated graphene
8
ether-based electrolyte
8
lobs f-gr
8
stabilizing li-o
4
batteries multifunctional
4
graphene full
4
full cell
4
cell system
4

Similar Publications

Metal-air batteries are promising energy storage systems with high specific energy density and low dependence on critical materials. However, their development is hindered by slow kinetics, low roundtrip efficiency, deficient capacity recovery, and limited lifetime. This work explores the effect of cycling protocols on the lifetime of Li-O cells, and the interplay between electrolyte composition and the upper cut-off voltage during charge.

View Article and Find Full Text PDF

An amide-based gel polymer electrolyte for Li-O batteries: advancing towards practical Li-air batteries.

Chem Commun (Camb)

January 2025

School of Materials Science and Engineering, Institute of New Energy Material Chemistry, Key Laboratory of Advanced Energy Materials Chemistry (Ministry of Education), Renewable Energy Conversion and Storage Center (ReCast), Nankai University, Tianjin 300350, China.

This study introduces an amide-based gel polymer electrolyte (GPE) for Li-O batteries, optimizing monomer and plasticizer ratios to enhance electrochemical stability and cycling performance. The GPE addresses sluggish kinetics and anode corrosion, enabling operation under atmospheric conditions, and demonstrating significant durability for practical Li-air batteries.

View Article and Find Full Text PDF

Sn-carbon nanocomposite anode for all-solid-state chloride-ion batteries operating at room temperature.

Chem Commun (Camb)

January 2025

Department of Materials Science and Engineering, Pusan National University, 2 Busandaehak-ro 63beon-gil, Geumjeong-gu, Busan 46241, Republic of Korea.

All-solid-state chloride-ion batteries promise high theoretical energy density and room-temperature operation. However, conventional Sn anodes suffer from low material utilization attributed to large particle size and volume expansion. Here, nano-sized Sn particles in an N-doped carbon framework are used as an anode, resulting in ∼12% higher capacity compared to conventional Sn, due to improved Sn utilization and suppression of volume expansion.

View Article and Find Full Text PDF

Proposing lithium pump mechanism for observing Ag-Li two-phase interface reaction of in-situ Li-O battery by two-step method.

J Colloid Interface Sci

January 2025

Hebei Key Laboratory of Applied Chemistry, College of Environmental and Chemical Engineering, Yanshan University, Qinhuangdao 066004 China; Clean Nano Energy Center, State Key Laboratory of Metastable Materials Science and Technology, Yanshan University, Qinhuangdao 066004 China. Electronic address:

Article Synopsis
  • Silver (Ag) is a key catalyst in lithium-oxygen batteries, but its catalytic mechanism is not fully understood.
  • Researchers used Ag nanowires and advanced electron microscopy to study the reactions between Ag and lithium at their interface, revealing that lithiation creates AgLi and oxidation produces Ag nanoparticles.
  • The findings highlight a cyclic reaction process (Ag-AgLi-Ag) that explains lithium transport during discharge and contribute to improved understanding of complex interfacial reactions in these batteries.
View Article and Find Full Text PDF

The addition of a redox mediator as soluble catalyst into electrolyte can effectively overcome the bottlenecks of poor energy efficiency and limited cyclability for Li-O batteries caused by passivation of insulating discharge products and unfavorable byproducts. Herein we report a novel soluble catalyst of bifunctional imidazolyl iodide salt additive, 1,3-dimethylimidazolium iodide (DMII), to successfully construct highly efficient and durable Li-O batteries. The anion I can effectively promote the charge transport of LiO and accelerate the redox kinetics of oxygen reduction/oxygen evolution reactions on the cathode side, thereby significantly decreasing the charge/discharge overpotential.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!