Organized by the European Radiation Dosimetry Group (EURADOS), a Monte Carlo code intercomparison exercise was conducted where participants simulated the emitted electron spectra and energy deposition around a single gold nanoparticle (GNP) irradiated by X-rays. In the exercise, the participants scored energy imparted in concentric spherical shells around a spherical volume filled with gold or water as well as the spectral distribution of electrons leaving the GNP. Initially, only the ratio of energy deposition with and without GNP was to be reported. During the evaluation of the exercise, however, the data for energy deposition in the presence and absence of the GNP were also requested. A GNP size of 50 nm and 100 nm diameter was considered as well as two different X-ray spectra (50 kVp and 100kVp). This introduced a redundancy that can be used to cross-validate the internal consistency of the simulation results. In this work, evaluation of the reported results is presented in terms of integral quantities that can be benchmarked against values obtained from physical properties of the radiation spectra and materials involved. The impact of different interaction cross-section datasets and their implementation in the different Monte Carlo codes is also discussed.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC9165644PMC
http://dx.doi.org/10.1016/j.radmeas.2021.106637DOI Listing

Publication Analysis

Top Keywords

energy deposition
16
monte carlo
12
carlo code
8
code intercomparison
8
emitted electron
8
electron spectra
8
spectra energy
8
deposition single
8
single gold
8
gold nanoparticle
8

Similar Publications

Atomic layer deposition of Pt nanoparticles grown onto 3D B-doped graphene as an efficient ultra-low Pt loading catalyst layer for PEMFC.

J Colloid Interface Sci

December 2024

Collaborative Innovation Center of Sustainable Energy Materials, School of Physical Science and Technology, Guangxi University; Guangxi Key Laboratory of Electrochemical Energy Materials, State Key Laboratory of Featured Metal Materials and Life-cycle Safety for Composite Structures, Nanning 530004, China. Electronic address:

Proton exchange membrane fuel cell (PEMFC) with ultra-low Pt loading is highly desirable but confronts challenges of deficient activity and durability for practical application. Herein, we report a newly integrated catalyst layer based on 3D porous B-doped graphene (3D-PBG) with the atomic layer deposition of Pt (Pt/3D-PBG) for PEMFC, in which highly graphitized 3D-PBG not only provides a robust framework to support Pt but also B dopants further enhances the deposition of Pt and their electronic interaction, resulting in high-performance PEMFC at ultra-low Pt loading. The cell with Pt/3D-PBG at 80.

View Article and Find Full Text PDF

Water-assisted electrocatalytic oxidation of alcohols into valuable chemicals is a promising strategy to circumvent the sluggish kinetics of water oxidation, while also reducing cell voltage and improving energy efficiency. Recently, transition metal (TM)-based catalysts have been investigated for anodic alcohol oxidation, but success has been limited due to competition from the oxygen evolution reaction (OER) within the working regime. In this study, NiCo-based Prussian blue analog (PBA) was electrochemically activated at the anodic potential to produce a Co-Ni(O)OH active catalyst with a nanosheet-like architecture.

View Article and Find Full Text PDF

Development of a high-performance pseudocapacitive composite via electroless deposition of silver nanoparticles on micro-sized silicon.

Sci Rep

December 2024

Department of Theoretical Electrical Engineering and Diagnostics of Electrical Equipment, Institute of Electrodynamics, National Academy of Sciences of Ukraine, Beresteyskiy, 56, Kyiv-57, 03680, Ukraine.

An energy material has been developed using a one-step chemical reduction method, incorporating silver nanoparticles (AgNPs) that encapsulate micro-sized silicon (mSi) flakes. SEM investigation revealed complete encapsulation of silicon flakes by AgNP's dendritic structure, EDX confirmed the deposition of Ag on Si flakes. Raman spectroscopy confirmed the formation of silver and silicon oxides.

View Article and Find Full Text PDF

The present investigation provides an easy and affordable strategy for fabrication of functional ceramics BiNaTiO-SrFeO (BNT-SrF5) thick films on a flexible, inexpensive and electrically integrated substrate using electrophoretic deposition process (EPD). EPD is a widely accepted, environmentally friendly method for applying coatings from a colloidal suspension to conductive substrates. Lead-free ferroelectric BNT-SrF5 powder was synthesized by solid state method to fabricate bulk samples and thick films (30-160 μm) by EPD process.

View Article and Find Full Text PDF

Waste generated during asbestos manufacturing contains substantial quantities of iron, nickel, magnesium, and silicon. The existing techniques for processing chrysotile-asbestos waste (CAW) cannot fully recover these elements. Therefore this paper presents a hydrometallurgical method for processing the CAW of the Zhitikara deposit in the Kostanay region of Kazakhstan.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!