Promotion and mechanisms of Bdellovibrio sp. Y38 on membrane fouling alleviation in membrane bioreactor.

Environ Res

Department of Environmental Science and Engineering, School of Energy and Environment, Southeast University, Nanjing, Jiangsu, 210096, China; Key Laboratory of Environmental Medicine Engineering, Ministry of Education, Southeast University, Nanjing, Jiangsu, 210009, China. Electronic address:

Published: September 2022

Membrane fouling is a major bottleneck limiting the widespread application of membrane bioreactors (MBR). In this study, Bdellovibrio sp. Y38, an obligate bacteriophage bacterium of Bdellovibrio-and-like organisms (BALOs), was enriched into highly concentrated culture medium (10-10 PFU/mL), and daily dosed into the MBR to investigate its effects on membrane fouling mitigation. The strain Y38 prolonged the membrane fouling cycle from 73 days to 90 days, indicating its membrane fouling alleviation potentials. The concentration of BALOs was increased 625 times higher than the control group after the whole operation, resulting in the concentration of chemical oxygen demand and nucleic acids in the liquid phase of the MBR system being significantly increased by 169.8 ± 1.5% and 126.7 ± 2.2%, respectively. The biomass growth rate was reduced by 27.2 ± 0.7% from day 0 to day 54. These results indicated the predation potential of Bdellovibrio sp. Y38 on the microorganisms in the sludge. The improvement of homogenized sludge and filtration and settling performance by the strain Y38 alleviated the membrane fouling. Compared with the control group, the macromolecular proteins in SMP and EPS were partially declined, and the polysaccharide in EPS decreased by 14.0 ± 3.9%, and the ratios of protein content to polysaccharide content (PN/PS) in SMP and EPS significantly increased by 35.6 ± 16.8% and 57.8 ± 6.1% at the middle stage, respectively, indicating the strain Y38 could alleviate membrane fouling by reducing and modifying SMP and EPS. Furthermore, the relative abundance of γ-proteobacteria decreased from 13.2% to 5.1% at the pre-middle stage, and Planctomycetes decreased from 1.5% to 0.8% at the end-stage, which were probably responsible for the membrane fouling mitigation. In addition, the strain Y38 had few impacts on the water treatment performance of MBR. There findings provide a promising strategy for in situ membrane pollution mitigation via exogenous additions of BALOs.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.envres.2022.113593DOI Listing

Publication Analysis

Top Keywords

membrane fouling
32
strain y38
16
bdellovibrio y38
12
smp eps
12
membrane
11
fouling
8
fouling alleviation
8
fouling mitigation
8
control group
8
y38
7

Similar Publications

In the integrated circuit manufacturing process, reverse osmosis (RO) membranes are widely used for wastewater reclamation. However, fouling by typical surfactants significantly reduces membrane efficiency and lifespan. This study investigates the fouling mechanisms of typical surfactants-cetyl trimethyl ammonium bromide (CTAB, cationic), sodium dodecyl sulfate (SDS, anionic), and polyoxyethylene octyl phenyl ether (TX, nonionic)-on RO membranes.

View Article and Find Full Text PDF

The effectiveness and safety of hemodialysis can be hindered by protein accumulation, mechanical instability of membranes and bacterial infection during the dialytic therapy. Herein, we show that cellulose acetate membranes modified with the low-fouling polymers (namely polyvinylpyrrolidone and polyethylene glycol), followed by the in situ reduction of different densities of silver oxide(I) nanoparticles, can effectively address these limitations. These improvements comprise the enhanced resistance to the protein fouling, improved antimicrobial capabilities against S.

View Article and Find Full Text PDF

Microalgae-based membrane bioreactor for wastewater treatment, biogas production, and sustainable energy: a review.

Environ Res

January 2025

Department of Chemistry, Faculty of Mathematics and Natural Sciences, Universitas Padjadjaran, Jatinangor, West Java 45363, Indonesia; Research Collaboration Center for Biomass and Biorefinery between BRIN and Universitas Padjadjaran, Jatinangor, West Java 45363, Indonesia.

Managing wastewater and using renewable energy sources are challenges in achieving Sustainable Development Goals. This study provides an overview of the factors influencing the performance of algae-based membrane bioreactors (AMBRs) for contaminant removal from wastewater and biogas. This review highlights that the performance of AMBRs in removing total phosphorus (TP) and nitrogen (N) from wastewater can reach up to 93% and 97%, depending on parameters such as pH, hydraulic retention time (HRT), and algae concentration.

View Article and Find Full Text PDF

Leveraging almost hydrophobic PVDF membrane and in-situ ozonation in O/UF/BAC system for superior anti-fouling and rejection performance in drinking water treatment.

Water Res

January 2025

State Key Joint Laboratory of Environment Simulation and Pollution Control, School of Environment, Tsinghua University, Beijing 100084, China. Electronic address:

The almost hydrophobic PVDF membrane (PVDF matrix) commonly exhibited excellent performance in pollutant rejection but with poor anti-fouling performance. This study intended to develop the rejection performance and enhance anti-fouling of the PVDF membrane in an O/UF/BAC system for high quality water production through leveraging the advantages of in-situ ozonation and the nature of the PVDF membrane. Reduced density gradient (RDG) analysis demonstrated that the PVDF membrane exhibited excellent ozone resistance by reducing hydrogen bonds and electrostatic interactions between the membrane surface and ozone.

View Article and Find Full Text PDF

Copper-containing industrial wastewater, characterized by strong acidity, high ionic strength, and various competing metals, presents significant challenges for Cu(II) recovery. To address these issues, an electric field-enhanced ultrafiltration process was developed, assisted with a functional polyelectrolyte with high selectivity for Cu(II). The polyelectrolyte, termed PPEI, was synthesized by grafting picolyl groups onto polyethyleneimine (PEI), enhancing its affinity for Cu(II).

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!