In the present work, attempts have been made to prepare scintillating nanoparticle composite films of Ce -doped Y Al O (YAG:Ce) embedded in a polystyrene (PS) polymer. A YAG:Ce phosphor has been previously synthesized using the sol-gel method. YAG:Ce-PS composite films of 250 ± 30 μm thickness were prepared using a solvent casting procedure with different PS/solvent concentration and a different mass ratio between nanoparticles of YAG:Ce and PS. X-ray diffraction analysis confirmed that the YAG:Ce powders were successfully prepared. Using thermogravimetric analyses and differential scanning calorimetry, we found that the glass transition temperature (Tg) and thermal degradation were shifted to higher temperatures for composite films relative to pure PS. Photoluminescence showed the yellow emission of the Ce -doped YAG phosphors, which was attributed to the 5d→4f transition of Ce ion and the intensity of the emissions changed with the mass ratio of the YAG:Ce nanoparticles incorporated in the polymer and with the concentration of the polymer solution.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1002/bio.4289 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Design of an Atomic Layer-Deposited InO/GaO Channel Structure for High-Performance Thin-Film Transistors.
ACS Appl Mater Interfaces
January 2025
Department of Electronic Engineering, Hanyang University, Seoul 04763, Republic of Korea.
For potential application in advanced memory devices such as dynamic random-access memory (DRAM) or NAND flash, nanolaminated indium oxide (In-O) and gallium oxide (Ga-O) films with five different vertical cation distributions were grown and investigated by using a plasma-enhanced atomic layer deposition (PEALD) process. Specifically, this study provides an in-depth examination of how the control of individual layer thicknesses in the nanolaminated (NL) IGO structure impacts not only the physical and chemical properties of the thin film but also the overall device performance. To eliminate the influence of the cation composition ratio and overall thickness on the IGO thin film, these parameters were held constant across all conditions.
View Article and Find Full Text PDFPhotochromic Sodalites: From Natural Minerals to Advanced Applied Materials.
Acc Chem Res
January 2025
Mineralogical Society of Antwerp, Boterlaarbaan 225, 2100 Deurne, Belgium.
ConspectusWhile photochromic natural sodalites, an aluminosilicate mineral, were originally considered as curiosities, articles published in the past ten years have radically changed this perspective. It has been proven that their artificial synthesis was easy and allowed compositional tuning. Combined with simulations, it has been shown that a wide range of photochromic properties were achievable for synthetic sodalites (color, activation energy, reversibility, etc.
View Article and Find Full Text PDFUltrafast Synthesis of Hard Carbon Anodes for Sodium-ion Batteries: An Intense-Pulsed-Light-Assisted Approach to Photothermal Carbonization of Polymer/Carbon Nanotube Composite Films.
Small Methods
January 2025
Nano Hybrid Technology Research Center, Electrical Materials Research Division, Korea Electrotechnology Research Institute (KERI), Changwon, 51543, Republic of Korea.
The conventional carbonization process for synthesizing hard carbons (HCs) requires high-temperature furnace operations exceeding 1000 °C, leading to excessive energy consumption and lengthy processing times, which necessitates the exploration of more efficient synthesis methods. This study demonstrates the rapid preparation of HC anodes using intense pulsed light (IPL)-assisted photothermal carbonization without the prolonged and complex operations typical of traditional carbonization methods. A composite film of microcrystalline cellulose (MCC) and single-walled carbon nanotubes (SWCNTs) is carbonized at high temperatures in less than 1 min.
View Article and Find Full Text PDFFabrication of high-performance tin halide perovskite thin-film transistors via chemical solution-based composition engineering.
Nat Protoc
January 2025
Department of Chemical Engineering, Pohang University of Science and Technology, Pohang, Gyeongbuk, Republic of Korea.
Metal halide perovskite semiconductors have attracted considerable attention because they enable the development of devices with exceptional optoelectronic and electronic properties via cost-effective and high-throughput chemical solution processes. However, challenges persist in the solution processing of perovskite films, including limited control over crystallization and the formation of defective deposits, leading to suboptimal device performance and reproducibility. Tin (Sn) halide perovskite holds promise for achieving high-performance thin-film transistors (TFTs) due to its intrinsic high hole mobility.
View Article and Find Full Text PDFEngineering vaginal film platform for mucoadhesion and sustained drug release for HIV-1 prevention.
J Control Release
January 2025
Department of Pharmaceutical Sciences, School of Pharmacy, University of Pittsburgh, Pittsburgh, PA, USA; Magee-Womens Research Institute, Pittsburgh, PA, USA; Department of Obstetrics, Gynecology & Reproductive Sciences, School of Medicine, University of Pittsburgh, Pittsburgh, PA, USA. Electronic address:
User adherence contributes to the effectiveness of topical pre-exposure prophylactic products designed to protect against human immunodeficiency virus type 1 (HIV-1) infection. Long-acting approaches that do not require daily or coitally-dependent use could potentially improve user adherence. This study aims to develop a long-acting vaginal film to deliver an integrase inhibitor, MK-2048, for prevention of HIV-1 infection.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!