The Impact of Post-Tear Collection Storage on Tear Film Substance P Concentration.

Curr Eye Res

School of Optometry and Vision Science, Faculty of Medicine and Health, University of New South Wales, Sydney, Australia.

Published: August 2022

Purpose: Substance P is a sensory neuropeptide increasingly used as a biomarker for ocular and systemic neuropathic conditions. Due to the limited studies on tear storage conditions compared to other bodily fluids including blood and urine, the aim of this study was to investigate whether different storage durations at 4 °C can impact on substance P concentrations prior to storage at -80 °C. This is important to assess potential practical limitations in the handling and storage of tear fluid essential.

Methods: Tears were collected and pooled from both eyes of 31 healthy participants using the flush tears method. The samples were centrifuged and aliquoted into three sets of microcentrifuge tubes with each stored at 4 °C for <2 h, 4 h or 6 h (Timepoints 1, 2 or 3). After each respective storage duration, the aliquoted samples were than stored at -80 °C before analysis, within 6 months. Tears were analyzed for the concentration of substance P and the total protein content (TPC).

Results: Substance P concentrations across the three timepoints were not significantly different ( > 0.05), including Timepoint 1 (Median [interquartile range]: 10.7 ng/ml [1.6-37.9]), Timepoint 2 (10.9 ng/ml [1.6-32.6]) and Timepoint 3 (5.2 ng/ml [1.3-25.2]). There were also no significant differences in TPC concentrations measured at the three timepoints, including Timepoint 1 (3.1 mg/ml [1.7-3.8]), Timepoint 2 (2.9 mg/ml [1.9-4.1]) and Timepoint 3 (2.7 mg/ml [1.6-3.7]).

Conclusions: While the levels of substance P were stable while stored at 4 °C prior to proper -80 °C storage and analysis, future research should investigate the impact of other storage conditions such as ambient room temperature to optimize the feasibility of using tears for biomarker purposes in clinical settings.

Download full-text PDF

Source
http://dx.doi.org/10.1080/02713683.2022.2067565DOI Listing

Publication Analysis

Top Keywords

storage tear
8
storage conditions
8
stored 4 °c
8
including timepoint
8
storage
7
timepoint
6
impact post-tear
4
post-tear collection
4
collection storage
4
tear film
4

Similar Publications

Purpose: To assess the impact of autologous serum (AS) tears at a 50% concentration on the ocular surface of patients with refractory dry eye disease (DED) because of Sjogren syndrome.

Methods: Twenty eyes of ten patients with severe immune-mediated DED were contralaterally randomized to receive either AS tears 50% or artificial tears between June 2021 and May 2023. Changes in tear stability, ocular surface staining, and in the morphology of the corneal sub-basal nerves were evaluated before treatment and at 1, 2, and 3 months after treatment using objective tests for DED and confocal microscopy.

View Article and Find Full Text PDF

Using a laser-scribed (direct printing) technique, we have fabricated an enzymeless, mediatorless, and paper-interfaced electrochemical device (P-LSG) for uric acid detection on a flexible polyimide sheet. Various paper substrates were investigated, and it was found that Whatman filter paper-1 is promising to obtain the best electrochemical signals at the small volume of electrolyte, i.e.

View Article and Find Full Text PDF

: We developed delafloxacin (Dela)-loaded PLGA nanoparticles (PNPs) for potential ocular application a topical route to treat eye infections caused by Gram-positive and Gram-negative bacteria. : Dela-PNPs were formulated using the emulsification-solvent evaporation method and stabilized using poly(vinyl alcohol) (PVA). Size and morphology were characterized by using dynamic light scattering (DLS) and scanning electron microscopy (SEM).

View Article and Find Full Text PDF

Root-inspired, template-confined additive printing for fabricating high-robust conformal electronics.

Microsyst Nanoeng

December 2024

Micro- and Nano-technology Research Center, State Key Laboratory for Manufacturing Systems Engineering, Xi'an Jiaotong University, Xi'an, Shaanxi, 710049, China.

Conformal electronic devices on freeform surface play a critical role in the emerging smart robotics, smart skins, and integrated sensing systems. However, their functional structures such as circuits tend to tear-off, break, or crack under mechanical or thermal influence when in service, thus limiting the application reliability of conformal electronics. Herein, inspired by the tree root system, template-confined additive (TCA) printing technology was presented for reliable fabrication of robust circuits.

View Article and Find Full Text PDF

Interspecies differences in human, pig and sheep corneal thickness may affect the colonization. Currently, there is no research investigating the impact of these differences, along with variable storage and culture conditions on infection in cornea models. These factors could significantly influence utilizing models for drug testing research.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!