We report here on the development of a multi-Watt power tunable single frequency ultra-low noise laser system emitting around 620 nm. More than 5 W of output power is obtained between 616.5 nm and 630.8 nm using sum frequency generation of 1050 nm and 1550 nm tunable laser sources in a periodic poled lithium niobate crystal. The tunability is achieved through temperature and channel shift, and only limited by the crystal characteristics. An output power of 10.1 W and an optical-optical efficiency of 45% are reached at 624.5 nm. The relative intensity noise properties of the conversion process have been experimentally investigated in different configurations showing excellent agreement with the analytical prediction.

Download full-text PDF

Source
http://dx.doi.org/10.1364/OE.455218DOI Listing

Publication Analysis

Top Keywords

output power
8
high power
4
power ultralow-intensity
4
ultralow-intensity noise
4
noise continuous
4
continuous wave
4
wave laser
4
laser tunable
4
tunable orange
4
orange red
4

Similar Publications

Background: The spatial resolution of new, photon counting detector (PCD) CT scanners is limited by the size of the focal spot. Smaller, brighter focal spots would melt the tungsten focal track of a conventional X-ray source.

Purpose: To propose focal spot multiplexing (FSM), an architecture to improve the power of small focal spots and thereby enable higher resolution clinical PCD CT.

View Article and Find Full Text PDF

This study first proposes an innovative method for optimizing the maximum power extraction from photovoltaic (PV) systems during dynamic and static environmental conditions (DSEC) by applying the horse herd optimization algorithm (HHOA). The HHOA is a bio-inspired technique that mimics the motion cycles of an entire herd of horses. Next, the linear active disturbance rejection control (LADRC) was applied to monitor the HHOA's reference voltage output.

View Article and Find Full Text PDF

Dual-mode, regenerated DNA motor for simultaneous detection of viral gene fragments and diagnosis of infectious disease.

Biosens Bioelectron

January 2025

Shandong Key Laboratory of Biophysics, Institute of Biophysics, Institute of Rural Revitalization, School of Pharmacy, Dezhou University, 253023, Dezhou, China. Electronic address:

This study presents a dual-mode and regenerated DNA motor powered by exonuclease III (Exo III) for the simultaneous detection of viral gene fragments. The detection methodology is categorized into two distinct operational modes. The first mode emphasizes the simultaneous detection of two viral gene fragments from a specific virus.

View Article and Find Full Text PDF

High-Performance Mechano-Sensitive Piezoelectric Nanogenerator from Post-Treated Nylon-11,11 Textiles for Energy Harvesting and Human Motion Monitoring.

ACS Appl Mater Interfaces

January 2025

School of Materials Science and Engineering, Henan Key Laboratory of Advanced Nylon Materials and Application, Zhengzhou University, Zhengzhou 450001, China.

Piezoelectric polymer textiles offer distinct advantages in the fabrication of wearable nanogenerators (NGs). One effective strategy to enhance the output capacity of NGs is to modulate the piezoelectric performance of the textiles. This paper focuses on further improving the piezoelectric properties of nylon-11,11 textiles through post-drawing and annealing treatments.

View Article and Find Full Text PDF

Background: Both listening to music during warm-up and consuming caffeine before exercise have been independently shown to enhance athletic performance. However, the potential synergistic effects of combining these strategies remain largely unexplored. To date, only two studies have reported additional benefits to combining music during warm-up with a caffeine dose of 3 mg/kg on taekwondo-specific performance tasks.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!