Significance: Both the Melbourne Rapid Fields (MRF) tablet and home versions are easy-to-use, portable, and low-cost and accurate methods of evaluating visual fields.
Purpose: This study aimed to investigate the clinical capabilities of the MRF perimetry test by comparing it with the Humphrey Field Analyzer (HFA), determine MRF consistency, assess the influence of refractive error, ascertain ambient illumination effects, and evaluate the consistency between the tablet and Internet Web site versions of the MRF.
Methods: Forty healthy young participants with normal visual function (33 female, 7 male; average age, 24 years) underwent two MRF office-based tablet, two HFA tests, and two MRF Web site-based tests, one in our laboratory and one at home on their own computer using the 24-2 test pattern each time. An additional six healthy participants with normal visual function performed the 24-2 test with varying amounts of blur.
Results: The average individual sensitivity values of MRF and HFA were within 4.02 dB (right eye) and 4.15 dB (left eye). The dynamic range of the MRF was smaller (30 dB) than that of the HFA. When sensitivity values greater than 30 dB were excluded, the sensitivity differences were within 2.2 dB (right eye) and 2.46 dB (left eye) of each other. Only a small number of cases produced reliability values (false positives, false negatives, fixation losses) that were outside of normal limits. There was a high correlation between test results obtained with the tablet version of the MRF test when compared with the Internet-based Web site version.
Conclusions: Quantitative visual field testing and perimetric screening procedures can be performed effectively and can provide results that are comparable with bowl perimeter test results.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1097/OPX.0000000000001889 | DOI Listing |
Commun Biol
January 2025
Department of Infectious Diseases, The University of Melbourne at The Peter Doherty Institute for Infection and Immunity, Melbourne, VIC, Australia.
Critical to the success of CRISPR-based diagnostic assays is the selection of a diagnostic target highly specific to the organism of interest, a process often requiring iterative cycles of manual selection, optimisation, and redesign. Here we present PathoGD, a bioinformatic pipeline for rapid and high-throughput design of RPA primers and gRNAs for CRISPR-Cas12a-based pathogen detection. PathoGD is fully automated, leverages publicly available sequences and is scalable to large datasets, allowing rapid continuous monitoring and validation of primer/gRNA sets to ensure ongoing assay relevance.
View Article and Find Full Text PDFActa Crystallogr B Struct Sci Cryst Eng Mater
February 2025
CSIRO Division of Mineral Products, Port Melbourne, Victoria, Australia.
The crystallographic phase change from tetragonal litharge (α-PbO; P4/nmm) to orthorhombic massicot (β-PbO; Pbcm) has been studied by full-matrix Rietveld analysis of high-temperature neutron powder diffraction data collected in equal steps from ambient temperature up to 925 K and back down to 350 K. The phase transformation takes place between 850 and 925 K, with the coexisting phases having equal abundance by weight at 885 K. The product massicot remains metastable on cooling to near ambient temperature.
View Article and Find Full Text PDFProc Biol Sci
January 2025
Evolution and Ecology Research Centre, School of Biological, Earth and Environmental Sciences, University of New South Wales, Sydney, New South Wales 2052, Australia.
Publishing preprints is quickly becoming commonplace in ecology and evolutionary biology. Preprints can facilitate the rapid sharing of scientific knowledge establishing precedence and enabling feedback from the research community before peer review. Yet, significant barriers to preprint use exist, including language barriers, a lack of understanding about the benefits of preprints and a lack of diversity in the types of research outputs accepted (e.
View Article and Find Full Text PDFEur Phys J C Part Fields
January 2025
A measurement of the dijet production cross section is reported based on proton-proton collision data collected in 2016 at by the CMS experiment at the CERN LHC, corresponding to an integrated luminosity of up to 36.3 . Jets are reconstructed with the anti- algorithm for distance parameters of and 0.
View Article and Find Full Text PDFPhys Chem Chem Phys
January 2025
Temperature and Humidity Metrology, CSIR-National Physical Laboratory, Dr K. S. Krishnan Marg, New Delhi, 110012, India.
In this study, we have proposed an advanced humidity sensor based on a composite of chitosan (CS) and graphene oxide (GO), prepared by the drop casting method. Graphene oxide-chitosan (GO-CS) films with varying volumetric ratios, along with pure GO and CS films, were prepared and extensively characterized using XRD, Raman, FTIR, SEM, XPS, and water contact angle to study their structural and morphological properties. Comparative analysis of humidity sensing parameters of all prepared films revealed that the film with a volumetric ratio of 4 : 1 (GOCS-2) performs best among all of them, which is attributed to the synergistic interaction between GO and CS.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!