Work-related musculoskeletal disorders have been recognized as a global problem that affects millions of people annually. Fatigue is one of the main contributors to musculoskeletal disorders. Thus, this study investigated fatigue detection based on the measured body motion by wearable inertial measurement units. We quantified the body motion during manual handling tasks using a novel kinematic score (i.e., K-score), and the Rapid Entire Body Assessment (REBA). K-score and REBA were calculated using joint angles. Nevertheless, unlike REBA, K-score showed a significant correlation (Spearman's correlation coefficient of ρ(302) = 0.21, p < 0.05) with electromyography (EMG) signal amplitude, which was affected by muscle fatigue. Therefore, in-field measurement of K-score using inertial measurement units could detect the fatigue-induced change of body motion in long-duration manual handling tasks. Our proposed K-score can be used to assess fatigue-related ergonomic risk in long-term and real-world working conditions without the need for tedious EMG recording at workplaces.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1016/j.apergo.2022.103757 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Gait during community ambulation and laboratory-based walking in people with mild traumatic brain injury.
Gait Posture
January 2025
Department of Neurology, Oregon Health & Science University, Portland, OR, United States. Electronic address:
Background: Gait impairments are common in individuals with mild traumatic brain injury (mTBI), presenting in the acute phase and often persisting in subtle ways over time. Despite the prominence of laboratory gait evaluations, a comprehensive understanding of gait deficits post-mTBI necessitates the examination of various gait domains in real-world environments. Assessing gait during a community ambulation task (CAT) may capture real-world challenges and influence focused interventions or rehabilitation in individuals with mTBI.
View Article and Find Full Text PDFCenter of mass acceleration during walking: comparison between IMU and camera-based motion capture methodologies.
Wearable Technol
November 2024
Department of Kinesiology, Iowa State University, Ames, IA, USA.
Placing an inertial measurement unit (IMU) at the 5th lumbar vertebra (L5) is a frequently employed method to assess the whole-body center of mass (CoM) motion during walking. However, such a fixed position approach does not account for instantaneous changes in body segment positions that change the CoM. Therefore, this study aimed to assess the congruence between CoM accelerations obtained from these two methods.
View Article and Find Full Text PDFBringing biomechanics to ballet: a feasibility study using wearable technology during grand allegro.
Sports Biomech
January 2025
Artistic Health Department, The Australian Ballet, Southbank, Victoria, Australia.
Quantifying impact accelerations during ballet class may assist load management. The largest impact accelerations occur during the sequence of large (single or double-leg) jumps (grand allegro) but are potentially the most challenging class component for utilising wearable technology, and feasibility is unknown. This pilot study utilised wearable technology during class to (1) explore feasibility and acceptability, (2) quantify impact accelerations during the entire sequence of jumps during grand allegro and (3) compare impact accelerations between limbs (preferred and non-preferred landing limb).
View Article and Find Full Text PDFReliability of running gait variability measures calculated from inertial measurement units.
J Biomech
January 2025
Sport and Physical Activity Research Centre, Sheffield Hallam University, Olympic Legacy Park, 2 Old Hall Rd, Sheffield S9 3TY, United Kingdom. Electronic address:
Changes to the variability within biomechanical signals may reflect a change in the health of the human system. However, for running gait variability measures calculated from wearable device data, it is unknown whether a between-day difference reflects a shift in system dynamics reflective of a change in human health or is a result of poor between-day reliability of the measurement device or the biomechanical signal. This study investigated the reliability of stride time and sacral acceleration variability measures calculated from inertial measurement units (IMUs).
View Article and Find Full Text PDFInstrumenting Parkrun: Usefulness and Validity of Inertial Sensors.
Sensors (Basel)
December 2024
Department of Sport, Exercise and Rehabilitation, Northumbria University, Newcastle upon Tyne NE1 8ST, UK.
The analysis of running gait has conventionally taken place within an expensive and restricted laboratory space, with wearable technology offering a practical, cost-effective, and unobtrusive way to examine running gait in more natural environments. This pilot study presents a wearable inertial measurement unit (IMU) setup for the continuous analysis of running gait during an outdoor parkrun (i.e.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!