Effect of the violet light from polywave light-polymerizing units on two resin cements that use different photoinitiators.

Statement Of Problem: Some light-emitting diode polymerization lights have been promoted as multiple peak or polywave lights that use multiple light-emitting diodes to produce both violet and blue light. However, whether the addition of violet light is required to light-activate resin cements that use bis(4-methoxybenzoyl)diethylgermane (Ivocerin) as the photoinitiator is unclear.

Purpose: This in vitro study evaluated the effect of violet, blue, or a combination of violet and blue light through ceramic on the degree of conversion of 2 resin cements that use either camphorquinone or Ivocerin as the photoinitiator.

Material And Methods: A Bluephase Style polywave light-emitting diode polymerizing unit delivering 6.4 J/cm of violet and blue light was used. This comprised 1.4 J/cm of violet (385 to 420 nm) and 5.0 J/cm of blue light (420 to 515 nm). The light-emitting diode emitters in a second modified Bluephase Style were connected directly to a power supply so that either just violet (1.4 J/cm) or just blue (5.0 J/cm) light was emitted. RelyX Veneer and Variolink Esthetic LC resin cements were either directly light-activated or through 0.5 or 1.5 mm of lithium disilicate ceramic (IPS e.max CAD). The degree of conversion was monitored by using Fourier-transform infrared spectroscopy. Data were subject to a 3-way analysis of variance followed by the Tukey honest significant difference multiple comparison tests (α=.05).

Results: All factors had a significant effect (P<.001). Increasing the ceramic thickness decreased the degree of conversion only for RelyX Veneer cement (P<.001). The effect of the thickness of ceramic was most noticeable when just violet light was delivered to RelyX Veneer. A significant reduction (P<.001) was found in the degree of conversion of RelyX Veneer when just violet light was delivered. Variolink Esthetic LC had significantly higher degree of conversion values than RelyX Veneer, irrespective of the light type used (P<.001).

Conclusions: A multiple-peak light is not required to photopolymerize a resin cement that uses either camphorquinone or Ivocerin as its photoinitiator. Adding the violet light produced no significant increase in the degree of conversion of the Variolink Esthetic LC cement.