Uniform International Method to Measure Cervical Length: Are We There Yet?

Fetal Diagn Ther

Department of Obstetrics & Gynecology, Amsterdam UMC, University of Amsterdam, Amsterdam, The Netherlands.

Published: July 2022

AI Article Synopsis

  • Cervical length is crucial for predicting spontaneous preterm birth, but methods for its measurement vary, prompting a study to compare six techniques, both with and without including the cervico-isthmic complex (CIC).
  • The study analyzed 1,691 women between 18-22 weeks of pregnancy, finding significant differences in cervical lengths across measurement techniques, with some methods showing considerable variation (over 8 mm).
  • The positive predictive values for spontaneous preterm birth measured by these techniques varied widely from 42.9% to 20.0%, indicating the importance of the chosen measurement method.

Article Abstract

Introduction: Cervical length is an important predictor of spontaneous preterm birth. So far, the best way to measure cervical length has not been established. We aimed to compare the incidence of short cervical length between three methods of cervical length measurement with and without the inclusion of cervico-isthmic complex (CIC) (six methods in total) and to determine the positive predictive value for spontaneous preterm birth.

Material And Methods: We performed a prospective single-center cohort study in women with a singleton pregnancy between August 2014 and December 2018. During the routine fetal anomaly scan (18-22 weeks), women were offered transvaginal ultrasound for cervical length measurement to screen for the risk of spontaneous preterm birth. Each cervix was measured in six different ways: single-line, two-line, and tracing method between the internal and external os of the cervix with and without CIC. We evaluated the predictive value of the different measurements for spontaneous delivery before 37 weeks using positive predictive values.

Results: Our final study population comprised 1,691 women. The overall rate of preterm birth <37 weeks was 8.0% (4.6% spontaneous, 3.4% iatrogenic preterm birth). The mean gestational age at cervical length measurement was 19+6 weeks. The different measuring techniques resulted in significant different cervical lengths, showing a maximum difference of >8 mm between the techniques (41.04 mm [SD 7.1] with one-line without CIC and 49.18 [SD 9.05] mm with trace with CIC) with an incidence of short cervical length below <25 mm ranging from 0.4% to 1.1% (p = 0.18). The positive predictive values for spontaneous preterm birth <37 weeks ranged from 42.9% to 20.0%.

Conclusion: Different measurement methods for cervical length resulted in statistically significant differences in measured cervical length. Depending on the chosen cut-off this translates to different incidences of short cervical length and influences the number of women designated as high risk for preterm birth and receiving treatment. For interpretation and comparability between (inter-) national studies, it is important to adequately report on the employed technique. Future research should focus on determining the optimal measuring technique and a universal method of measurement.

Download full-text PDF

Source
http://dx.doi.org/10.1159/000523996DOI Listing

Publication Analysis

Top Keywords

cervical length
28
spontaneous preterm
12
preterm birth
12
measure cervical
8
incidence short
8
short cervical
8
length measurement
8
positive predictive
8
cervical
7
length
7

Similar Publications

Injuries involving the Atlas (C1) and Axis (C2) vertebrae of the cervical spine present significant clinical challenges due to their complex anatomy and potential for severe neurological impairment. Traditional imaging methods often lack the detailed visualization required for precise surgical planning. This study aimed to develop high-resolution 3D models of the C1 and C2 vertebrae to perform a comprehensive morphometric analysis, identify gender differences, and assess bilateral symmetry to enhance surgical accuracy.

View Article and Find Full Text PDF

The aim of this study was to elucidate the impact of porcine pancreatic enzymes (Creon pancrelipase) in comparison to microbial-derived alpha amylase (MD amylase) on the small intestine wall structure, mucosal glycogen accumulation, and enterocyte turnover. The impact of enzyme supplementation on the small intestine was explored in 18 pigs with surgically induced exocrine pancreatic insufficiency (EPI). Four healthy pigs served as the control group.

View Article and Find Full Text PDF

CXCL12 and CXCR4 proteins and mRNAs were monitored in the dorsal root ganglia (DRGs) of lumbar (L4-L5) and cervical (C7-C8) spinal segments of naïve rats, rats subjected to sham operation, and those undergoing unilateral complete sciatic nerve transection (CSNT) on post-operation day 7 (POD7). Immunohistochemical, Western blot, and RT-PCR analyses revealed bilaterally increased levels of CXCR4 protein and mRNA in both lumbar and cervical DRG neurons after CSNT. Similarly, CXCL12 protein levels increased, and CXCL12 mRNA was upregulated primarily in lumbar DRGs ipsilateral to the nerve lesion.

View Article and Find Full Text PDF

A study protocol for individualized prognostic counselling in the palliative phase.

BMC Palliat Care

January 2025

Department of Otorhinolaryngology and Head and Neck Surgery, Erasmus MC Cancer Institute, University Medical Centre Rotterdam, Dr. Molewaterplein 40, Rotterdam, 3015 GD, The Netherlands.

Background: Head and neck squamous cell cancer (HNSCC) has a poor prognosis, with approximately 25-30% of patients transitioning into the palliative phase at some point. The length of this phase is relatively short, with a median duration of five months. Patients in this stage often have increased prognostic information needs.

View Article and Find Full Text PDF

Computer-aided design and fabrication of statistically shaped nasal prostheses: A feasibility study.

J Prosthet Dent

January 2025

Head and Neck Surgeon and Head, Verwelius 3D Lab, Department of Head and Neck Oncology and Surgery, Netherlands Cancer Institute, Amsterdam, The Netherlands.

Statement Of Problem: A nasal prosthesis may compensate for a partial or complete defect of the nose associated with trauma or amputation. However, the design and production is time-consuming, expensive, and expertize-dependent. Computer-generated prosthesis models and 3D printing can optimize the process.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!