Pollutant emissions from residential heating systems represent a main concern in terms of outdoor air quality. Differently from other pollutants, sub-micron particle emission from heating systems has not yet been exhaustively characterized by the scientific literature, with limited data available, in particular, for gas-fueled boilers. In the present paper, an experimental campaign to measure the sub-micron particle number concentrations and distributions at the stack of different automatically-fed small-scale heating systems (conventional and condensing boilers fueled by natural gas and liquid petroleum gas, and pellet stoves) was performed. Based on the measured concentrations, corresponding emission rates and emission factors were also estimated. The results of the experimental campaign revealed that the highest concentrations were measured for pellet stoves (median value >10 part. m), whereas conventional (about 1 × 10 part. m) and condensing boilers (<10 part. m) presented much lower concentrations. No effect of the fuel (natural gas, liquid petroleum gas) on the total concentration measured at the stack of boilers was recognized, whereas a smaller distribution mode (at 10 nm) was measured for gas-fired boilers. Because of the particle concentration values, the highest particle emission rates and factors were the pellet stove ones (median values of 2.1 × 10 part. h and 8.4 × 10 part. kWh, respectively), whereas emission rates for conventional and condensing boilers were about 5 × 10 part. h and 2 × 10 part. h, respectively. The estimated emission factors were also adopted to perform a simplified evaluation of the relative contributions of the investigated automatically-fed small-scale heating systems in terms of particle number on a national scale (Italy): we obtained that the pellet stove contribution is the main one as it accounts for 87% of total emissions of particle number for heating purpose.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.scitotenv.2022.154288DOI Listing

Publication Analysis

Top Keywords

heating systems
16
sub-micron particle
12
conventional condensing
12
condensing boilers
12
pellet stoves
12
particle number
8
residential heating
8
boilers fueled
8
fueled natural
8
natural gas
8

Similar Publications

Triazole, a nitrogen-containing five-membered heterocycle with two isomeric forms, 1,2,3-triazole and 1,2,4-triazole, has proven to be a valuable component in the pharmaceutical domain. Owing to its widespread utility in drug development, pharmaceutical and medicinal chemistry, several synthetic methods have been explored, such as different catalytic systems, solvents, and heating methodologies in recent years. However, some methods were associated with several limitations, such as harsh reaction conditions, high temperatures, low atom economy, and long reaction times.

View Article and Find Full Text PDF

Recycling of Post-Consumer Waste Polystyrene Using Commercial Plastic Additives.

ACS Cent Sci

January 2025

Department of Chemistry, Princeton University, Princeton, New Jersey 08544, United States.

Photothermal conversion can promote plastic depolymerization (chemical recycling to a monomer) through light-to-heat conversion. The highly localized temperature gradient near the photothermal agent surface allows selective heating with spatial control not observed with bulk pyrolysis. However, identifying and incorporating practical photothermal agents into plastics for end-of-life depolymerization have not been realized.

View Article and Find Full Text PDF

Wearable thermoelectric generator (TEG) can collect human body heat and convert it into electrical energy, achieving self-powering of the device and thus becoming a hot research topic at present. By utilization of three-dimensional spiral thin-film thermoelectric structures and passive radiation cooling methods, the heat transfer area can be increased and power generation can be enhanced. In order to study the effect of outdoor radiation cooling on the thermoelectric performance of spiral heating, as well as the TEG performance output under different external environments and circuit loads, this paper proposes a new three-dimensional coupled numerical model of the spiral thermoelectric wristband system with multiple physical fields.

View Article and Find Full Text PDF

Background: The adverse health impacts of ambient temperature have been well-documented, encompassing not only the mortality and morbidity burden but also mood and mental health disorders. However, the relationship between temperature and social isolation remains unexplored. The objective of the current study was to investigate the potential associations between ambient temperature and social isolation among the aging population.

View Article and Find Full Text PDF

Plasmonic heating by indium tin oxide nanoparticles: spectrally enabling decoupled near-infrared theranostics.

Nanoscale

January 2025

Nanomaterials for BioImaging Group (nanoBIG), Departamento de Física de Materiales, Universidad Autónoma de Madrid (UAM), Madrid 28049, Spain.

All-optical theranostic systems are sought after in nanomedicine, since they combine in a single platform therapeutic and diagnostic capabilities. Commonly in these systems the therapeutic and diagnostic/imaging functions are accomplished with plasmonic photothermal agents and luminescent nanoparticles (NPs), respectively. For maximized performance and minimized side effects, these two modalities should be independently activated, , in a decoupled way, using distinct near infrared (NIR) wavelengths: a radiation window wherein photon-tissue interaction is reduced.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!