Porous CDHA microspheres were incorporated into innovative injectable calcium phosphate cement (CPC) to enhance the rate of degradation and bioactivity of bone regeneration. With varying content of CDHA microspheres, the final setting time varied between 12 and 17 min, which is adequate for surgeons to accomplish the implantation. Compressive strength ranged between 6 and 8 MPa, until the addition of porous CDHA microsphere into CPC reached 20 vol %, but decreased dramatically after 30 vol % addition. Therefore, CPC with 20 vol % addition of porous CDHA microspheres was found appropriate for in vitro degradation and cytocompatibility studies. Histological assessment identified new bone formation around the injected bone substitute without significant inflammatory reactions. In vivo analysis of rat femoral defects revealed a threefold higher bone formation in CPC/CDHA 20 vol % than in CPC, due to the more cell migration and penetration into CPC by the existence of porous CDHA microspheres. Based on the promising results obtained, this novel injectable bone substitute may be useful in bone regeneration.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1002/jbm.b.35033 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Injectable magnesium oxychloride cement foam-derived scaffold for augmenting osteoporotic defect repair.
J Colloid Interface Sci
June 2023
Department of Chemistry, The Chinese University of Hong Kong, Shatin, N. T., Hong Kong 999077, PR China. Electronic address:
Hypothesis: Cement augmentation has been widely applied to promote osteoporotic fracture healing, whereas the existing calcium-based products suffer from the excessively slow degradation, which may impede bone regeneration. Magnesium oxychloride cement (MOC) shows promising biodegradation tendency and bioactivity, which is expected to be a potential alternative to the classic calcium-based cement for hard-tissue-engineering applications.
Experiments: Here, a hierarchical porous MOC foam (MOCF)-derived scaffold with favorable bio-resorption kinetic and superior bioactivity is fabricated through Pickering foaming technique.
Porous CDHA microspheres laden brushite-based injectable bone substitutes for improved bone regeneration.
J Biomed Mater Res B Appl Biomater
August 2022
Department of Regenerative Medicine, College of Medicine, Soonchunhyang University, Cheonan, South Korea.
Porous CDHA microspheres were incorporated into innovative injectable calcium phosphate cement (CPC) to enhance the rate of degradation and bioactivity of bone regeneration. With varying content of CDHA microspheres, the final setting time varied between 12 and 17 min, which is adequate for surgeons to accomplish the implantation. Compressive strength ranged between 6 and 8 MPa, until the addition of porous CDHA microsphere into CPC reached 20 vol %, but decreased dramatically after 30 vol % addition.
View Article and Find Full Text PDFA BMP/Activin A Chimera Induces Posterolateral Spine Fusion in Nonhuman Primates at Lower Concentrations Than BMP-2.
J Bone Joint Surg Am
August 2021
Orthopedic Research and Pharmaceutical Development Consultant, Hudson, Massachusetts.
Background: Supraphysiologic bone morphogenetic protein (BMP)-2 concentrations are required to induce spinal fusion. In this study, a BMP-2/BMP-6/activin A chimera (BV-265), optimized for BMP receptor binding, delivered in a recombinant human collagen:CDHA [calcium-deficient hydroxyapatite] porous composite matrix (CM) or bovine collagen:CDHA granule porous composite matrix (PCM), engineered for optimal BV-265 retention and guided tissue repair, was compared with BMP-2 delivered in a bovine absorbable collagen sponge (ACS) wrapped around a MASTERGRAFT Matrix (MM) ceramic-collagen rod (ACS:MM) in a nonhuman primate noninstrumented posterolateral fusion (PLF) model.
Methods: In vivo retention of 125I-labeled-BV-265/CM or PCM was compared with 125I-labeled-BMP-2/ACS or BMP-2/buffer in a rat muscle pouch model using scintigraphy.
Guided bone regeneration activity of different calcium phosphate/chitosan hybrid membranes.
Int J Biol Macromol
April 2019
Department of Chemical and Materials Engineering, Tamkang University, No. 151 Ying-chuan Road, Tamsui, New Taipei City, Taiwan. Electronic address:
To fulfill the properties of membrane for guided bone tissue regeneration, chitosan (CS) and calcium phosphates were blended to produce porous hybrid membranes by lyophilization. We synthesized three different calcium phosphates: calcium deficient hydroxyapatite (CDHA), biphasic calcium phosphate (BCP) and β‑tricalcium phosphate (TCP) by a reverse emulsion method followed by calcination, and compared their efficacy on bone regeneration. The CDHA/CS, BCP/CS, and TCP/CS membranes had an interconnected pore structure with porosity of 91-95% and pore size of 102-147 μm.
View Article and Find Full Text PDFEnhanced osteoinductivity of porous biphasic calcium phosphate ceramic beads with high content of strontium-incorporated calcium-deficient hydroxyapatite.
J Mater Chem B
November 2018
National Engineering Research Center for Biomaterials, Sichuan University, Chengdu 610064, China.
Further biomimicking natural bone and enhancing osteoinductivity to meet the requirements of regenerative medicine is the key development direction of biphasic calcium phosphate (BCP) ceramics. Bone mineral is a kind of Ca-deficient hydroxyapatite (CDHA) with many kinds of trace ions incorporated; however, little is actually known regarding the incorporation of trace ions in CDHA, and trace-ions-incorporated CDHA in BCP ceramics has seldom been studied. The present study introduces an effective approach to fabricate porous BCP ceramic beads with a high content of strontium (Sr)-incorporated CDHA (BCP-Sr), and investigated its biological performance, especially with regard to osteoinductivity.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!