Quasi one-dimensional semiconductor nanowires (NWs) in either arrays or single free-standing forms have shown unique optical properties (, light absorption and emission) differently from their thin film or bulk counterparts, presenting new opportunities for achieving enhanced performance and/or functionalities for optoelectronic device applications. However, there is still a lack of understanding of the absorption properties of vertically standing single NWs within an array environment with light coupling from neighboring NWs within certain distances, due to the challenges in fabrication of such devices. In this article, we present a new approach to fabricate single vertically standing NW photodetectors from ordered InP NW arrays using the focused ion beam technique, to allow direct measurements of optical and electrical properties of single NWs standing in an array. The light-matter interaction and photodetector performance are investigated using both experimental and theoretical methods. The consistent photocurrent and simulated absorption mapping results reveal that the light absorption and thus photoresponse of single NWs are strongly affected by the NW array geometry and related light coupling from their surrounding dielectric environment, due to the large absorption cross section and/or strong light interaction. While the highest light concentration factor (∼19.64) was obtained from the NW in an array with a pitch of 1.5 μm, the higher responsivity per unit cell (equivalent to NW array responsivity) of a single vertical NW photodetector was achieved in an array with a pitch of 0.8 μm, highlighting the importance of array design for practical applications. The insight from our study can provide important guidance to evaluate and optimize the device design of NW arrays for a wide range of optoelectronic device applications.

Download full-text PDF

Source
http://dx.doi.org/10.1039/d1nr08088aDOI Listing

Publication Analysis

Top Keywords

single nws
12
light-matter interaction
8
single vertical
8
light absorption
8
optoelectronic device
8
device applications
8
vertically standing
8
nws array
8
light coupling
8
array pitch
8

Similar Publications

Article Synopsis
  • Metal halide perovskites (MHPs) show promise but suffer from structural instability, particularly in high humidity, which limits their practical use.
  • Researchers discovered a method to grow nanowires (NWs) of MHP on glass surfaces under 85% humidity, allowing for tunable lengths and compositions.
  • These nanowire lasers demonstrated impressive qualities such as high quality factor and stability, opening up new possibilities for advanced optical applications.
View Article and Find Full Text PDF

The Ag NWs/TCMs/WPU/PET fabric was prepared by coating the polyester (PET) fabric with Ag NWs/TCMs/WPU paint. First, an electrothermochromic paint was fabricated by incorporating waterborne polyurethane (WPU) and thermochromic microcapsules (TCMs) into silver nanowire (Ag NW) dispersions, and then the Ag NWs/TCMs/WPU paint was applied to polyester (PET) fabrics via brushing, thereby integrating electrothermal and color-changing properties into a single functional layer. The color change test and DSC data demonstrate that the Ag NWs/TCMs/WPU paint exhibits a reversible color change effect, and the flexibility test data indicate that the coating's resistance remains essentially unchanged after 1000 bending cycles.

View Article and Find Full Text PDF

This article describes an approach to making highly stable copper nanowire networks on any type of substrates. These nanostructured materials are highly sought after for, among other applications, the development of next-generation flexible electronics. Their high susceptibility to oxidation in air currently limits their use in the real world.

View Article and Find Full Text PDF

Single vertical InP nanowire diodes with low ideality factors contacted in-array for high-resolution optoelectronics.

Nanotechnology

December 2024

Division of Synchrotron Radiation Research and NanoLund, Department of Physics, Lund University, Box 118, 22100 Lund, Sweden.

Nanowire (NW) optoelectronic and electrical devices offer unique advantages over bulk materials but are generally made by contacting entire NW arrays in parallel. In contrast, ultra-high-resolution displays and photodetectors require electrical connections to individual NWs inside an array. Here, we demonstrate a scheme for fabricating such single NW vertical devices by contacting individual NWs within a dense NW array.

View Article and Find Full Text PDF

The positioning of quantum dots (QDs) in nanowires (NWs) on-axis has emerged as a controllable method of QD fabrication that has given rise to structures with exciting potential in novel applications in the field of Si photonics. In particular, III-V NWQDs attract a great deal of interest owing to their vibrant optical properties, high carrier mobility, facilitation in integration with Si and bandgap tunability, which render them highly versatile. Moreover, unlike Stranski-Krastanov or self-assembled QDs, this configuration allows for deterministic position and size of the dots, enhancing the sample uniformity and enabling beneficial functions.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!