Selecting effective antioxidants is challenging since their efficiency in inhibiting lipid oxidation depends on the rate constants of the chemical reactions involved and their concentration at the reaction site, i.e., at the interfacial region. Accumulation of antioxidants at the interface of emulsions is key to modulate their efficiency in inhibiting lipid oxidation but its control was not well understood, especially in emulsions. It can be optimized by modifying the physicochemical properties of antioxidants or the environmental conditions. In this work, we analyze the effects of surfactant concentration, droplet size, and oil to water ratio on the effective interfacial concentration of a set of chlorogenic acid (CGA) esters in fish oil-in-water (O/W) emulsions and nanoemulsions and on their antioxidant efficiency. A well-established pseudophase kinetic model is used to determine in the intact emulsified systems the effective concentrations of the antioxidants (AOs). The relative oxidative stability of the emulsions is assessed by monitoring the formation of primary oxidation products with time. Results show that the concentration of all AOs at the interfacial region is much higher (20-90 fold) than the stoichiometric one but is much lower than those of other phenolipid series such as caffeic or hydroxytyrosol derivatives. The main parameter controlling the interfacial concentration of antioxidants is the surfactant volume fraction, Φ, followed by the O/W ratio. Changes in the droplet sizes (emulsions and nanoemulsions) have no influence on the interfacial concentrations. Despite the high radical scavenging capacity of CGA derivatives and their being concentrated at the interfacial region, the investigated AOs do not show a significant effect in inhibiting lipid oxidation in contrast with what is observed using other series of homologous antioxidants with similar reactivity. Results are tentatively interpreted in terms of the relatively low interfacial concentrations of the antioxidants, which may not be high enough to make the rate of the inhibition reaction faster than the rate of radical propagation.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC8838834PMC
http://dx.doi.org/10.3390/molecules27030861DOI Listing

Publication Analysis

Top Keywords

interfacial concentrations
12
concentrations antioxidants
12
inhibiting lipid
12
lipid oxidation
12
interfacial region
12
antioxidant efficiency
8
chlorogenic acid
8
fish oil-in-water
8
interfacial
8
low interfacial
8

Similar Publications

Effects of Maillard Reaction Durations on the Physicochemical and Emulsifying Properties of Chickpea Protein Isolate.

Foods

January 2025

Department of Marine Biopharmacology, College of Food Science and Technology, Shanghai Ocean University, Shanghai 201306, China.

This study investigated the physicochemical and emulsifying properties of chickpea protein isolate (CPI)-citrus pectin (CP) conjugates formed via the Maillard reaction across varying reaction durations. CPI and CP were conjugated under controlled dry-heating conditions, and the resulting conjugates were characterized by measuring their particle size, zeta potential, solubility, thermal stability, surface hydrophobicity, and emulsifying properties. The results showed that as reaction duration increased, the particle size and zeta potential of the CPI-CP conjugates increased significantly, reaching a maximum particle size of 1311.

View Article and Find Full Text PDF

Interfacial properties significantly influence emulsifying and foaming stability. We here explore the interfacial behavior of egg yolk granules (EYGs) combined with various Span emulsifiers (Span 20, 40, 60, 80) to assess their solution properties, interface dynamics, and effects on emulsifying and foaming stability. The results unveiled that as the Span concentration increased, particle size decreased from 7028 to 1200 nm, absolute zeta potential increased from 4.

View Article and Find Full Text PDF

Effect of Chemical Treatment on the Mechanical and Hygroscopic Properties of an Innovative Clay-Sand Composite Reinforced with Fibers.

Materials (Basel)

January 2025

Laboratoire d'Energétique et des Transferts Thermique et Massique (LETTM), Faculté des Sciences de Tunis, Université de Tunis El Manar, Campus Universitaire El-Manar, El Manar, Tunis 2092, Tunisia.

The viability of using fibers as reinforcement material for developing lightweight sustainable non-structural construction materials in compliance with the valorization of local by-products has been investigated in this work. This study aims to investigate the effect of the chemical treatment of fibers on the mechanical and hygric properties of bio-sourced clay-sand- fiber composite. This lightweight specimen has been produced from a mixture of 60% natural clay and 40% sand by mass, as a matrix, and reinforced with different amounts of Juncus fibers.

View Article and Find Full Text PDF

Co-Flocculation of Mixed-Sized Colloidal Particles in Aqueous Dispersions Under a DC Electric Field.

Materials (Basel)

December 2024

Department of Chemistry and Biomolecular Science, Faculty of Engineering, Gifu University, Gifu 501-1193, Japan.

When an electric field is applied to or removed from colloidal particle aqueous dispersions, a reversible increase in sedimentation velocity of the colloidal particles, referred to as the Electrically Induced Rapid Separation (ERS) effect, is observed. While electrophoresis and other interfacial electrokinetic phenomena under applied electric fields are well-studied, the phenomena of particle aggregation and re-dispersion caused by the application and removal of the field remain largely unexplored despite their significance. Experiments using mixed aqueous dispersions of poly (methyl methacrylate) (PMMA) particles of different sizes revealed that applying an electric field induced the formation of co-flocs involving both large and small particles, significantly enhancing the sedimentation velocity.

View Article and Find Full Text PDF

Effect of Strengthening Mechanism of Alkali Curing on Mechanical Properties of Fly Ash Lightweight Aggregates and Its Concrete.

Materials (Basel)

December 2024

Jiangsu Key Laboratory Environmental Impact and Structural Safety in Engineering, China University of Mining and Technology, Xuzhou 221116, China.

The low hydration degree of fly ash in Fly Ash Unburned Lightweight Aggregate (FULA) is not conducive to the development of the mechanical properties of lightweight aggregates and their concrete. In this paper, FULA was immersed in an alkaline solution with the purpose of improving the mechanical properties of FULA and its concrete. Firstly, FULA was prepared using fly ash as the main raw material.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!