Transport and fate of aqueous film forming foam in an urban estuary.

Environ Pollut

US Environmental Protection Agency, Office of Research and Development (ORD), Center for Measurement and Modeling (CEMM), Atlantic Coastal Ecosystem Sciences Division (AED), 27 Tarzwell Drive, Narragansett, RI, 02882, USA.

Published: May 2022

The deployment of aqueous film forming foams (AFFF) used for firefighting during emergencies and training often releases per- and polyfluoroalkyl substances (PFAS) into the environment. In October 2018, first responders in Providence, RI, USA applied an AFFF during a fuel spill. Due to the proximity of the incident to the upper reaches of Narragansett Bay (NB), an unknown quantity of gasoline and AFFF entered the estuary via surface runoff and stormwater drains. Water samples near the spill were collected approximately 15 h after the incident and analyzed for 24 PFAS. Minor increases in measured PFAS concentrations were observed relative to pre- and post-spill samples at monitoring sites near the incident, except 6:2-fluorotelomer sulfonate (6:2-FTS) that peaked post-spill (max 311 ng/L). After performing the total oxidizable precursor (TOP) assay on water samples and the AFFF concentrate, significant increases in perfluorocarboxylic acids (PFCAs) were observed. One compound, 6:2 fluorotelomer mercaptoalkylamido sulfonate (6:2-FTSAS), was identified as a major component of the AFFF used. Peak areas of 6:2-FTSAS and the degradation product 6:2-FTSAS-sulfoxide corresponded to observed increases in the TOP assay results and were useful as tracers of AFFF in surrounding waters. Elevated levels of PFAS at the time of sampling were limited to a confined area of the Providence River due to river flow and tidal action. Observed concentrations were also compared to hydrodynamic model results, and results confirmed rapid dissipation of AFFF components with distance from the spill. However, modeled results did not capture possible secondary releases of AFFF from local municipal stormwater and sewer infrastructure, as observational data suggest. The multiple lines of evidence of PFAS present in surface waters permitted a better assessment of the potential environmental impacts from products such as AFFF for which the chemical composition is largely unknown.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC8924856PMC
http://dx.doi.org/10.1016/j.envpol.2022.118963DOI Listing

Publication Analysis

Top Keywords

afff
9
aqueous film
8
film forming
8
water samples
8
top assay
8
pfas
5
transport fate
4
fate aqueous
4
forming foam
4
foam urban
4

Similar Publications

Per- and polyfluoroalkyl substances (PFAS) are widely used persistent synthetic chemicals that have been linked to adverse health effects. While the behavior of PFAS has been evaluated in the environment, our understanding of reaction products in mammalian systems is limited. This study identified biological PFAS transformation products and generated mass spectral libraries to facilitate an automated search and identification.

View Article and Find Full Text PDF

Characterization of PFAS residuals: A case study on PFAS content in a firefighting foam delivery system of an aircraft rescue and firefighting vehicle.

Chemosphere

December 2024

Arcadis G&M of North Carolina, Inc., 175 Regency Woods Place, Suite 400, Cary, NC, 27518, USA. Electronic address:

When fire suppression systems that held aqueous film forming foams (AFFF) are transitioned to per- and polyfluoroalkyl substance (PFAS)-free firefighting formulations, PFAS can dissolve from the wetted surfaces of the systems and release into the new firefighting formulations. The overall objective of this work was to characterize PFAS residual mass on the wetted surfaces of aircraft rescue and firefighting (ARFF) vehicle on-board fire suppression system components from the water, mixed fire water, and foam concentrate systems with various geometries, materials of construction, and locations within the fire suppression system. The ARFF vehicle components were dismantled from the system after a triple water rinse procedure which removed 19,600 mg total measured PFAS post-TOP assay from the foam concentrate system and 23 mg total measured PFAS post-TOP assay from the water system.

View Article and Find Full Text PDF

Assessing the efficacy of the Plasma Spinning Disc Reactor (PSDR) in treating undiluted Aqueous Film Forming Foams (AFFFs).

J Hazard Mater

December 2024

Department of Chemical and Biomolecular Engineering, 8 Clarkson Avenue, Clarkson University, Potsdam, NY 13699, USA. Electronic address:

This work used pulsed electrical discharge plasma to treat undiluted Aqueous Film Forming Foam (AFFF) solution that contained significant quantities of per- and polyfluoroalkyl substances (PFAS). The plasma was generated within a plasma spinning disc reactor (PSDR), which utilizes the electric breakdown of argon gas to create plasma over a thin liquid film generated on a spinning disc. The PSDR performance toward degradation of AFFF constituents such as fluorotelomers, perfluorinated C-C alkyl acids, and unidentified precursors was investigated.

View Article and Find Full Text PDF

The environmental fate of per- and polyfluoroalkyl substances (PFAS) in aqueous film-forming foams (AFFFs), especially those synthesized by electrochemical fluorination (ECF) processes, remains largely unknown. This study evaluated the transformation of AFFF-derived ECF-based precursors in aerobic soil microcosms amended with a historically used AFFF formulation (3M Light Water). Fifteen classes of PFAS, including AFFF components and transformation products, were identified or tentatively identified by suspect screening/nontargeted analysis (SSA/NTA) throughout a 308-day incubation.

View Article and Find Full Text PDF

Zwitterionic, cationic, and anionic per- and polyfluoroalkyl substances (PFAS) were investigated in freshwater sediments of Canada, including sites impacted by aqueous film-forming foams (AFFFs). The first step of the project involved optimizing the extraction method with equilibrated sediment-water-AFFF samples. The analytical method had acceptable linearity, accuracy, and precision in the sediment matrix, and was further validated with NIST SRM 1936.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!