Single-dispersed polyoxometalate clusters embedded on multilayer graphene as a bifunctional electrocatalyst for efficient Li-S batteries.

Nat Commun

State Key Laboratory for Physical Chemistry of Solid Surfaces, Department of Chemistry, College of Chemistry and Chemical Engineering, iChem (Collaborative Innovation Center of Chemistry for Energy Materials), Innovation Laboratory for Sciences and Technologies of Energy Materials of Fujian Province (IKKEM), Xiamen University, Xiamen, Fujian, 361005, China.

Published: January 2022

The redox reactions occurring in the Li-S battery positive electrode conceal various and critical electrocatalytic processes, which strongly influence the performances of this electrochemical energy storage system. Here, we report the development of a single-dispersed molecular cluster catalyst composite comprising of a polyoxometalate framework ([Co(PWO)]) and multilayer reduced graphene oxide. Due to the interfacial charge transfer and exposure of unsaturated cobalt sites, the composite demonstrates efficient polysulfides adsorption and reduced activation energy for polysulfides conversion, thus serving as a bifunctional electrocatalyst. When tested in full Li-S coin cell configuration, the composite allows for a long-term Li-S battery cycling with a capacity fading of 0.015% per cycle after 1000 cycles at 2 C (i.e., 3.36 A g). An areal capacity of 4.55 mAh cm is also achieved with a sulfur loading of 5.6 mg cm and E/S ratio of 4.5 μL mg. Moreover, Li-S single-electrode pouch cells tested with the bifunctional electrocatalyst demonstrate a specific capacity of about 800 mAh g at a sulfur loading of 3.6 mg cm for 100 cycles at 0.2 C (i.e., 336 mA g) with E/S ratio of 5 μL mg.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC8752791PMC
http://dx.doi.org/10.1038/s41467-021-27866-5DOI Listing

Publication Analysis

Top Keywords

bifunctional electrocatalyst
12
li-s battery
8
sulfur loading
8
e/s ratio
8
li-s
5
single-dispersed polyoxometalate
4
polyoxometalate clusters
4
clusters embedded
4
embedded multilayer
4
multilayer graphene
4

Similar Publications

The development of high-performance bifunctional single-atom catalysts for use in applications, such as zinc-air batteries, is greatly impeded by mild oxygen reduction and evolution reactions (ORR and OER). Herein, we report a bifunctional oxygen electrocatalyst designed to overcome these limitations. The catalyst consists of well-dispersed low-nuclearity Co clusters and adjacent Co single atoms over a nitrogen-doped carbon matrix (Co/NC).

View Article and Find Full Text PDF

Grain-Boundary-Rich Pt/CoO Nanosheets for Solar-Driven Overall Water Splitting.

Inorg Chem

December 2024

Wenzhou Key Lab of Advanced Energy Storage and Conversion, Zhejiang Province Key Lab of Leather Engineering, College of Chemistry and Materials Engineering, Wenzhou University, Wenzhou, Zhejiang 325035, China.

Interfacial engineering is considered an effective strategy to improve the electrochemical water-splitting activity of catalysts by modulating the local electronic structure to expose more active sites. Therefore, we report a platinum-cobaltic oxide nanosheets (Pt/CoO NSs) with plentiful grain boundary as the efficient bifunctional electrocatalyst for water splitting. The Pt/CoO NSs exhibit a low overpotential of 55 and 201 mV at a current density of 10 mA cm for the hydrogen evolution reaction and oxygen evolution reaction in 1.

View Article and Find Full Text PDF

Designing Ru-B-Cr Moieties to Activate the Ru Site for Acidic Water Electrolysis under Industrial-Level Current Density.

Nano Lett

December 2024

Alan G. MacDiarmid Institute, College of Chemistry, Jilin University, 2699 Qianjin Street, Changchun 130012, P. R. China.

Developing highly efficient non-iridium-based active sites for acidic water splitting is still a huge challenge. Herein, unique Ru-B-Cr moieties have been constructed in RuO nanofibers (NFs) to activate Ru sites for water electrolysis, which overcomes the bottleneck of RuO-based catalysts usually possessing low activity for the hydrogen evolution reaction (HER) and poor stability for the oxygen evolution reaction (OER). The fabricated Cr, B-doped RuO NFs exhibit low overpotentials of 205 and 379 mV for acidic HER and OER at 1 A cm with outstanding stability lasting 1000 and 188 h, respectively.

View Article and Find Full Text PDF

The active site density, intrinsic activity, and supporting substrate of cobalt phosphide catalysts are vital to their performance in alkaline water electrolysis. In this work, a CoP/CoP loaded on cellulose nanofiber-derived carbon aerogels (CP/CCAs) bifunctional electrocatalyst with a three-dimensional network and heterostructure is illustrated through sequential facile hydrothermal, freeze-drying, and phosphorylation processes. The three-dimensional network of carbon aerogels derived from cellulose nanofibers reveals a specific surface area of 183.

View Article and Find Full Text PDF

Electrocatalyst materials play a crucial role in determining the efficiency of the hydrogen evolution reaction (HER), directly influencing the overall effectiveness of energy conversion technologies. NiS/MoS heterostructures hold substantial promise as bifunctional catalysts, owing to their synergistic electronic characteristics and plentiful active sites. However, their catalytic efficacy is impeded by the relatively elevated chemisorption energy of hydrogen-containing intermediates, which constrains their functionality in different pH environments.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!