Introduction: The objective of this investigation was to evaluate the effects of high-intensity light-emitting diode (LED) light from a curing device on the retinas of Wistar rats.

Methods: Six male Wistar rats were used, and their ocular structures were the focus of this study. During the photostimulation of each animal, the right eye of the animal, considered the control sample, was covered with a removable polyvinyl chloride cap, and the contralateral eye, the experimental sample, was exposed to high-intensity LED light, 3200 mW/cm (VALO Ortho; Ultradent Products, South Jordan, Utah) for 144 seconds from a distance of 30 cm. The animals were exposed to the LED light 3 times on the same day to investigate if any acute inflammatory changes in the retina occurred. Seven days after the photostimulation sessions, the animals were anesthetized and perfused with paraformaldehyde solution. After which, the eyes were resected and processed histologically. The histologic sections were analyzed stereologically and histomorphometrically to measure the parameters of the retina under investigation.

Results: There was a statistically significant increase in total retinal volume in the experimental group because of the increased volume of the ganglion cell layers, inner plexiform layers, outer nuclear layers, and the cone and rod extensions. There was no statistically significant difference in terms of density. However, there was a statistically significant increase in the nuclear area of the cells in all the studied layers in the group exposed to high-intensity LED light. In addition, hyperchromatic cells that are suggestive of pyknosis were observed.

Conclusions: An acute but short protocol of exposure of high-intensity LED light to the eye caused morphometric alterations in the retinal structures, specifically in the nuclear area of the photosensitive cells.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.ajodo.2021.01.026DOI Listing

Publication Analysis

Top Keywords

led light
20
high-intensity led
12
high-intensity light-emitting
8
light-emitting diode
8
exposed high-intensity
8
statistically increase
8
nuclear area
8
high-intensity
5
led
5
light
5

Similar Publications

Advanced technologies in InGaN micro-LED fabrication to mitigate the sidewall effect.

Light Sci Appl

January 2025

Advanced Semiconductor Laboratory, Electrical and Computer Engineering Program, CEMSE Division, King Abdullah University of Science and Technology (KAUST), Thuwal, 23955-6900, Kingdom of Saudi Arabia.

The size of InGaN micro-LEDs is continuously decreasing to meet the demands of various emerging applications, especially in tiny micro-displays such as AR/VR. However, the conventional pixel definition based on plasma etching significantly damages the mesa sidewalls, leading to a severe reduction in efficiency as the micro-LED size decreases. This seriously impedes the development and application of micro-LEDs.

View Article and Find Full Text PDF

An optogenetic mouse model of hindlimb spasticity after spinal cord injury.

Exp Neurol

January 2025

Brain and Mind Research Institute, Department of Biology, University of Ottawa, Ottawa, Ontario, Canada. Electronic address:

Spasticity is a common comorbidity of spinal cord injury (SCI), disrupting motor function and resulting in significant discomfort. While elements of post-SCI spasticity can be assessed using pre-clinical SCI models, the robust measurement of spasticity severity can be difficult due to its periodic and spontaneous appearance. Electrical stimulation of sensory afferents can elicit spasticity-associated motor responses, such as spasms; however, placing surface electrodes on the hindlimbs of awake animals can induce stress or encumbrance that could influence the expression of behaviour.

View Article and Find Full Text PDF

Physical vapor deposition is widely used in the fabrication of organic light-emitting diodes and has the potential to adjust the density and orientation through substrate temperature control, which may lead to enhanced electrical performance. However, it is unclear whether this enhanced property is because of the horizontal molecular orientation or the increased density. The effects of the density and orientation on the electrical properties of a potential electron transport material, (3-dibenzo[c,h]acridin-7-yl)phenyl)diphenylphosphine oxide (TPPO-dibenzacridine), were investigated.

View Article and Find Full Text PDF

Amphotericin B Encapsulation in Polymeric Nanoparticles: Toxicity Insights via Cells and Zebrafish Embryo Testing.

Pharmaceutics

January 2025

Programa de Pós-Graduação em Pesquisa Translacional em Fármacos e Medicamentos (PPG-PTFM), Fundação Oswaldo Cruz (Fiocruz), Rio de Janeiro 21040-900, Brazil.

Amphotericin B (AmB) is a commonly utilized antifungal agent, which is also recommended for the treatment of certain neglected tropical diseases, including leishmaniasis. However, its clinical application is constrained because of its poor oral bioavailability and adverse effects, prompting the investigation of alternative drug delivery systems. Polymeric nanoparticles (PNPs) have gained attention as a potential drug delivery vehicle, providing advantages such as sustained release and enhanced bioavailability, and could have potential as AmB carriers.

View Article and Find Full Text PDF

The effectiveness of ultraviolet-C light-emitting diodes (UVC LEDs) is currently limited by the lack of suitable encapsulation materials, restricting their use in sterilization, communication, and in vivo cancer tumor inhibition. This study evaluates various silicone oils for UVC LED encapsulation. A material aging experiment was conducted on CF1040 (octamethylcyclotetrasiloxane), HF2020 (methyl hydro polysiloxanes), and MF2020-1000 (polydimethylsiloxane) under UVC radiation for 1000 h.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!