Solid fuel use is the main source of indoor air pollution, especially in rural areas of developing countries. Nevertheless, the evidence linking indoor solid fuel use and renal function is very limited. Therefore, we investigated the association between indoor solid fuel use and renal function among middle-aged and older adults in rural China. Cystatin C (CysC) concentration of each participant was used to calculate the estimated glomerular filtration rate (eGFR). We used the baseline data to investigate the associations between solid fuel use for cooking and heating and eGFR through a linear-mixed effects model. Then, we applied the generalized linear-mixed effects model with binary distribution to examine the relationship between renal function decline and cooking fuel switching from 2011 to 2015. A total of 4959 participants were included at baseline, and 3536 participants were included in the follow-up analysis. Compared to participants who used clean fuel for both cooking and heating, the eGFR was significantly lower among participants who cooked with solid fuel and heated with clean fuel (β: -2.81; 95% CI: -5.53, -0.09). In the follow-up analysis, the risks of renal function decline for participants using solid fuel for cooking were significantly higher in males (OR: 2.74; 95% CI: 1.68, 4.49), smokers (OR: 5.70; 95% CI: 2.82, 11.55), and drinkers (OR: 7.11; 95% CI: 3.15, 16.02) compared to females, non-smokers, and non-drinkers. Moreover, 45-65 years aged participants (OR: 0.54; 95% CI: 0.33, 0.89) and non-drinkers (OR: 0.61; 95% CI: 0.41, 0.92) who switched from solid to clean cooking fuel had a lower risk of renal function decline. In conclusion, our findings show that household solid fuel use is likely to be an important risk factor for renal function decline in rural China. And switching to cleaner fuel may provide significant public health benefits.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1016/j.envres.2021.112588 | DOI Listing |
Small
January 2025
Institute of Chemical Materials, China Academy of Engineering Physics, Mianyang, 621999, China.
The combustion efficiency and reactivity of aluminum (Al) particles, as a crucial component in solid propellants, are constrained by the inert oxide layer aluminum oxide (AlO). Polytetrafluoroethylene (PTFE) can remove the oxide layer, however, carbon deposition generated during the reaction process still limits the reaction efficiency of Al/PTFE fuel. Here, a litchi-like Al/PTFE fuel with the nano-PTFE islands distributed on the Al particles surface is successfully designed, based on localized activation and synergistic reaction strategies, to solve the AlO layer and carbon deposition.
View Article and Find Full Text PDFChemosphere
January 2025
Institute of Chemical Engineering Sciences, Foundation for Research and Technology Hellas (FORTH/ICE-HT), 26504, Patras, Greece. Electronic address:
The goal of the present work is to quantify the performance of ozonation as a method for the in situ remediation of soils polluted at varying degree with different types of hydrocarbons, and assess its applicability, in terms of remediation efficiency, cost factors, and environmental impacts. Ozonation tests are conducted on dry soil beds, for three specific cases: sandy soil contaminated with low, moderate and high concentration of a non-aqueous phase liquid (NAPL) consisting of equal concentrations of n-decane, n-dodecane, and n-hexadecane; sandy soil polluted with diesel fuel; oil-drilling cuttings (ODC). The transient changes of the concentration of the total organic carbon (TOC), total petroleum hydrocarbons (TPH), polycyclic aromatic hydrocarbons (PAHs), and soluble chemical oxygen demand (SCOD) in soil and carbon dioxide (CO), carbon monoxide (CO), volatile organic compounds (VOCs), and ozone (O) in exhaust gases are recorded.
View Article and Find Full Text PDFMolecules
January 2025
Guangdong Provincial Key Laboratory of Fuel Cell Technology, School of Chemistry and Chemical Engineering, South China University of Technology, Guangzhou 510641, China.
Solid polymer electrolytes (SPEs) have attracted much attention due to their excellent flexibility, strong interfacial adhesion, and good processibility. However, the poor interfacial contact between the separate solid polymer electrolytes and electrodes leads to large interfacial impedance and, thus, hinders Li transport. In this work, an ionic liquid-modified comb-like crosslinked network composite solid-state electrolyte with an integrated electrolyte/cathode structure is prepared by in situ ultraviolet (UV) photopolymerization.
View Article and Find Full Text PDFInt J Environ Res Public Health
January 2025
Environmental Epidemiology Team, Radiation, Chemical and Environmental Hazards Directorate, UK Health Security Agency (UKHSA), Didcot OX11 0RQ, UK.
Carbon monoxide (CO) is a toxic gas, and faulty gas appliances or solid fuel burning with incomplete combustion are possible CO sources in households. Evaluating household CO exposure models and measurement studies is key to understanding where CO exposures may result in adverse health outcomes. This assists the assessment of the burden of disease in high- and middle-income countries and informs public health interventions in higher-risk environments.
View Article and Find Full Text PDFSci Rep
January 2025
Department of Electrical Engineering, Faculty of Engineering, Mansoura University, Mansoura, Egypt.
The current study uses the Chernobyl disaster optimizer (CDO), a new metaheuristic optimizer, to identify the seven unknown parameters of solid oxide fuel cells (SOFCs). The procedures of the CDO is based on physical behavior of the elaborated radiations from the well-known Chernobyl disaster according to their mass, speed, frequency, and degree of ionization. The sum of square errors (SMSE) among the estimated and the real measured output voltage datasets of SOFCs is minimized employing the CDO.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!