Water pollution has always been a serious problem across the world; therefore, facile pollutant degradation via light irradiation has been an attractive issue in the field of environmental protection. In this study, a type of Zn-based metal-organic framework (ZIF-8)-wrapped BiVO nanorod (BiVO@ZIF-8) with high efficiency for photocatalytic wastewater treatment was synthesized through a two-step hydrothermal method. The heterojunction structure of BiVO@ZIF-8 was confirmed by morphology characterization. Due to the introduction of mesoporous ZIF-8, the specific surface area reached up to 304.5 m/g, which was hundreds of times larger than that of pure BiVO nanorods. Furthermore, the band gap of BiVO@ZIF-8 was narrowed down to 2.35 eV, which enabled its more efficient utilization of visible light. After irradiation under visible light for about 40 min, about 80% of rhodamine B (RhB) was degraded, which was much faster than using pure BiVO or other BiVO-based photocatalysts. The synergistic photocatalysis mechanism of BiVO@ZIF-8 is also discussed. This study might offer new pathways for effective degradation of wastewater through facile design of novel photocatalysts.
Download full-text PDF |
Source |
|---|---|
| http://www.ncbi.nlm.nih.gov/pmc/articles/PMC8658979 | PMC |
| http://dx.doi.org/10.3390/ma14237424 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Co-Atomic Interface Minimizing Charge Transfer Barrier in Polytypic Perovskites for CO Photoreduction.
Adv Sci (Weinh)
January 2025
School of Resources and Environment, University of Electronic Science and Technology of China, Chengdu, 611731, China.
Heterojunctions, known for their decent separation of photo-generated electrons and holes, are promising for photocatalytic CO reduction. However, a significant obstacle in traditional post-assembled heterojunctions is the high interfacial barrier for charge transfer caused by atomic lattice mismatch at multiphase interfaces. Here, as research prototypes, the study creates a lattice-matched co-atomic interface within CsPbBr-CsPbBr polytypic nanocrystals (113-125 PNs) through the proposed in situ hybrid strategy to elucidate the underlying charge transfer mechanism within this unique interface.
View Article and Find Full Text PDFPhotoexcited CuO/TiO Heterojunction for Photoelectrochemical Sensors for Nonenzymatic Glucose Detection.
Langmuir
January 2025
Department of Bioinformatics and Medical Engineering, Asia University, Taichung 413305, Taiwan.
Photoelectrochemical sensors have been studied for glucose detection because of their ability to minimize background noise and unwanted reactions. Titanium dioxide (TiO), a highly efficient material in converting light into electricity, cannot utilize visible light. In this regard, we developed a nonenzymatic glucose sensor by using a simple one-step electrospinning technique to combine cupric oxide with TiO to create a heterojunction.
View Article and Find Full Text PDFPhotocatalytic CO reduction of Ag/AgS/TiCT heterojunctions with enhanced interfacial charge transfer.
Nanoscale Adv
December 2024
Key Laboratory of Jiangxi Province for Persistent Pollutants Control and Resources Recycle, Nanchang Hangkong University Nanchang 330063 P. R. China.
Photocatalytic reduction of CO to produce organic fuels is a promising strategy for addressing carbon reduction and energy scarcity. Transition metal carbides (TiCT ) are of particular interest due to their unique layered structures and excellent electrical conductivity. However, the practical application of TiCT is limited by the poor separation efficiency of photogenerated charge carriers and the low migration ability of photogenerated electrons.
View Article and Find Full Text PDFDMSO-Assisted Control Enables Highly Efficient 2D/3D Hybrid Perovskite Solar Cells.
Small
January 2025
State Key Laboratory of Silicon and Advanced Semiconductor Materials, Department of Polymer Science and Engineering, Zhejiang University, Hangzhou, 310058, P. R. China.
Building 2D/3D heterojunction is a promising approach to passivate surface defects and improve the stability of perovskite solar cells (PSCs). Developing effective methods to build high-quality 2D/3D heterojunction is in demand. The formation of 2D/3D heterojunction involves both the diffusion of 2D spacer molecules and phase transition from 3D to 2D structure.
View Article and Find Full Text PDFAdvanced Dual-Mode Microfluidic Sensing Platform Based on Amphiphilic Polymer-Capped Perovskite Nanozymes Induced Photoelectrochemical Signal Amplification and Fluorescence Emission.
Anal Chem
January 2025
School of Chemistry and Chemical Engineering, Shandong University, Jinan 250100, China.
A novel dual-mode microfluidic sensing platform integrating photoelectrochemical (PEC) and fluorescence (FL) sensors was developed for the sensitive monitoring of heart fatty acid binding protein (h-FABP). First, BiVO/AgInS (BVAIS) composites with excellent photoelectric activity were synthesized as sensing matrices. The BVAIS heterojunction with a well-matched internal energy level structure provided a stable photocurrent.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!