Aim: To determine whether collagen membrane (CM) fixation enhances guided bone regeneration in standardized defects.
Materials And Methods: Four 8-mm-diameter defects were surgically made in eight rabbit calvaria, and randomly allocated into four groups: control (empty), unfixed-CM, fixed-CM, and unfixed-CM with bone graft (BG + CM) (positive control). After 1- and 4-week healing periods, the animals were sacrificed and quantitative reverse transcription polymerase chain reaction, micro-computed tomography, and histological outcomes were assessed.
Results: At week 1, the expression levels of BMP-2, FGF-2, VEGF, and osteocalcin were significantly higher in the fixed-CM group than in the unfixed-CM and control groups (p < .05). Conversely, cathepsin-K was significantly expressed in the unfixed-CM group. No significant differences in expression markers were observed between the fixed-CM and BG + CM groups (p > .05). At week 4, new bone formation was significantly higher in the fixed-CM group than the unfixed-CM and control groups (p < .05), but similar to the BG + CM group (p > .05).
Conclusions: CM fixation enhances the expression of osteogenic factors similar to BG + CM, leading to significantly more new bone formation. This suggests that the osteogenic potential is greater when membranes are fixed, thereby limiting the necessity of membrane-supporting materials to enhance bone formation.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1111/jcpe.13583 | DOI Listing |
Eur J Trauma Emerg Surg
January 2025
AO Research Institute Davos, Davos, Switzerland.
Background: Digitally Enhanced Hands-on Surgical Training (DEHST) platform was introduced to overcome the lack of training capabilities for the challenging task of freehand distal interlocking of intramedullary nails. It demonstrates high perceived realism for surgeons, and novices perform significantly better after DEHST training. However, characterization of how performance improves remained unexplored.
View Article and Find Full Text PDFClin Biomech (Bristol)
January 2025
Ohio State University Wexner Medical Center, Department of Orthopaedics, Columbus, OH, USA. Electronic address:
Background: Low back pain affects over 80 % of adults, with sacroiliac joint dysfunction accounting for 15-30 % of these cases. Sacroiliac fusion is a surgical procedure for refractory joint pain. While the biomechanics of the joint and its fusion relative to the spinal column are well-known, the hip-spine relationship post-fusion remains unclear.
View Article and Find Full Text PDFArch Orthop Trauma Surg
January 2025
Department of Orthopedics and Traumatology, University Medical Center Mainz, Mainz, Germany.
Iliosacral screw osteosynthesis is a widely recognized technique for stabilizing unstable posterior pelvic ring injuries, offering notable advantages, including enhanced mechanical stability, minimal invasiveness, reduced blood loss, and lower infection rates. However, the procedure presents technical challenges due to the complex anatomy of the sacrum and the proximity of critical neurovascular structures. While conventional fluoroscopy remains the primary method for intraoperative guidance, precise preoperative planning using multiplanar reconstructions and three-dimensional volume rendering is crucial for ensuring accurate placement of iliosacral or transsacral screws.
View Article and Find Full Text PDFNeuromodulation
January 2025
Division of Gastroenterology and Hepatology, University of Michigan School of Medicine, Ann Arbor, MI, USA. Electronic address:
Objectives: Gastrointestinal (GI) disturbance is a frequent complication in patients with thoracolumbar vertebral fracture (TVF). Transcutaneous electrical acustimulation (TEA) has been reported to effectively accelerate postoperative GI function recovery after abdominal surgery. This study aimed to investigate the effects of TEA on postoperative recovery and the associated mechanisms.
View Article and Find Full Text PDFInorg Chem
January 2025
Key Laboratory of Green and Precise Synthetic Chemistry and Applications, Ministry of Education, Huaibei Normal University, Huaibei, Anhui 235000, P. R. China.
Improving catalytic performance by controlling the microstructure of materials has become a hot topic in the field of photocatalysis, such as the surface defect site, multistage layered morphology, and exposed crystal surface. Due to the differences in the metal atomic radius (Mn and Cd) and solubility product constant (MnS and CdS), Mn defect easily occurred in the S/MnCdS (S/0.4MCS) composite.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!