The aim of this study was to reveal the macroscopic and mesoscopic deterioration behaviors of concrete under the coupling effect of chlorine salt erosion and the freezing-thawing cycle. The rapid freezing-thawing test was carried out in a 5% chlorine salt environment. The macroscopic characteristics of concrete were analyzed by testing the mass, the relative dynamic modulus of elasticity, and the compressive strength of concrete under different freezing-thawing cycles. Using CT scanning technology and three-dimensional reconstruction technology, the pore structure, CT value, and surface deviation of concrete before and after freezing-thawing were analyzed. Based on the changes of solid volume, pore volume, and solid CT value of concrete, the calculation method of relative CT value was proposed, and the damage model was established with relative CT value as the damage variable. The results demonstrate that the mass loss rate decreases in the beginning and then increases in the process of chlorine salt erosion and freezing-thawing, and the smaller the concrete size, the greater the mass loss rate. The relative dynamic modulus of elasticity decreases gradually, slowly at the initial stage and then at a faster rate, and the compressive strength loss rate increases gradually. The pore quantity, porosity, and volume loss rate of concrete increase in a fluctuating manner, whereas the relative CT value decreases. The comprehensive analysis shows that the chlorine salt frost resistance of concrete is negatively related to the water-cement ratio when the freezing-thawing cycle is fixed. The damage model could better reflect the freezing-thawing damage degree of concrete with different water cement ratios, and the damage evolution process is well described by the Weibull function.
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC8585147 | PMC |
http://dx.doi.org/10.3390/ma14216471 | DOI Listing |
ACS Omega
January 2025
School of Chemistry, University of Southampton, Southampton SO17 1BJ, United Kingdom.
Seventeen 3-alkylaminoquinoxaline-2(1)-thiones and 3-alkyloxyquinoxaline-2(1)-thiones were prepared by a novel thionation protocol from the readily available quinoxaline-2,3-dione in excellent overall yields. This protocol starts with the chlorination of dione using thionyl chloride to give 2,3-dichloroquinoxaline followed by the reaction with equimolar amounts of -nucleophiles (primary amines and secondary amines) or -nucleophiles (phenols and alcohols) to principally afford 2-alkanamino-3-chloroquinoxalines or 2-alkyloxy-3-chloroquinoxalines, respectively. The chloroquinoxalines reacted with the thionation reagent -cyclohexyl dithiocarbamate cyclohexyl ammonium salt in ethanol under reflux to principally give the corresponding quinoxalin-2-yl cyclohexylcarbamodithioate that finally rearranges to give the corresponding thiones in 76-93% overall yields.
View Article and Find Full Text PDFJ Hazard Mater
January 2025
School of Earth and Environmental Sciences, Seoul National University, Seoul 08826, South Korea. Electronic address:
Chlorinated ethenes are prevalent contaminants in industrial wastewater that detrimentally affect human health. As elevated tetrachloroethene (PCE) concentrations (18.0-18.
View Article and Find Full Text PDFAnal Methods
January 2025
Department of Chemistry, Universidade Federal de Santa Catarina, Florianópolis, SC, 88035-972, Brazil.
A new analytical method was developed for the determination of 14 multiclass emerging organic contaminants in surface waters using LC-MS, and Dispersive Liquid-Liquid Microextraction (DLLME) for extraction. Different Natural Deep Eutectic Solvents (NADESs) composed of terpenes and organic acids were tested as extraction solvents and characterized by Fourier Transform Infrared Spectroscopy (FTIR), Hydrogen Nuclear Magnetic Resonance Spectroscopy (H-NMR), Differential Scanning Calorimetry (DSC), Thermogravimetric Analysis (TGA), density, and viscosity, eliminating the need to use traditional chlorinated solvents. NADES produced with butyric acid and thymol showed the best results and was selected for application for the first time in the extraction of emerging organic contaminants of different classes in water samples.
View Article and Find Full Text PDFACS Appl Mater Interfaces
January 2025
Department of Environmental Engineering, Seoul National University of Science and Technology, Seoul 01811, Republic of Korea.
Trichloroethylene (TCE) is widely used in various industrial applications, leading to significant environmental and public health concerns due to its toxicity and persistence. Current nonthermal liquid-phase TCE treatment methods, including electrochemical processes, typically produce liquid byproducts that require additional separation steps, limiting their efficiency. To overcome these challenges, this study introduces an innovative electrochemical approach for the direct conversion of TCE gas into less harmful gaseous products, utilizing a Cu/Ni alloy 3D foam electrode integrated with a poly(vinyl alcohol) (PVA)-sodium polyphosphate (SPP) gel membrane system.
View Article and Find Full Text PDFMaterials (Basel)
December 2024
School of Metallurgy and Energy Engineering, North China University of Science and Technology, Tangshan 063000, China.
The composition of TBFS is complex. It is categorized into low (W < 5%), medium (5% < W < 20%), and high-titanium slag (W > 20%) based on Ti content. The titanium in the slag is underutilized, causing it to accumulate and contribute to environmental pollution.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!