Activated carbons were prepared from different Amazonian fruit waste-derived biomass residues from the Amazon to store CO at low pressure. The samples were carbonized in under flowing N flow atmosphere and activated with KOH. The carbon materials obtained were physically and structurally characterized by the analysis of N isotherms for textural characterization, X-ray fluorescence (XRF), ash content, X-ray diffraction (XRD), Raman spectroscopy, scanning electron microscopy (SEM), and applied for CO adsorption. Temperature programmed desorption (TPD), the isosteric heat were also calculated. The values of the specific surface area (S) ranged from 1824 to 2004 m/g, and the total pore volume varied between 0.68 and 0.79 cm/g. These results confirm that the obtained activated carbons are microporous materials. The highest CO adsorption under the pressure of 1 bar was achieved in activated carbon derived from andiroba seeds ANKO1, the adsorption of carbon dioxide at 1 bar was being 7.18 and 4.81 mmol/g at 273 K and 298 K, respectively. As a result, the most important factor in the preparation of activated carbon for CO capture is primarily rich in extremely the high amount of small micropores.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.wasman.2021.10.025DOI Listing

Publication Analysis

Top Keywords

activated carbon
12
fruit waste-derived
8
waste-derived biomass
8
activated carbons
8
activated
6
carbon
5
conversion fruit
4
biomass highly
4
highly microporous
4
microporous activated
4

Similar Publications

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!