Carbohydrate degradation contributes to the main bioheat generation during kitchen waste biodrying process: A pilot study.

Waste Manag

Institute of Environment Science and Technology, College of Environmental and Resource Sciences, Zhejiang University, Hangzhou 310058, PR China; Zhejiang Province Key Laboratory for Water Pollution Control and Environmental Safety Technology, Zhejiang 310058, PR China. Electronic address:

Published: January 2022

Biodrying is a promising method for processing kitchen waste (KW) with high moisture content into reusable solid recovered fuels (SRFs). During biodrying, a large amount of bioheat generated from biodegradation of biochemical components results in KW dehydration. However, the degradation rules of these components and their contribution to the bioheat in KW biodrying have not been systematically clarified. Here, a pilot experiment was performed to investigate the variations in biochemical components, hydrolase activities, and bioheat generation during three successive cycles of biodrying processes. Results showed that KW could be rapidly converted into SRFs with low calorific values of 6705-7062 kJ/kg and moisture content of 31.26%-35.21%. Analyses of hydrolase activities and mean fluorescence intensity suggested that the biodrying process pioneered the degradation of lipids and proteins in the warming stages, while carbohydrates (i.e. amylum, celluloses, etc.) underwent rapid decomposition in a large extent in the high-temperature and cooling stages. Carbohydrates with minimal difficulty in degradation, contributed 73.37%-89.92% to the total degradation mass and 59.23%-60.80% to the bioheat source during the three-cycle biodrying process. The generated bioheat was 4.32-4.56 times the amount of the theoretical heat used for water removal, indicating that internal bioheat could significantly enhance water evaporation and was sufficient for the expected water removal mass. Therefore, the evaluation of the main components to bioheat generation and its utilization efficiency makes a prominent contribution that can greatly clarify the conversion of KW biodrying into SRFs in order to efficiently promote renewable bioenergy and support the bioeconomy.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.wasman.2021.10.021DOI Listing

Publication Analysis

Top Keywords

bioheat generation
12
biodrying process
12
bioheat
8
kitchen waste
8
biodrying
8
moisture content
8
biochemical components
8
hydrolase activities
8
stages carbohydrates
8
water removal
8

Similar Publications

Objectives: This work highlights the methods used to develop a multi-pulse 1726 nm laser system combined with bulk air-cooling for selective sebaceous gland (SG) photothermolysis using thermal imaging and software algorithms. This approach enables treating to a desired tissue temperature and depth to provide a safe, effective, reproducible, and durable treatment of acne.

Methods: We designed and built a 1726 nm laser system with a 40 W maximum power output, a highly controlled air-cooling device, and a thermal camera in the handpiece, which permits real-time temperature monitoring of the epidermis.

View Article and Find Full Text PDF

Robust stochastic optimisation strategies for locoregional hyperthermia treatment planning using polynomial chaos expansion.

Phys Med Biol

January 2025

Radiation Oncology, Amsterdam UMC Location AMC, Meibergdreef 9, Amsterdam, Noord-Holland, 1105 AZ, NETHERLANDS.

Conventional temperature optimisation in Hyperthermia Treatment Planning aims to maximise tumour temperature (e.g., T90; the temperature reached in at least 90% of the tumour) while enforcing hard constraints on normal tissue temperature (max(Ttissue)≤45°C).

View Article and Find Full Text PDF

The heat transfer in skin tissues under the general two-temperature three-phase-lag model of heat conduction with a comparative study.

Heliyon

November 2024

Mechanical Engineering Department, College of Engineering and Architecture, Umm Al-Qura University, Makkah, 21955, Saudi Arabia.

In this paper, a new and more general model of heat conduction that depends on the drift velocity due to thermomass motion assumption will be established and will be applied to the skin tissue. Four different heat conduction models will be incorporated into a unified equation of heat conduction: the Pennes, Vernotte-Cattaneo, dual-phase-lag of Tzou, and the general two-temperature three-phase-lag of Youssef. The governing partial differential equations of the general two-temperature three-phase-lag model of bioheat conduction will be implemented and solved directly in the domain of the Laplace transformation.

View Article and Find Full Text PDF

Intracorporeal needle-based therapeutic ultrasound (NBTU) is a minimally invasive option for intervening in malignant brain tumors, commonly used in thermal ablation procedures. This technique is suitable for both primary and metastatic cancers, utilizing a high-frequency alternating electric field (up to 10 MHz) to excite a piezoelectric transducer. The resulting rapid deformation of the transducer produces an acoustic wave that propagates through tissue, leading to localized high-temperature heating at the target tumor site and inducing rapid cell death.

View Article and Find Full Text PDF

Laser corneal reshaping is a safe and effective technique utilized to treat common vision disorders. An advanced laser delivery system equipped with a pulsed UV laser with specific parameters is used to ablate parts of the cornea surface to correct the existing refractive error. The argon fluoride (ArF) excimer pulsed gas laser at 193 nm is the most employed type in the commercial devices for such treatments.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!