Fatty Acids Can Induce the Formation of Proteinaceous Particles in Monoclonal Antibody Formulations.

The presence of subvisible or visible particles in mAb formulations can pose significant challenges to pharmaceutical development as it can lead to reduced shelf life, batch rejection, and recalls. Among all type of particles, proteinaceous particles are the most concerning due to their potential role in immunogenicity. Nevertheless, the underlying mechanism for protein particle formation remains poorly understood. Past research highlighted the importance of interfaces and mechanical agitation in causing protein particle formation. Current research suggests that fatty acids, as impurities present in excipients or as a result of polysorbate degradation, can also induce protein assembly and promote particle formation. In this work, we assessed oleic and lauric acid for their impact on particle formation as each represents the main hydrolysis product of PS80 or PS20, respectively. It was found that co-existence of either fatty acids with 10 mg/mL mAb A can cause protein particles, with a similar morphology to those observed previously in mAb formulations. FTIR spectra showed that the particles are proteinaceous, heterogeneous in its composition, but contain corresponding fatty acids. Interestingly, it was found that oleic acid is significantly more effective in causing protein particles than lauric acid in these experiments. This suggests that PS20 containing formulations might have a lower likelihood to have protein particles compared to PS80 containing mAb formulations if hydrolysis of polysorbate were to occur. Lastly, the presence of 0.01% polysorbate in the mAb A formulation was able to fully mitigate the effect of fatty acids and reduce the protein particles significantly, suggesting a potential mechanism where interfacial action is involved. The present study can help to understand the root cause for protein particles in a mAb formulation where fatty acids are introduced because of polysorbate hydrolysis. With further work, it will help to shed light into product control strategy as well as design approaches for robust mAb products.