AI Article Synopsis

  • This study examined the effects of topical tranexamic acid (TXA) on gentamicin release from bone cement used in total joint arthroplasty without increasing complications.
  • Twelve bone cement cylinders were tested to compare the gentamicin release from those soaked in fetal calf serum alone versus those soaked in fetal calf serum with TXA over a week.
  • Results showed no significant difference in gentamicin concentration, antimicrobial activity, or compressive strength between the two soaking conditions, indicating that TXA does not compromise antibiotic effectiveness.

Article Abstract

Purpose: The topical application of tranexamic acid (TXA) into the joint space during total joint arthroplasty (TJA) with no increase of complications, has been widely reported. We investigated the influence of TXA on antibiotic release, activity of the released antibiotic against a clinical isolate of , and compressive strength of a widely used commercially prepared gentamicin-loaded cement brand (PALACOS R + G).

Method: 12 bone cement cylinders (diameter and height = 6 and 12 mm, respectively) were molded. After curing in air for at least 1 h, six of the cylinders were completely immersed in 5 mL of fetal calf serum (FCS) and the other six were completely immersed in a solution consisting of 4.9 mL of FCS and 0.1 mL (10 mg) of TXA. Gentamicin elution tests were performed over 7 d. Four hundred µL of the gentamicin eluate were taken every 24 h for the first 7 d without renewing the immersion fluid. The gentamicin concentration was determined in a clinical analyzer using a homogeny enzyme immuno-assay. The antimicrobial activity of the eluate, obtained after day 7, was tested. An agar diffusion test regime was used with . Bacteria were grown in a LB medium and plated on LB agar plates to get a bacterial lawn. Fifty µL of each eluate were pipetted on 12-mm diameter filter discs, which were placed in the middle of the agar gel. After 24 h of cultivation at 37 °C, the zone of inhibition (ZOI) for each specimen was measured. The compressive strength of the cements was determined per ISO 5833.

Results: At each time point in the gentamicin release test, the difference in gentamicin concentration, obtained from specimens immersed in the FCS solution only and those immersed in the FCS + TXA solution was not significant ( = 0.055-0.522). The same trend was seen in each of the following parameters, after 7 d of immersion: (1) Cumulative gentamicin concentration ( < 0.297); (2) gentamicin activity against (strongly visible); (3) ZOI size (mostly > 20 mm) ( = 0.631); and (4) compressive strength ( = 0.262).

Conclusions: For the PALACOS R + G specimens, the addition of TXA to FCS does not produce significant decreases in gentamicin concentration, in the activity of the gentamicin eluate against a clinical isolate of , the zone of inhibition of and in the compressive strength of the cement, after 7 d of immersion in the test solution.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC8510380PMC
http://dx.doi.org/10.3390/ma14195639DOI Listing

Publication Analysis

Top Keywords

compressive strength
20
gentamicin concentration
16
gentamicin
10
tranexamic acid
8
clinical isolate
8
completely immersed
8
fcs txa
8
gentamicin eluate
8
zone inhibition
8
immersed fcs
8

Similar Publications

Role of calcination process of natural colemanite powder on compressive strength property of concrete.

Heliyon

January 2025

Department of Civil Engineering, Faculty of Engineering and Architecture, Recep Tayyip Erdogan University, 53100, Rize, Turkey.

The use of boron minerals as an additive is important in terms of reducing CO emissions and providing input to the economy. Sustainable natural colemanite was subjected to calcination at 550 °C in order to concentrate the amount of BO. For the characterization of calcined mineral, XRD, TGA/DTA, and BO component tests were carried out.

View Article and Find Full Text PDF

Hierarchical Biogenic-Based Thermal Insulation Foam.

ACS Nano

January 2025

Department of Materials Science and Engineering, University of Maryland, College Park, Maryland 20742, United States.

Biogenic-based foam, renowned for its sustainable and eco-friendly properties, is emerging as a promising thermal insulating material with the potential to significantly enhance energy efficiency and sustainability in building applications. However, its relatively high thermal conductivity, large-pore configurations, and energy-intensive manufacturing processes hinder its widespread use. Here, we report on the scalable, one-pot synthesis of biogenic foams achieved by integrating recycled paper pulp and in situ nanoporous silica formation, resulting in a hierarchical structure comprising both micropores and nanopores.

View Article and Find Full Text PDF

Temperature dynamics and mechanical properties analysis of carbon fiber epoxy composites radiated by nuclear explosion simulated light source.

Sci Rep

January 2025

Engineering Research Center of Flexible Radiation Protection Technology, Universities of Shaanxi Province, Xi'an Polytechnic University, Xi'an, 710048, Shaanxi, China.

The impact of light radiation, a predominant energy release mechanism in nuclear explosions, on material properties is of critical importance. This investigation employed an artificial light source to replicate the effects of nuclear explosion radiation and utilized a physical information neural network (PINN) to examine the temperature evolution and corresponding changes in the mechanical properties of carbon fiber/epoxy composites (CFEC). A light source simulating nuclear explosion's light radiation was built to irradiate the CFEC, then measure the reflection spectrum and temperature of samples.

View Article and Find Full Text PDF

The ore mining sites commonly experience slope instability, which is causing concern for the workers' safety and the operation's stability. Considering the Ziluoyi iron ore mining site as a case study, uniaxial compression strength and shear tests are performed on the lower disk peripheral rock, ore body, and upper disk peripheral rock, leading to the extraction of compressive strength and elastic modulus (lower disk: 77.7 MPa-9.

View Article and Find Full Text PDF

Long-term erosion by acidic solutions in karst regions leads to continuous deterioration of the physical and mechanical properties at the interfaces of engineering structures, adversely affecting their operational performance. To investigate the degradation patterns of the mechanical properties and corrosion mechanisms of the concrete‒limestone composite (CLC) after exposure to acidic corrosion, three kinds of CLC samples treated with acidic solutions of different pH values were fabricated. Mechanical property analysis was conducted via triaxial compression testing methods.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!