In this work, large 3D Ti meshes fabricated by direct ink writing were wirelessly anodized for the first time to prepare highly photocatalytically active TiO nanotube (TNT) layers. The use of bipolar electrochemistry enabled the fabrication of TNT layers within the 3D Ti meshes without the establishment of an electrical contact between Ti meshes and the potentiostat, confirming its unique ability and advantage for the synthesis of anodic structures on metallic substrates with a complex geometry. TNT layers with nanotube diameters of up to 110 nm and thicknesses of up to 3.3 μm were formed. The TNT-layer-modified 3D Ti meshes showed a superior performance for the photocatalytic degradation of methylene blue in comparison to TiO-nanoparticle-decorated and nonanodized Ti meshes (with a thermal oxide layer), resulting in multiple increases in the dye degradation rate. The results presented here open new horizons for the employment of anodized 3D Ti meshes in various flow-through (photo)catalytic reactors.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1021/acs.nanolett.1c02815 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Ultrathin ALD Coatings of Zr and V Oxides on Anodic TiO Nanotube Layers: Comparison of the Osteoblast Cell Growth.
ACS Appl Mater Interfaces
January 2025
Central European Institute of Technology, Brno University of Technology, Purkynova 123, 612 00 Brno, Czech Republic.
The current study investigates and compares the biological effects of ultrathin conformal coatings of zirconium dioxide (ZrO) and vanadium pentoxide (VO) on osteoblastic MG-63 cells grown on TiO nanotube layers (TNTs). Coatings were achieved by the atomic layer deposition (ALD) technique. TNTs with average tube diameters of 15, 30, and 100 nm were fabricated on Ti substrates (via electrochemical anodization) and were used as primary substrates for the study.
View Article and Find Full Text PDFEnhancement of biocompatibility of anodic nanotube structures on biomedical Ti-6Al-4V alloy via ultrathin TiO coatings.
Front Bioeng Biotechnol
December 2024
Center of Materials and Nanotechnologies, Faculty of Chemical Technology, University of Pardubice, Pardubice, Czechia.
This work aims to describe the effect of the surface modification of TiO nanotube (TNT) layers on Ti-6Al-4V (TiAlV) alloy by ultrathin TiO coatings prepared via Atomic Layer Deposition (ALD) on the growth of MG-63 osteoblastic cells. The TNT layers with two distinctly different inner diameters, namely ∼15 nm and ∼50 nm, were prepared via anodic oxidation of the TiAlV alloy. Flat, i.
View Article and Find Full Text PDFDense-TNT: Efficient Vehicle Type Classification Neural Network Using Satellite Imagery.
Sensors (Basel)
November 2024
School of Electrical and Electronic Engineering, Nanyang Technological University, Singapore 639798, Singapore.
Accurate vehicle type classification plays a significant role in intelligent transportation systems. It is critical to understand the road conditions and usually contributive for the traffic light control system to respond correspondingly to alleviate traffic congestion. New technologies and comprehensive data sources, such as aerial photos and remote sensing data, provide richer and higher-dimensional information.
View Article and Find Full Text PDFEnzyme-free detection of creatinine as a kidney dysfunction biomarker using TiO flow-through membranes.
Nanoscale Adv
December 2024
Nanomaterials Research Group (NRG), Physics Division, PINSTECH Islamabad 44000 Pakistan
TiO nanotube flow-through membranes (TNTsM) were fabricated anodization of Ti foil and explored as a biosensing platform for creatinine detection. The electrodes were prepared in different configurations including TNT membrane with top surface up (TNTsMTU/TNPs/FTO), TNT membrane with bottom surface up (TNTsMBU/TNPs/FTO), TNT membrane with top surface up containing nanograss (TNTsMNG/TNPs/FTO), and TNTs/NPs/FTO and TiO nanoparticles (TNPs) film on fluorine doped tin oxide (TNPs/FTO). Electrochemical studies depict the higher electrochemical activity (sensitivity ∼19.
View Article and Find Full Text PDFAuCu bimetallic nanocluster-modified titania nanotubes for photoelectrochemical water splitting: composition-dependent atomic arrangement and activity.
Nanoscale
January 2025
Quantum Solid-State Physics, Department of Physics and Astronomy, KU Leuven, Belgium.
The photoelectrochemical (PEC) water splitting reaction of bimetallic AuCu ( = 1, 0.75, 0.5, 0.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!