AI Article Synopsis
Article Abstract
Poor visible light utilization and charge separation efficiency of TiO restrict its extensive application in the photocatalytic field. Herein, a specific Z-scheme TiO/Cu/ZnO heterojunction was successfully constructed by atomic layer deposition (ALD) technique and spray pyrolysis technology. Benefited from the surface plasmon resonance (SPR) effect of Cu and Z-scheme heterojunction, the visible light absorption capacity was greatly enhanced. Meanwhile, ZnO nanolayer coating, prepared by ALD technique, protects Cu element to hinder its oxidation, thus enhancing the separation efficiency of photogenerated carriers. Therefore, the photocatalytic hydrogen production performance was significant improved, exhibiting a maximum value of 342.0 µmol·g·h for the optimal B-T-0.1C-10Z (black TiO/0.1Cu/10 nm ZnO) sample without any noble-metal cocatalyst, which is higher than pure TiO (310.7 µmol·g·h, with 3 wt% Pt) synthesized by spray pyrolysis method under equal conditions. In addition, a possible mechanism for the enhanced performance was briefly discussed based on the experimental results.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1016/j.jcis.2021.09.023 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Defects Calculation and Accelerated Interfacial Charge Transfer in a Photoactive MOF-Based Heterojunction.
Small
January 2025
Institutes of Physical Science and Information Technology, Anhui Graphene Carbon Fiber Materials Research Center, Anhui University, Hefei, Anhui, 230601, P. R. China.
Photocatalytic hydrogen production is currently considered a clean and sustainable route to meet the energy and environmental issues. Among, heterojunction photocatalysts have been developed to improve their photocatalytic efficiency. Defect engineering of heterojunction photocatalysts is attractive due to it can perform as electron trap and change the band structure to optimize the interfacial separation rate of photogenerated electron-hole pairs.
View Article and Find Full Text PDFBeyond Tradition: A MOF-On-MOF Cascade Z-Scheme Heterostructure for Augmented CO Photoreduction.
Small
January 2025
Beijing Key Laboratory for Green Catalysis and Separation and Department of Chemical Engineering, College of Materials Science and Engineering, Beijing University of Technology, Beijing, 100124, P. R. China.
Metal-organic frameworks (MOFs) are rigorously investigated as promising candidates for CO capture and conversion. MOF-on-MOF heterostructures integrate bolstered charger carrier separation with the intrinsic advantages of MOF components, exhibiting immense potential to substantially escalate the efficiency of photocatalytic CO reduction (CORR). However, the structural and compositional complexity poses significant challenges to the controllable development of these heterostructures.
View Article and Find Full Text PDFThe theoretical investigation of the g-CN/ZnS heterojunction for photocatalytic applications.
Phys Chem Chem Phys
January 2025
Department of Chemistry, Faculty of Science, Ferdowsi University of Mashhad, Mashhad, Iran.
Graphitic carbon nitride (g-CN) is a useful photocatalyst applied in various areas. However, it has some disadvantages that limit its applications. Therefore, doping and the construction of a heterojunction are beneficial methods to overcome these drawbacks.
View Article and Find Full Text PDFCombination of Broad Light-Absorption CuS with S,C,N-TiO: Assessment of Photocatalytic Performance in Nitrogen Fixation Reaction.
Inorg Chem
January 2025
Research Laboratory of Advanced Water and Wastewater Treatment Processes, Department of Applied Chemistry, Faculty of Chemistry, University of Tabriz, Tabriz 51666-16471, Iran.
In the field of solar energy storage, photocatalytic ammonia production is a next-generation technology. The rapid recombination of charges and insignificant utilization of the sunlight spectrum are bottlenecks of effective photocatalytic N fixation. The introduction of impurities in the crystal lattice and the development of heterojunctions could effectively segregate carriers and improve the solar-light-harvesting capability, which can boost NH generation.
View Article and Find Full Text PDFSelf-powered dual-photoelectrode photoelectrochemical aptasensor amplified by hemin/G-quadruplex-based DNAzyme.
Mikrochim Acta
January 2025
Department of General Surgery, Qilu Hospital (Qingdao), Cheeloo College of Medicine, Shandong University, 758 Hefei Road, Qingdao, Shandong, 266035, P.R. China.
A self-powered dual-electrode aptasensor was developed for the detection of tumor marker carcinoembryonic antigen (CEA). The composite BiVO/ZnInS, which is capable of forming a Z-scheme heterojunction, was chosen as the photoanode, and the AuNP/CuBiO complex was chosen as the photocathode in photoelectrochemical (PEC) detection. The experiments showed that the constructed self-powered dual-electrode system had a good photoelectric response to white light, and the photocurrent signal of the photocathode was significantly enhanced under the influence of the photoanode.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!