The impact of bacterial cell aggregation on UV inactivation kinetics.

Water Res

Microbiology and Fermentation, Department of Food Science, Faculty of Science, University of Copenhagen, Rolighedsvej 26, DK-1958, Frederiksberg C, Denmark.

Published: October 2021

Reconditioning of food processing water streams for reuse is an increasingly common water management practice in the food industry and UV disinfection is often employed as part of the water treatment. Several factors may impact the effect of UV radiation. Here, we aim to assess the impact of cell aggregation on UV inactivation kinetics and investigate if UV exposure induces aggregation. Three strains, isolated from food processing water reuse lines (Raoultella ornithinolytica, Pseudomonas brenneri, Rothia mucilaginosa) and both an aggregating and a non-aggregating strain of Staphylococcus aureus were exposed to UVC light at 255 nm using UV LED equipment. Total Viable Count and phase-contrast microscopy, coupled with image analysis, were used to compare the UV inactivation kinetics with the average particle size for a range of UV doses. Tailing effect, seen as a strong reduction in inactivation rate, was observed for all strains at higher UV doses (industrial strains ≥ 50 or 120 mJ/cm, S. aureus strains  ≥ 40 or 60 mJ/cm). The naturally aggregating strains were more UV tolerant, both within and between species. When aggregates of S. aureus were broken, UV tolerance decreased. For the processing water isolates, the lowest applied UV dose (25 mJ/cm) significantly increased the average particle size. Application of higher UV doses obtained with longer exposure times did not further increase the particle size compared with untreated samples. For the S. aureus strains, however, no consistent change in average particle size was observed due to UV. Our results demonstrate that aggregating strains have a higher degree of protection and that UV radiation induces aggregation in some, but not all bacteria. A better understanding of the mechanisms governing microbial aggregation and survival during UV treatment could help to improve UV applications and predictions of microbial inactivation.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.watres.2021.117593DOI Listing

Publication Analysis

Top Keywords

particle size
16
inactivation kinetics
12
processing water
12
average particle
12
cell aggregation
8
aggregation inactivation
8
food processing
8
induces aggregation
8
strains higher
8
higher doses
8

Similar Publications

The application of high-pressure grinding rolls (HPGR) for ore crushing is considered to be one of the effective ways to save energy and reduce emissions in the ore processing industry. The crushing effect is directly determined by the forces of ore material during roll crushing. However, the mechanical state of ore material in roll crushing and the effect of roll structure, process parameters, feed particle size, on the force during the crushing of ore material needs to be expanded.

View Article and Find Full Text PDF

Periodontitis, a common chronic inflammatory condition caused by bacteria, leads to loss of attachment, resorption of alveolar bone, and ultimately tooth loss. Therefore, reducing bacterial load and fostering alveolar bone regeneration are essential components in the treatment of periodontitis. In this study, we prepared smaller-sized Ag-Metal Organic Frameworks (Ag@MOF) and loaded with sodium alginate (Alg) hydrogel for periodontitis treatment.

View Article and Find Full Text PDF

Extraction of cellulose nanocrystals from date seeds using transition metal complex-assisted hydrochloric acid hydrolysis.

Int J Biol Macromol

January 2025

Chemical and Petroleum Engineering Department, College of Engineering, United Arab Emirates University, PO Box 15551, Al Ain, United Arab Emirates. Electronic address:

In this study, the role of a transition metal complex in improving hydrolysis efficiency during nanocellulose production was analysed. Cellulose nanocrystals (CNCs) were extracted from date seeds by incorporating a copper metal complex during HCl hydrolysis. In contrast to traditional HCl hydrolysis at moderate conditions, which yielded only microcrystalline cellulose (MCC), this approach resulted in the extraction of CNCs with a 10 % improved yield compared to MCC.

View Article and Find Full Text PDF

Synthesis of BODIPYs using organoindium reagents and survey of their cytotoxicity and cell uptake on nervous system cells.

Bioorg Chem

December 2024

Universidade da Coruña, CICA - Centro Interdisciplinar de Química e Bioloxía and Departamento de Química, Facultad de Ciencias, Campus A Zapateira, 15071 A Coruña, Spain. Electronic address:

In this study, a series of BODIPY dyes were synthesized, containing various substituents at meso position. Further functionalization of the BODIPY framework at C2 and C2-C6 position(s) by palladium-catalysed cross-coupling reactions using organoindium reagents (RIn) was efficiently assessed, starting from C2(6)-halogenated BODIPYs, and their optical properties were measured. The cytotoxicity of BODIPY dyes on SH-SY5Y neuronal cells by MTT assay showed that those compounds bearing thien-2-yl and benzonitrile moieties at meso position, exhibited great efficiency in maintaining cell viability under all tested conditions (up to 50 µM for 24 h and 48 h).

View Article and Find Full Text PDF

An optimized microwave-assisted low methoxyl pectin extraction procedure was described. Six task specific deep eutectic solvents (TDES) were used in the extraction of pectin from bilimbi (LMABP) and pomelo peels (LMCGP). Response surface methodology-based optimization of the parameters like feed-to-solvent ratio, extraction time, and microwave power level results in 72.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!