Enzymatic purification of microplastics in soil.

MethodsX

School of Engineering and Built Environment, Griffith University, Nathan Campus, QLD 4111, Australia.

Published: January 2021

Accurate and effective analysis of microplastics depends on the purification of any biogenic matter present in the environmental sample. Within the soil environment, the presence of biogenic materials (living and non-living) obstruct reliable identification of microplastics. However, while conventional acidic, alkaline, and wet peroxidation methods are often used for microplastics purification, they can result in significant alteration to the polymer integrity. To overcome this issue of polymer damage, we have developed a more efficient protocol using enzymes to eliminate organic materials from soil media without affecting the synthetic polymers. This method describes a simple enzymatic protocol that eliminates the organic matter based on the application of enzymes that target the three natural components of lignocellulosic biomass (cellulose, hemicellulose, and lignin). The enzymatic protocol introduced in this study allows for the use of an oxidizing agent for the pre-treatment of samples and density separation step. Additionally, this method was used to determine the enzymatic digestion efficiencies of soil organic matter and recovery rates of microplastics. Finally, the recovered microplastics were characterized by techniques including stereomicroscopy, FT-IR, and SEM. This method proved to be effective in reducing approximately >90% of organic materials in soil samples. After showing a high digestion efficiency the method was applied to spiked microplastic soil samples where high recovery rates were established and plastic characteristics were conserved. Despite being a time consuming and expensive method when compared to other purification methods. The key benefits of this methodology are:•Minimal sample preparation•Representative purification of microplastic from diverse soil media; and•Most importantly, preservation of polymer integrity aiding requirements needed for particle identification (e.g.,% mass polymer remaining, SEM images revealing no obvious polymer morphology change after enzyme treatment).

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC8374289PMC
http://dx.doi.org/10.1016/j.mex.2021.101254DOI Listing

Publication Analysis

Top Keywords

polymer integrity
8
organic materials
8
materials soil
8
soil media
8
enzymatic protocol
8
organic matter
8
recovery rates
8
soil samples
8
soil
7
microplastics
6

Similar Publications

Background: Glia mediated neuroinflammation and degeneration of inhibitory GABAergic interneurons are some of the hall marks of pyrethroid neurotoxicity. Here we investigated the sex specific responses of inflammatory cytokines, microglia, astrocyte and parvalbumin positive inhibitory GABAergic interneurons to λ-cyhalothrin (LCT) exposures in rats.

Methods: Equal numbers of male and female rats were given oral corn oil, 2 mg/kg.

View Article and Find Full Text PDF

Bioinspired Antiswelling Hydrogel Sensors with High Strength and Rapid Self-Recovery for Underwater Information Transmission.

ACS Appl Mater Interfaces

January 2025

School of Chemistry and Chemical Engineering, State Key Laboratory of Metal Matrix Composites, Frontiers Science Center for Transformative Molecules, Shanghai Jiao Tong University, 800 Dongchuan Road, Shanghai 200240, China.

Hydrogel-based sensors typically demonstrate conspicuous swelling behavior in aqueous environments, which can severely compromise the mechanical integrity and distort sensing signals, thereby considerably constraining their widespread applicability. Drawing inspiration from the multilevel heterogeneous structures in biological tissues, an antiswelling hydrogel sensor endowed with high strength, rapid self-recovery, and low swelling ratio was fabricated through a water-induced phase separation and coordination cross-linking strategy. A dense heterogeneous architecture was developed by the integration of "rigid" quadridentate carboxyl-Zr coordination bonds and "soft" hydrophobic unit-rich regions featuring π-π stacking and cation-π interactions into the hydrogels.

View Article and Find Full Text PDF

The current demand for highly sensitive, optical sensors in biodiagnostics has prompted the development of ultrathin metal coatings on a range of substrates. Given the potential attenuation of the signal from a plasmonic sensor for the detection of fluorescent molecules when an adhesion layer between the substrate and coating is employed, this study examines the impact of various factors on the adhesion strength between gold coatings and substrates comprising glass and cyclo-olefin-polymer (COP). The objective is to identify potential configurations for high adhesion strength, thereby eliminating the need for an adhesion layer in the fabrication of optical sensors with gold coatings for diagnostic applications or to utilize a minimal adhesion layer thickness.

View Article and Find Full Text PDF

Unstable solid-electrolyte interphase (SEI) film resulting from chemically active surface state and huge volume fluctuation limits the development of Si-based anode materials in lithium-ion batteries. Herein, a photo-initiated polypyrrole (PPy) coating is manufactured on Si nanoparticles to guide the in situ generation of PPy-integrated hybrid SEI film (hSEI). The hSEI film shows excellent structure stability and optimized component composition for lithium storage.

View Article and Find Full Text PDF

Eco-Friendly Fabrication of FeS QD-Chitosan Biopolymer Composites: Green Synthetic Approach.

Biopolymers

March 2025

Department of Chemistry, School of Chemical and Physical Sciences, Lovely Professional University, Phagwara, India.

In this paper, we offer a unique green synthetic approach for producing iron sulfide quantum dots (FeS QD)-chitosan composites using gel chemistry. The technique uses the environmental features of chitosan, a biocompatible and biodegradable polysaccharide, and the excellent electrical properties of FeS QDs. By sustainable chemistry principles, the synthesis process is carried out under gentle settings, using aqueous solutions and avoiding hazardous solvents and strong chemicals.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!