Modeling and simulation of solar flat plate collector for energy recovery at varying regional coordinates.

Pakistan has remained an energy-deficient country, and most of the industrial sectors are closed due to the loading shedding of electricity. Even though Pakistan is located on the "solar belt" and receives over 2 MWh/m solar irradiation per year with 1500-3000 h of sunshine, unfortunately solar energy is not harnessed to fulfill the energy needs of the country. Solar flat plate collectors (SFPC) are widely employed for collecting solar radiations from the sun. Currently, worldwide solar thermal energy is widely used in household and commercial equipment for energy collection and utilization. The working fluid selected for this research work is water; numerical simulations were performed using Ansys FLUENT. On selected geographical coordinates, solar ray tracing model was employed to incorporate solar heat flux. Nawabshah (NWB), Hyderabad (HYB), Jacobabad (JCB), and Mirpurkhas (MPK) cities were selected for the measuring of performance of SPFC. Firstly, parallel to ground (at a 0° tilt angle) orientation of SFPC was performed. Furthermore, the performance of SFPC was measured using tilt angles of 15°, 30°, and 45°, respectively. The maximum exit water temperature in JCB at a tilt angle of 30° was 97.8 °C in March and a minimum of 88.09 °C in June. In HYD, at a tilt angle of 45°, the maximum temperature rise was recorded at 98.01 °C in November and the minimum was noticed at 76.37 °C in June. While in JCA, at an angle of 30°, the highest temperature was recorded at 97.83 °C in February and a minimum of 78.54 °C in June. The specific aim of this research study was to measure the performance of the SFPC at different tilt angles and at varying geographical coordinates through numerical simulations.