Total Temporomandibular Joint Replacement and Simultaneous Orthognathic Surgery Using Computer-Assisted Surgery.

Background: Disorders of the temporomandibular joint (TMJ) are frequent and are usually associated with other disorders of the facial skeleton. Surgery might be needed to correct TMJ anatomy and function and, in cases where pathologies coexist, a two-stage corrective surgery might be needed. However, the current fashion of single-stage procedures is feasible with the aid of new technologies such as computer-assisted surgery (CAS). This is a step forward toward performing complex procedures such as a TMJ replacement with simultaneous orthognathic surgery. CAS allows designing patient-fitted prosthesis and more predictable and accurate surgeries. Moreover, intraoperative development can be controlled in real time with intraoperative navigation, and postoperative results can be measured and compared afterwards.

Aims: The primary purpose of this article is to present the protocol used in our institution for orthognathic surgery associated with unilateral and bilateral TMJ replacement with patient-fitted prostheses guided with CAS.

Materials And Methods: We present two cases to illustrate our protocol and its results.

Results: In the first case, the difference in millimeters between planning and surgical outcomes was 1.72 mm for the glenoid component and 2.16 mm for the condylar prosthesis; for the second case, differences in the right side were 2.59 mm for the glenoid component and 2.06 mm for the ramus, and in the left side, due to the anatomy the difference was a little greater, without clinical significance.

Conclusion: Combined surgery of the midface and mandible with total TMJ replacement is feasible and beneficial for the patient. CAS facilitates the planning and design of custom-fit prosthesis and execution of these procedures.