AI Article Synopsis
Article Abstract
A novel metal-biochar (Biochar/AMDS) composite were fabricated by co-pyrolysis of spent coffee waste (SCW)/acid mine drainage sludge (AMDS), and their effective application in adsorptive removal of air pollutants such as formaldehyde in indoor environments was evaluated. The physicochemical characteristics of Biochar/AMDS were analyzed using SEM/EDS, XRF, XRD, BET, and FTIR. The characterization results illustrated that Biochar/AMDS had the highly porous structure, carbonaceous layers, and heterogeneous Fe phases (hematite, metallic Fe, and magnetite). The fixed-bed column test showed that the removal of formaldehyde by Biochar/AMDS was 18.4-fold higher than that by metal-free biochar (i.e., SCW-derived biochar). Changing the ratio of AMDS from 1:6 to 1:1 significantly increased the adsorption capacity for formaldehyde from 1008 to 1811 mg/g. In addition, thermal treatment of used adsorbent at 100 °C effectively restored the adsorptive function exhausted during the column test. These results provide new insights into the fabrication of practical, low-cost and ecofriendly sorbent for formaldehyde.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1016/j.jenvman.2021.113468 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Efficient Oxidative Removal of Indoor Formaldehyde Using Functionalized Activated Alumina.
ACS Appl Mater Interfaces
January 2025
School of Materials Science and Engineering, Shanghai Jiao Tong University, Shanghai 200240, China.
Formaldehyde (HCHO) has become a significant indoor air pollutant, arising from the widespread use of decorative and construction materials. Adsorption is the most convenient method for HCHO removal. However, the current adsorption is limited by the current low adsorption capacity and desorption.
View Article and Find Full Text PDFCryopreservation Method for Preventing Freeze-Fracture of Small Muscle Samples.
Bio Protoc
January 2025
Wellman Center for Photomedicine, Massachusetts General Hospital, Boston, MA, USA.
Histological techniques to study muscle are crucial for assessing skeletal muscle health. To preserve tissue morphology, samples are usually fixed in formaldehyde or cryopreserved immediately after excision from the body. Freezing samples in liquid nitrogen, using isopentane as a mediator for efficient cooling, preserves the tissue in its natural state.
View Article and Find Full Text PDFEnhancing visible light degradation of gaseous formaldehyde with CuO/OVs-TiO photocatalyst loaded wallpaper: Preparation, efficacy and mechanism.
Chemosphere
January 2025
Beijing Key Laboratory for Source Control Technology of Water Pollution, College of Environmental Science and Engineering, Beijing Forestry University, Beijing, 100083, China; Engineering Research Center for Water Pollution Source Control & Eco-remediation, College of Environmental Science and Engineering, Beijing Forestry University, Beijing, 100083, China. Electronic address:
Photocatalytic oxidation is considered to be a highly promising technology for indoor formaldehyde (HCHO) abatement. However, powdered photocatalysts encounter practical challenges due to their recycling difficulties and propensity for aggregation. In this study, we developed a CuO/OVs-TiO photocatalyst dispersion using various physical and chemical methods, which could be stabilized for an extended period.
View Article and Find Full Text PDFFormaldehyde-purifying air conditioner with integrated gas-phase photoelectrocatalytic system.
J Colloid Interface Sci
December 2024
School of Environmental Science and Engineering, Huazhong University of Science and Technology, Wuhan 430074, China. Electronic address:
Developing an efficient and economical indoor air purification system for catalytic decomposition of formaldehyde is of great significance. In this work, an indoor air conditioner capable of purifying formaldehyde was designed by directly integrating defective WO/TiO nanotube catalytic fin, with both thermal conductivity and gas-phase photoelectrocatalytic (GPEC) properties, onto the condenser component. The electrochemical treatment of the catalytic fin introduced a substantial number of oxygen vacancies, resulting in a significant increase in carrier concentration and mobility to the semi-metallic level.
View Article and Find Full Text PDFApproaches for the Inactivation of .
Appl Biosaf
December 2024
Department of Microbiology and Immunology; University of Louisville School of Medicine, Louisville, Kentucky, USA.
Introduction: is the gram-negative, facultative intracellular bacterium that causes the disease known as plague. Due to the risk for aerosol transmission, a low infectious dose, and the acute and lethal nature of pneumonic plague, research activities with require Biosafety Level 3 (BSL-3) facilities to provide the appropriate safeguards to minimize accidental exposures and environmental release. However, many experimental assays cannot be performed in BSL-3 due to equipment availability, and thus require removal of samples from the BSL-3 laboratory to be completed.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!